Experimental study of positron production from a 2.55-mm-thick silicon crystal target using 8-GeV channeling electron beams with high-bunch charges

We have investigated quenching phenomena of channeling radiation through positron production from a silicon crystal hit by a single-bunch electron beam with high-bunch charge at the 8-GeV electron/positron injector linac. The crystal axis, left angle bracket1 1 0right-pointing angle bracket, was aligned to the electron beam with a precise goniometer, and positrons produced in the forward direction with a momentum of 20 MeV/c were detected with a magnetic spectrometer. Positron yields were measured by varying the charge in a bunch with a typical bunch length of not, vert, similar10 ps from 0.1 nC to 2 nC. The corresponding instantaneous current density ranged from 0.15 × 104 to 1.2 × 104 A/cm2. The results show that, at these current densities, the positron yield is proportional to the bunch charge within the experimental accuracy, which implies that no non-linear phenomena are observed in channeling radiation

Enhancement of the Positron Intensity by a Tungsten Single Crystal Target at the KEKB Injector Linac

International audienceA new tungsten single-crystalline positron target has been successfully employed for generation of the intense positron beam at the KEKB injector linac in September 2006. The target is composed of a tungsten single-crystal with a thickness of 10.5 mm. The positron production target is bombarded at an incident electron energy of 4 GeV, and the produced positrons are collected and accelerated up to the final injection energy of 3.5 GeV in the succeeding sections. A conventional tungsten plate with a thickness of 14 mm has been used previously, and the conversion efficiency (Ne^+/Ne^-), the ratio between the number of positrons (Ne^+) captured in the positron capture section and the number of the incident electrons (Ne^-), was 0.20 on average. By replacing the tungsten plate with the tungsten crystal, it increased to 0.25 on average. The increase of the conversion efficiency has boosted the positron intensity to its maximum since the beginning of KEKB operation in 1999. Now this new positron source is stably operating and is contributing to increasing the integrated luminosity of the KEKB B-factory

PERFORMANCE OF RF SYSTEM FOR COMPACT-ERL MAIN LINAC AT KEK

Abstract The construction of the compact Energy Recovery LINAC (cERL) in KEK was completed at the end of 2013, and the beam commissioning has begun. Solidstate amplifiers were employed as the RF power sources in the main LINAC (ML). Cavity field feedback and tuner feedback control were performed using the digital low-level RF (LLRF) system. Large microphonics was observed, but the effect was suppressed well by the digital LLRF system

PERFORMANCE OF RF SYSTEM FOR COMPACT-ERL MAIN LINAC AT KEK

Abstract The construction of the compact Energy Recovery LINAC (cERL) in KEK was completed at the end of 2013, and the beam commissioning has begun. Solid-state amplifiers were employed as the RF power sources in the main LINAC (ML). Cavity field feedback and tuner feedback control were performed using the digital lowlevel RF (LLRF) system. Large microphonics was observed, but the effect was suppressed well by the digital LLRF system

Measurement of inclusive D*+- and associated dijet cross sections in photoproduction at HERA

Inclusive photoproduction of D*+- mesons has been measured for photon-proton centre-of-mass energies in the range 130 < W < 280 GeV and a photon virtuality Q^2 < 1 GeV^2. The data sample used corresponds to an integrated luminosity of 37 pb^-1. Total and differential cross sections as functions of the D* transverse momentum and pseudorapidity are presented in restricted kinematical regions and the data are compared with next-to-leading order (NLO) perturbative QCD calculations using the "massive charm" and "massless charm" schemes. The measured cross sections are generally above the NLO calculations, in particular in the forward (proton) direction. The large data sample also allows the study of dijet production associated with charm. A significant resolved as well as a direct photon component contribute to the cross section. Leading order QCD Monte Carlo calculations indicate that the resolved contribution arises from a significant charm component in the photon. A massive charm NLO parton level calculation yields lower cross sections compared to the measured results in a kinematic region where the resolved photon contribution is significant.Comment: 32 pages including 6 figure

