61 research outputs found
Evaluation of ion exchange capacity of acid activated, thermally treated Iranian Na-bentonite as a cheap alternative for ammonium removal in aquaculture farms of Iran and comparison with H-zeolite synthesis
Assisted reverse electrodialysis : principles, mechanisms, and potential
Although seawater reverse osmosis (RO) is nearing its thermodynamic minimum energy limit, it is still an energy-intensive process, requiring 2–3 kWh/m³ at a recovery of 50%. Pre-desalination of the seawater by reverse electrodialysis (RED), using an impaired water source, can further decrease this energy demand by producing energy and reducing the seawater concentration. However, RED is hampered by the initial high resistance of the fresh water source, resulting in a high required membrane area (i.e., high investment costs). In this paper, a new process is presented that can overcome this initial resistance and decrease the RED investment cost without the need for additional infrastructure: assisted RED (ARED). In ARED, a small potential difference is applied in the direction of the natural salinity gradient, increasing the ionic transport rate and rapidly decreasing the initial diluate resistance. This decreasing resistance is shown to outweigh any negative effects caused by, for example, concentration polarization, resulting in a process that is more efficient than theoretically expected. As this effect is mainly important at low diluate concentrations (up to 0.1 M), ARED is proposed as a first step in an economic and energy efficient (A)RED-RO hybrid process
Practical considerations for operability of an 8″ spiral wound forward osmosis module: Hydrodynamics, fouling behaviour and cleaning strategy
© 2016 Elsevier B.V. A better understanding of large spiral wound forward osmosis (SW FO) module operation is needed to provide practical insight for a full-scale FO practical implementation desalination plant. Therefore, this study investigated two different 8″ SW FO modules (i.e. cellulose tri acetate, CTA and thin film composite, TFC) in terms of hydrodynamics, operating pressure, water and solute fluxes, fouling behaviour and cleaning strategy. For both modules, a significantly lower flow rate was required in the draw channel than in the feed channel due to important pressure-drop in the draw channel and was a particularly critical operating challenge in the CTA module when permeate spacers are used. Under FO and pressure assisted osmosis (PAO, up to 2.5 bar) operations, the TFC module featured higher water flux and lower reverse salt flux than the CTA module. For both modules, fouling tests demonstrated that feed inlet pressure was more sensitive to foulant deposition than the flux, thus confirming that FO fouling deposition occurs in the feed channel rather than on the membrane surface. Osmotic backwash combined with physical cleaning used in this study confirmed to be effective and adapted to large-scale FO module operation
Reduction of specific energy demand of seawater RO by osmotic dilution/osmotic energy recovery: a realistic modelling approach
Effect of pH on the transport and adsorption of organic micropollutants in ion-exchange membranes in electrodialysis-based desalination
In energy-efficient electrodialysis desalination processes, salt ions are transported from seawater (high salinity) to wastewater (low salinity) through ion-exchange membranes. Besides salt ions, also organic micropollutants can be transported from wastewater (high in organics) to seawater (low in organics). The transport mechanisms of organic micropollutants through ion-exchange membranes are complex phenomena, and pH has a tremendous impact on them. Since pH variations in electrodialysis operation are common, it is of crucial importance to investigate its influence on these mechanisms. Therefore, a large pool of nineteen organic micropollutants of various physicochemical characteristics was selected and added to artificial wastewater, at environmentally relevant concentrations. Approximately twenty of these physicochemical properties were statistically analyzed to elucidate the dominant mechanisms affecting adsorption and transport of organic micropollutants as a function of pH. Additionally, the influence of different current densities on the transport of organic micropollutants at different pH conditions was studied. This pH effect has now been investigated for the very first time, leading to essential conclusions on the practical applicability of electrodialysis for seawater desalination. The presented findings advance our understanding of the type of interactions between organic micropollutants and ion-exchange membranes
Nanofiltration separation of polyvalent and monovalent anions in desalination brines
This work, as part of a global membrane process for the recovery of alkali and acids from reverse osmosis (RO) desalination brines, focuses on the nanofiltration (NF) separation of polyvalent and monovalent anions, more specifically sulfate and chloride. This pretreatment stage plays a key role in the whole recovery process. Working with model brines simulating the concentration of RO concentrates, 0.2–1.2 M chloride concentration and 0.1 M sulfate concentration, the experimental performance and modeling of the NF separation is reported. The study has been carried out with the NF270 (Dow Filmtec) membrane. The effect of operating pressure (500–2000 kPa), ionic strength (0.4–1.3 M) and chloride initial concentration (0.2–1.2 M) on the membrane separation capacity has been investigated. Finally, the Donnan Steric Pore Model (DSPM) together with experimentally determined parameters, effective pore radius (rp), thickness of the membrane effective layer (d) and effective membrane charge density (Xd), was proved accurate enough to satisfactorily describe the experimental results. In this work we provide for the first time the analysis of partitioning effects and transport mechanism in the NF separation of sulfate and chloride anions in concentrations that simulate those found in RO desalination brines.This work has been financially supported by projects CTQ2008-0690, ENE2010-15585 and CTM2011-23912 (co-financed by ERDF Funds).The authors would like to acknowledge SADYT, S.A. for providing assistance for this work
REMOVED: Predictive Modelling of Combined Influence of Colloidal and Organic Fouling on Rejection of Trace Organics in RO and FO/PRO
Solubilization of struvite as a sustainable nutrient source for single cell protein production
Effect of fouling on removal of trace organic compounds by nanofiltration
The fate of chemical of concern is not yet fully understood during treatment of impaired waters. The aim of this paper is to assess the impact of different organic-based fouling layers on the removal of a large range of trace organics. Both model and real water samples (mixed with trace organic contaminants at environmental concentration of 2 μg l−1) were used to simulate fouling in nanofiltration under controlled environment. The new and fouled membranes were systematically characterised for surface charge, hydrophobicity and roughness. It was observed that fouling generally reduced the membrane surface charge; however, the alterations of the membrane hydrophobicity and surface roughness were dependent on the foulants composition. The rejection of charged trace organics was observed to be improved due to the increased electrostatic repulsion by fouled membranes and the adsorption of the trace organic chemicals onto organic matters. On the other hand, the removal of nonionic compounds decreased when fouling occurred, due to the presence of cake enhanced concentration polarization. The fouling layer structure was found to play an important role in the rejection of the trace organic compounds
- …