Using Magnetic Bearing Orbit Information to Maximize Centrifugal Compressor Efficiency at Off-Design Conditions

Active magnetic bearings used on oil-free centrifugal refrigeration compressors have lower stiffness than conventional oil-lubricated journal or rolling element bearings. The lower stiffness of these bearings makes them sensitive to internal flow instabilities that are precursors of rotating stall or compressor surge. At operating conditions far away from surge the internal flow is very stable and the magnetic bearings keep the shaft centered, resulting in a minimal bearing orbit. The internal flow instabilities that arise when the compressor approaches the surge limit result in some radially fluctuating forces on the shaft. The active magnetic bearings correct for these fluctuating radial forces on the shaft. The bearing orbit increases with the size of these radial forces. Optimum compressor efficiency occurs close to surge at incipient stall conditions when maximum internal flow pressure recovery occurs. The positional feedback system of the active magnetic bearing control loop system indicates the bearing orbit which relates to compressor efficiency. At high flow conditions capacity is controlled by compressor speed for the imposed pressure ratio. At low flow conditions a combination of variable speed and a means of range extension (e.g. inlet guide vanes, variable geometry diffuser, or flow recirculation) are required to control capacity at the imposed pressure ratio and guarantee stable compressor operation. The bearing orbit signal can be used to determine which speed/geometry combination gives the highest compressor efficiency. If the bearing orbit is below a minimum value the compressor runs too close to choke and a reduction in speed combined with an opening of the diffuser throat area would increase compressor efficiency. If, on the other hand, the bearing orbit is above a maximum value the compressor runs too close to surge and an increase in speed combined with a closing of the diffuser throat area is required to increase compressor efficiency and guarantee surge-free compressor. Experience with this control scheme will be illustrated for a newly developed 350 ton two-stage centrifugal compressor where the variable geometry hardware is replaced with a controlled internal flow recirculation

A Chiller Control Algorithm for Multiple Variable-speed Centrifugal Compressors

Capacity control of a chiller with multiple variable-speed centrifugal compressors running in parallel between a common evaporator and condenser under reduced load conditions can be achieved by speed variation and/or adjusting the number of compressors in operation. These different capacity control schemes result in modifications of chiller efficiency under part-load conditions. The decision in selecting the number of operational compressors matching the compressor rotational speed to reach a desired part-load capacity depends not only on the required partial load but also on the required pressure ratio at that part-load condition. To illustrate the control dilemma, the paper will start with an example that shows the need for a different control strategy for two different chiller pressure ratios at equal part-load capacity. This difference in partial load control can be planned by observing the topological variation of the efficiency islands on the variable-speed centrifugal compressor map. For a given refrigerant the efficiency of a compressor is a function of only two process variables: head (isentropic enthalpy rise) and volumetric flow rate on the compressor map. With that information a multiple compressor control algorithm has been developed that can estimate optimum chiller efficiency for any head/flow combination the chiller with multiple compressors might encounter. The improvement in chiller part-load efficiency using this algorithm can be substantial as will be illustrated in the paper for a two compressor chiller configuration

Science with the EXTraS Project: Exploring the X-ray Transient and variable Sky

The EXTraS project (Exploring the X-ray Transient and variable Sky) will characterise the temporal behaviour of the largest ever sample of objects in the soft X-ray range (0.1-12 keV) with a complex, systematic and consistent analysis of all data collected by the European Photon Imaging Camera (EPIC) instrument onboard the ESA XMM-Newton X-ray observatory since its launch. We will search for, and characterize variability (both periodic and aperiodic) in hundreds of thousands of sources spanning more than nine orders of magnitude in time scale and six orders of magnitude in flux. We will also search for fast transients, missed by standard image analysis. Our analysis will be completed by multiwavelength characterization of new discoveries and phenomenological classification of variable sources. All results and products will be made available to the community in a public archive, serving as a reference for a broad range of astrophysical investigations.Comment: 4 pages, 1 figure. Refereed Proceeding of "The Universe of Digital Sky Surveys" conference held at the INAF - Observatory of Capodimonte, Naples, on 25th-28th November 2014, to be published in the Astrophysics and Space Science Proceedings, edited by Longo, Napolitano, Marconi, Paolillo, Iodic