Measurement of Jet Shapes in Photoproduction at HERA

The shape of jets produced in quasi-real photon-proton collisions at centre-of-mass energies in the range $134-277$ GeV has been measured using the hadronic energy flow. The measurement was done with the ZEUS detector at HERA. Jets are identified using a cone algorithm in the $\eta - \phi$ plane with a cone radius of one unit. Measured jet shapes both in inclusive jet and dijet production with transverse energies $E^{jet}_T>14$ GeV are presented. The jet shape broadens as the jet pseudorapidity ($\eta^{jet}$) increases and narrows as $E^{jet}_T$ increases. In dijet photoproduction, the jet shapes have been measured separately for samples dominated by resolved and by direct processes. Leading-logarithm parton-shower Monte Carlo calculations of resolved and direct processes describe well the measured jet shapes except for the inclusive production of jets with high $\eta^{jet}$ and low $E^{jet}_T$. The observed broadening of the jet shape as $\eta^{jet}$ increases is consistent with the predicted increase in the fraction of final state gluon jets.Comment: 29 pages including 9 figure

Plastisol Foaming Process. Decomposition of the Foaming Agent, Polymer Behavior in the Corresponding Temperature Range and Resulting Foam Properties

The decomposition of azodicarbonamide, used as foaming agent in PVC - plasticizer (1/1) plastisols was studied by DSC. Nineteen different plasticizers, all belonging to the ester family, two being polymeric (polyadipates), were compared. The temperature of maximum decomposition rate (in anisothermal regime at 5 K min-1 scanning rate), ranges between 434 and 452 K. The heat of decomposition ranges between 8.7 and 12.5 J g -1. Some trends of variation of these parameters appear significant and are discussed in terms of solvent (matrix) and viscosity effects on the decomposition reactions. The shear modulus at 1 Hz frequency was determined at the temperature of maximum rate of foaming agent decomposition, and differs significantly from a sample to another. The foam density was determined at ambient temperature and the volume fraction of bubbles was used as criterion to judge the efficiency of the foaming process. The results reveal the existence of an optimal shear modulus of the order of 2 kPa that corresponds roughly to plasticizer molar masses of the order of 450 ± 50 g mol-1. Heavier plasticizers, especially polymeric ones are too difficult to deform. Lighter plasticizers such as diethyl phthalate (DEP) deform too easily and presumably facilitate bubble collapse

Observation of Scaling Violations in Scaled Momentum Distributions at HERA

Charged particle production has been measured in deep inelastic scattering (DIS) events over a large range of $x$ and $Q^2$ using the ZEUS detector. The evolution of the scaled momentum, $x_p$, with $Q^2,$ in the range 10 to 1280 $GeV^2$, has been investigated in the current fragmentation region of the Breit frame. The results show clear evidence, in a single experiment, for scaling violations in scaled momenta as a function of $Q^2$.Comment: 21 pages including 4 figures, to be published in Physics Letters B. Two references adde

Angular and Current-Target Correlations in Deep Inelastic Scattering at HERA

Correlations between charged particles in deep inelastic ep scattering have been studied in the Breit frame with the ZEUS detector at HERA using an integrated luminosity of 6.4 pb-1. Short-range correlations are analysed in terms of the angular separation between current-region particles within a cone centred around the virtual photon axis. Long-range correlations between the current and target regions have also been measured. The data support predictions for the scaling behaviour of the angular correlations at high Q2 and for anti-correlations between the current and target regions over a large range in Q2 and in the Bjorken scaling variable x. Analytic QCD calculations and Monte Carlo models correctly describe the trends of the data at high Q2, but show quantitative discrepancies. The data show differences between the correlations in deep inelastic scattering and e+e- annihilation.Comment: 26 pages including 10 figures (submitted to Eur. J. Phys. C