An experimental study of plane mixing layer development

Mean flow and turbulence was measured in the near field of two plane mixing layers in air with a maximum velocity of 21 m/sec. The experimental rig enabled mixing layers of velocity ratios 0 and 0.46 to be generated simultaneously. Gases with both tripped and untripped initial boundary layers were studied. It was found that the two stream layer developed to the self preserving state in a distance much shorter than did the single stream layer which followed accepted criteria for the development distance. The asymptotic levels of the turbulence quantities in the two stream layer and the development of the single stream layer showed agreement with existing data. It is suggested that the two stream mixing layer should provide a better test case for the development of turbulence models and calculation methods than the single stream mixing layer

Measurements of the free stream fluctuations above a turbulent boundary layer

This paper investigates the velocity fluctuations in the free stream above an incompressible turbulent boundary layer developing at constant pressure. It is assumed that the fluctuations receive contributions from three statistically independent sources: (1) one-dimensional unsteadiness, (2) free stream turbulence, and (3) the potential motion induced by the turbulent boundary layer. Measurements were made in a wind tunnel with a root-mean-square level of the axial velocity fluctuations of about 0.2 percent. All three velocity components were measured using an X-wire probe. The unsteadiness was determined from the spanwise covariance of the axial velocity, measured using two single wire probes. The results show that it is possible to separate the contributions to the r.m.s. level of the velocity fluctuations, without resorting to the dubious technique of high-pass filtering. The separation could be extended to the spectral densities of the contributions, if measurements of sufficient accuracy were available. The Appendix provides a general guide for the measurement of small free stream fluctuation levels

Development of subminiature multi-sensor hot-wire probes

Limitations on the spatial resolution of multisensor hot wire probes have precluded accurate measurements of Reynolds stresses very near solid surfaces in wind tunnels and in many practical aerodynamic flows. The fabrication, calibration and qualification testing of very small single horizontal and X-array hot-wire probes which are intended to be used near solid boundaries in turbulent flows where length scales are particularly small, is described. Details of the sensor fabrication procedure are reported, along with information needed to successfully operate the probes. As compared with conventional probes, manufacture of the subminiature probes is more complex, requiring special equipment and careful handling. The subminiature probes tested were more fragile and shorter lived than conventional probes; they obeyed the same calibration laws but with slightly larger experimental uncertainty. In spite of these disadvantages, measurements of mean statistical quantities and spectra demonstrate the ability of the subminiature sensors to provide the measurements in the near wall region of turbulent boundary layers that are more accurate than conventional sized probes

Monodromy in the CMB: Gravity Waves and String Inflation

We present a simple mechanism for obtaining large-field inflation, and hence a gravitational wave signature, from string theory compactified on twisted tori. For Nil manifolds, we obtain a leading inflationary potential proportional to phi^(2/3) in terms of the canonically normalized field phi, yielding predictions for the tilt of the power spectrum and the tensor-to-scalar ratio, $n_s\approx 0.98$ and $r\approx 0.04$ with 60 e-foldings of inflation; we note also the possibility of a variant with a candidate inflaton potential proportional to phi^(2/5). The basic mechanism involved in extending the field range -- monodromy in D-branes as they move in circles on the manifold -- arises in a more general class of compactifications, though our methods for controlling the corrections to the slow-roll parameters require additional symmetries.Comment: 43 pages, latex. 4 figure

Improved Skin Friction Interferometer

An improved system for measuring aerodynamic skin friction which uses a dual-laser-beam oil-film interferometer was developed. Improvements in the optical hardware provided equal signal characteristics for each beam and reduced the cost and complexity of the system by replacing polarization rotation by a mirrored prism for separation of the two signals. An automated, objective, data-reduction procedure was implemented to eliminate tedious manual manipulation of the interferometry data records. The present system was intended for use in two-dimensional, incompressible flows over a smooth, level surface without pressure gradient, but the improvements discussed are not limited to this application

Double-branched vortex generator

In order to assess the suitability of using a double branched vortex generator in parametric studies involving vortex interactions, an experimental study of the main vortex and secondary flows produced by a double branched vortex generator was conducted in a 20-by-40 cm indraft wind tunnel. Measurements of the cross flow velocities were made with a five hole pressure probe from which vorticity contours and vortex parameters were derived. The results showed that the optimum configuration consisted of chord extensions with the absence of a centerbody

Interaction Between a Vortex and a Turbulent Boundary Layer. Part 1: Mean Flow Evolution and Turbulence Properties

An experimental study was conducted to examine the interaction between a single weak streamwise vortex and a two-dimensional turbulent boundary layer. Attention was focused on characterizing the effect of the boundary layer on the vortex, including the effects of a moderate adverse pressure gradient. Rapid growth of the vortex core was observed, and a flattening of the core shape occurred when the dimension of the core radius became comparable to the distance of the vortex center from the surface. Adverse pressure gradients caused an increase in the rate of core growth, and therefore, a stronger distortion of the core shape. Measurements of surface skin friction beneath the vortex and some of the Reynolds stresses are presented

Crossed hot-wire data acquisition and reduction system

The report describes a system for rapid computerized calibration acquisition, and processing of data from a crossed hot-wire anemometer is described. Advantages of the system are its speed, minimal use of analog electronics, and improved accuracy of the resulting data. Two components of mean velocity and turbulence statistics up to third order are provided by the data reduction. Details of the hardware, calibration procedures, response equations, software, and sample results from measurements in a turbulent plane mixing layer are presented

Novel duplex vapor electrochemical method for silicon solar cells

Progress in the development of low-cost solar arrays is reported. Topics covered include: (1) development of a simplified feed system for the Na used in the Na-SiF4 reactor; (2) production of high purity silicon through the reduction of sodium fluosilicate with sodium metal; (3) the leaching process for recovering silicon from the reaction products of the SiF4-Na reaction; and (4) silicon separation by the melting of the reaction product