Suited for Success? : Suits, Status, and Hybrid Masculinity

This document is the Accepted Manuscript version. The final, definitive version of this paper has been published in Men and Masculinities, March 2017, doi: https://doi.org/10.1177/1097184X17696193, published by SAGE Publishing, All rights reserved.This article analyzes the sartorial biographies of four Canadian men to explore how the suit is understood and embodied in everyday life. Each of these men varied in their subject positions—body shape, ethnicity, age, and gender identity—which allowed us to look at the influence of men’s intersectional identities on their relationship with their suits. The men in our research all understood the suit according to its most common representation in popular culture: a symbol of hegemonic masculinity. While they wore the suit to embody hegemonic masculine configurations of practice—power, status, and rationality—most of these men were simultaneously marginalized by the gender hierarchy. We explain this disjuncture by using the concept of hybrid masculinity and illustrate that changes in the style of hegemonic masculinity leave its substance intact. Our findings expand thinking about hybrid masculinity by revealing the ways subordinated masculinities appropriate and reinforce hegemonic masculinity.Peer reviewe

Protocol for the Foot in Juvenile Idiopathic Arthritis trial (FiJIA): a randomised controlled trial of an integrated foot care programme for foot problems in JIA

<b>Background</b>: Foot and ankle problems are a common but relatively neglected manifestation of juvenile idiopathic arthritis. Studies of medical and non-medical interventions have shown that clinical outcome measures can be improved. However existing data has been drawn from small non-randomised clinical studies of single interventions that appear to under-represent the adult population suffering from juvenile idiopathic arthritis. To date, no evidence of combined therapies or integrated care for juvenile idiopathic arthritis patients with foot and ankle problems exists. <b>Methods/design</b>: An exploratory phase II non-pharmacological randomised controlled trial where patients including young children, adolescents and adults with juvenile idiopathic arthritis and associated foot/ankle problems will be randomised to receive integrated podiatric care via a new foot care programme, or to receive standard podiatry care. Sixty patients (30 in each arm) including children, adolescents and adults diagnosed with juvenile idiopathic arthritis who satisfy the inclusion and exclusion criteria will be recruited from 2 outpatient centres of paediatric and adult rheumatology respectively. Participants will be randomised by process of minimisation using the Minim software package. The primary outcome measure is the foot related impairment measured by the Juvenile Arthritis Disability Index questionnaire's impairment domain at 6 and 12 months, with secondary outcomes including disease activity score, foot deformity score, active/limited foot joint counts, spatio-temporal and plantar-pressure gait parameters, health related quality of life and semi-quantitative ultrasonography score for inflammatory foot lesions. The new foot care programme will comprise rapid assessment and investigation, targeted treatment, with detailed outcome assessment and follow-up at minimum intervals of 3 months. Data will be collected at baseline, 6 months and 12 months from baseline. Intention to treat data analysis will be conducted. A full health economic evaluation will be conducted alongside the trial and will evaluate the cost effectiveness of the intervention. This will consider the cost per improvement in Juvenile Arthritis Disability Index, and cost per quality adjusted life year gained. In addition, a discrete choice experiment will elicit willingness to pay values and a cost benefit analysis will also be undertaken

An exploration of parents’ preferences for foot care in juvenile idiopathic arthritis: a possible role for the discrete choice experiment

