Effect of irrigation fluid temperature on body temperature during arthroscopic elbow surgery in dogs

This prospective randomised clinical trial evaluated the effect of warmed irrigation fluid on body temperature in anaesthetised dogs undergoing arthroscopic elbow surgery. Nineteen dogs undergoing elbow arthroscopy were included in the study and were randomly allocated to one of two groups. Group RT received irrigation fluid at room temperature (RT) while dogs in group W received warmed (W) irrigation fluid (36oC). A standardised patient management and anaesthetic protocol was used and body temperature was measured at four time points; (T1) pre-anaesthetic examination, (T2) arrival into theatre, (T3) end of surgery and (T4) arrival into recovery. There was no significant difference in body temperature at any time point between the groups. The mean overall decrease in body temperature between pre-anaesthetic examination (T1) and return to the recovery suite (T4) was significant in both groups, with a fall of 1.06±0.58oC (p<0.001) in group RT and 1.53±0.76oC (p<0.001) group W. There was no significant difference between the groups. At the end of surgery (T3) 4/19 (21.1%) of dogs were hypothermic (<37oC). The addition of warmed irrigation fluids to a temperature management protocol in dogs undergoing elbow arthroscopy during general anaesthesia did not lead to decreased temperature losses

Assessing liner performance using on-farm milk meters

The primary objective of this study was to quantify and compare the interactive effects of liner compression, milking vacuum level, and pulsation settings on average milk flow rates for liners representing the range of liner compression of commercial liners. A secondary objective was to evaluate a methodology for assessing liner performance that can be applied on commercial dairy farms. Eight different liner types were assessed using 9 different combinations of milking system vacuum and pulsation settings applied to a herd of 80 cows with vacuum and pulsation conditions changed daily for 36d using a central composite experimental design. Liner response surfaces were created for explanatory variables milking system vacuum (Vsystem) and pulsator ratio (PR) and response variable average milk flow rate (AMF=total yield/total cups-on time) expressed as a fraction of the within-cow average flow rate for all treatments (average milk flow rate fraction, AMFf). Response surfaces were also created for between-liner comparisons for standardized conditions of claw vacuum and milk ratio (fraction of pulsation cycle during which milk is flowing). The highest AMFf was observed at the highest levels of Vsystem, PR, and overpressure. All liners showed an increase in AMF as milking conditions were changed from low to high standardized conditions of claw vacuum and milk ratio. Differences in AMF between liners were smallest at the most gentle milking conditions (low Vsystem and low milk ratio), and these between-liner differences in AMF increased as liner overpressure increased. Differences were noted with vacuum drop between Vsystem and claw vacuum depending on the liner venting system, with short milk tube vented liners having the greater vacuum drop than mouthpiece chamber vented liners. The accuracy of liner performance assessment in commercial parlors fitted with milk meters can be improved by using a central composite experimental design with a repeated center point treatment, rotating different clusters to different stalls (milk meters), and adjusting performance estimates for similar claw vacuum and pulsation conditions

GTF2IRD1 regulates transcription by binding an evolutionarily conserved DNA motif ‘GUCE’

AbstractGTF2IRD1 is a member of a family of transcription factors whose defining characteristic is varying numbers of a helix–loop–helix like motif, the I-repeat. Here, we present functional analysis of human GTF2IRD1 in regulation of three genes (HOXC8, GOOSECOID and TROPONIN ISLOW). We define a regulatory motif (GUCE–GTF2IRD1 Upstream Control Element) common to all three genes. GUCE is bound in vitro by domain I-4 of GTF2IRD1 and mediates transcriptional regulation by GTF2IRD1 in vivo. Definition of this site will assist in identification of other downstream targets of GTF2IRD1 and elucidation of its role in the human developmental disorder Williams–Beuren syndrome

Baryon resonances from a novel fat-link fermion action

We present first results for masses of positive and negative parity excited baryons in lattice QCD using an O(a^2) improved gluon action and a Fat Link Irrelevant Clover (FLIC) fermion action in which only the irrelevant operators are constructed with fat links. The results are in agreement with earlier calculations of N^* resonances using improved actions and exhibit a clear mass splitting between the nucleon and its chiral partner, even for the Wilson fermion action. The results also indicate a splitting between the lowest J^P = 1/2^- states for the two standard nucleon interpolating fields.Comment: 5 pages, 3 figures, talk given by W.Melnitchouk at LHP 2001 workshop, Cairns, Australi

Novel fat-link fermion actions

The hadron mass spectrum is calculated in lattice QCD using a novel fat-link clover fermion action in which only the irrelevant operators of the fermion action are constructed using smeared links. The simulations are performed on a 16^3 X 32 lattice with a lattice spacing of a=0.125 fm. We compare actions with n=4 and 12 smearing sweeps with a smearing fraction of 0.7. The n=4 Fat Link Irrelevant Clover (FLIC) action provides scaling which is superior to mean-field improvement, and offers advantages over nonperturbative O(a) improvement.Comment: 5 pages, 2 figures, talk given by J.Zanotti at LHP 2001 workshop, Cairns, Australi