Background: An increased awareness of patients’ and parents’ care preferences regarding foot care is desirable from a clinical perspective as such information may be utilised to optimise care delivery. The aim of this study was to examine parents’ preferences for, and valuations of foot care and foot-related outcomes in juvenile idiopathic arthritis (JIA).<p></p> Methods: A discrete choice experiment (DCE) incorporating willingness-to-pay (WTP) questions was conducted by surveying 42 parents of children with JIA who were enrolled in a randomised-controlled trial of multidisciplinary foot care at a single UK paediatric rheumatology outpatients department. Attributes explored were: levels of pain; mobility; ability to perform activities of daily living (ADL); waiting time; referral route; and footwear. The DCE was administered at trial baseline. DCE data were analysed using a multinomial-logit-regression model to estimate preferences and relative importance of attributes of foot care. A stated-preference WTP question was presented to estimate parents’ monetary valuation of health and service improvements.<p></p> Results: Every attribute in the DCE was statistically significant (p < 0.01) except that of cost (p = 0.118), suggesting that all attributes, except cost, have an impact on parents’ preferences for foot care for their child. The magnitudes of the coefficients indicate that the strength of preference for each attribute was (in descending order): improved ability to perform ADL, reductions in foot pain, improved mobility, improved ability to wear desired footwear, multidisciplinary foot care route, and reduced waiting time. Parents’ estimated mean annual WTP for a multidisciplinary foot care service was £1,119.05.<p></p> Conclusions: In terms of foot care service provision for children with JIA, parents appear to prefer improvements in health outcomes over non-health outcomes and service process attributes. Cost was relatively less important than other attributes suggesting that it does not appear to impact on parents’ preferences.<p></p&gt

The Consumption, Production and Regulation of Alcohol in the UK: The Relevance of the Ambivalence of the Carnivalesque

Alcohol consumption in 21st-century Britain is of significant interest to government, media and academics. Some have referred to a ‘new culture of intoxication’ or ‘calculated hedonism’, fostered by the drinks industry, and enabled by a neoliberal policymaking context. This article argues that the ‘carnivalesque’ is a better concept through which to understand alcohol’s place in British society today. The concept of the carnivalesque conveys an earthy yet extraordinary culture of drinking, as well as ritual elements with a lack of comfort and security that characterise the night-time economy for many people. This night-time carnival, as well as being something experienced by participants, is also a spectacle, with gendered and classed dynamics. It is suggested that this concept is helpful in making sense of common understandings of alcohol that run through the spheres not only of alcohol consumption but also production and regulation

All the way from … authenticity and distance in world music production

World music and the narratives it produces are at the very centre of a formerly transnational production and consumption process. However, the shortened distance between the sites of production and consumption of this good, brought on by migration and greater participation, has created a dilemma for the UK-based artists who perform it: how to maintain authenticity without the added value of ‘distance’. Therefore, the aim of this article is to examine the ways in which musicians and other participants attempt to overcome this problem and in doing so (re)-construct particular aspects of their identity. Rather than being just another critique on authenticity, this article uses distance as an organizing concept in understanding the challenges facing world music production in the UK

Control of star formation by supersonic turbulence

Understanding the formation of stars in galaxies is central to much of modern astrophysics. For several decades it has been thought that stellar birth is primarily controlled by the interplay between gravity and magnetostatic support, modulated by ambipolar diffusion. Recently, however, both observational and numerical work has begun to suggest that support by supersonic turbulence rather than magnetic fields controls star formation. In this review we outline a new theory of star formation relying on the control by turbulence. We demonstrate that although supersonic turbulence can provide global support, it nevertheless produces density enhancements that allow local collapse. Inefficient, isolated star formation is a hallmark of turbulent support, while efficient, clustered star formation occurs in its absence. The consequences of this theory are then explored for both local star formation and galactic scale star formation. (ABSTRACT ABBREVIATED)Comment: Invited review for "Reviews of Modern Physics", 87 pages including 28 figures, in pres

A Multifunctional, Charge-Neutral, Chiral Octahedral M12 L12 Cage.

peer reviewedA chiral, octahedral M12 L12 cage, which is charge neutral and contains an internal void of about 2000 Å3 , is reported. The cage was synthesised as an enantiopure complex by virtue of amino-acid-based dicarboxylate ligands, which assemble around copper paddlewheels at the vertices of the octahedron. The cage persists in solution with retention of the fluorescence properties of the parent acid. The solid-state structure contains large pores both within and between the cages, and displays permanent porosity for the sorption of gases with retention of crystallinity. Initial tests show some enantioselectivity of the cage towards guests in solution