Effect of pulsation rest phase duration on teat end congestion

peer-reviewedThe objective of this study was to quantify the effect of d-phase (rest phase) duration of pulsation on the teat canal cross-sectional area during the period of peak milk flow from bovine teats. A secondary objective was to test if the effect of d-phase duration on teat canal cross-sectional area was influenced by milking system vacuum level, milking phase (b-phase) duration, and liner overpressure. During the d-phase of the pulsation cycle, liner compression facilitates venous flow and removal of fluids accumulated in teat-end tissues. It was hypothesized that a short-duration d-phase would result in congestion of teat-end tissue and a corresponding reduction in the cross-sectional area of the teat canal. A quarter milking device, designed and built at the Milking Research and Instruction Laboratory at the University of Wisconsin–Madison, was used to implement an experiment to test this hypothesis. Pulsator rate and ratios were adjusted to achieve 7 levels of d-phase duration: 50, 100, 150, 175, 200, 250, and 300ms. These 7 d-phase durations were applied during one milking session and were repeated for 2 vacuum levels (40 and 50kPa), 2 milking phase durations (575 and 775ms), and 2 levels of liner overpressure (9.8 and 18kPa). We observed a significant reduction in the estimated cross-sectional area of the teat canal with d-phase durations of 50 and 100ms when compared with d-phase durations of 150, 175, 225, 250, and 300ms. No significant difference was found in the estimated cross-sectional area of the teat canal for d-phase durations from 150 to 300ms. No significant interaction was observed between the effect of d-phase and b-phase durations, vacuum level, or liner overpressure

Assessing liner performance using on-farm milk meters

peer-reviewedThe primary objective of this study was to quantify and compare the interactive effects of liner compression, milking vacuum level, and pulsation settings on average milk flow rates for liners representing the range of liner compression of commercial liners. A secondary objective was to evaluate a methodology for assessing liner performance that can be applied on commercial dairy farms. Eight different liner types were assessed using 9 different combinations of milking system vacuum and pulsation settings applied to a herd of 80 cows with vacuum and pulsation conditions changed daily for 36d using a central composite experimental design. Liner response surfaces were created for explanatory variables milking system vacuum (Vsystem) and pulsator ratio (PR) and response variable average milk flow rate (AMF=total yield/total cups-on time) expressed as a fraction of the within-cow average flow rate for all treatments (average milk flow rate fraction, AMFf). Response surfaces were also created for between-liner comparisons for standardized conditions of claw vacuum and milk ratio (fraction of pulsation cycle during which milk is flowing). The highest AMFf was observed at the highest levels of Vsystem, PR, and overpressure. All liners showed an increase in AMF as milking conditions were changed from low to high standardized conditions of claw vacuum and milk ratio. Differences in AMF between liners were smallest at the most gentle milking conditions (low Vsystem and low milk ratio), and these between-liner differences in AMF increased as liner overpressure increased. Differences were noted with vacuum drop between Vsystem and claw vacuum depending on the liner venting system, with short milk tube vented liners having the greater vacuum drop than mouthpiece chamber vented liners. The accuracy of liner performance assessment in commercial parlors fitted with milk meters can be improved by using a central composite experimental design with a repeated center point treatment, rotating different clusters to different stalls (milk meters), and adjusting performance estimates for similar claw vacuum and pulsation conditions

A method for assessing teatcup liner performance during the peak milk flow period

peer-reviewedThe objective of this study was to develop a method to quantify the milking conditions under which circulatory impairment of teat tissues occurs during the peak flow period of milking. A secondary objective was to quantify the effect of the same milking conditions on milk flow rate during the peak flow rate period of milking. Additionally, the observed milk flow rate was a necessary input to the calculation of canal area, our quantitative measure of circulatory impairment. A central composite experimental design was used with 5 levels of each of 2 explanatory variables (system vacuum and pulsator ratio), creating 9 treatments including the center point. Ten liners, representing a wide range of liner compression (as indicated by overpressure), were assessed, with treatments applied using a novel quarter-milking device. Eight cows (32 cow-quarters) were used across 10 separate evening milkings, with quarter being the experimental unit. The 9 treatments, with the exception of a repeated center point, were randomly applied to all quarters within each individual milking. Analysis was confined to the peak milk flow period. Milk flow rate (MFR) and teat canal cross sectional area (CA) were normalized by dividing individual MFR, or CA, values by their within-quarter average value across all treatments. A multiple explanatory variable regression model was developed for normalized MFR and normalized CA. The methods presented in this paper provided sufficient precision to estimate the effects of vacuum (both at teat-end and in the liner mouthpiece), pulsation, and liner compression on CA, as an indicator of teat-end congestion, during the peak flow period of milking. Liner compression (as indicated by overpressure), teat-end vacuum, vacuum in the liner mouthpiece, milk-phase time, and their interactions are all important predictors of MFR and teat-end congestion during the peak milk flow period of milking. Increasing teat-end vacuum and milk-phase time increases MFR and reduces CA (indicative of increased teat-end congestion). Increasing vacuum in the liner mouthpiece also acts to reduce CA and MFR. Increasing liner compression reduces the effects of teat-end congestion, resulting in increased MFR and increased CA at high levels of teat-end vacuum and milk-phase time. These results provide a better understanding of the balance between milking speed and milking gentleness

Baffin Island Expedition, 1953: A Preliminary Field Report

Contains description and brief summaries of results of the second Baffin Island Expedition of the Arctic Institute of North America, May-Sept. 1953. The 13-man party carried out a program in the Penny Highland region of Cumberland Peninsula, centering on Pangnirtung Pass. Glaciological work on the Penny Icecap and Highway Glacier included studies of glacier physics, seismic work, and meteorological observations on bedrock geology and structure are given. Corrie formation and the geomorphology of Pangnirtung Pass were studied. Specimens of local fauna were collected and biological studies of some species were made. Comparisons of the vegetation of Penny Highland and East and North Greenland were made through extensive plant collections. Eight peaks were climbed and their altitudes determined. A list of 17 new names approved by the Canadian Board on Geographical Names is appended