13,006 research outputs found
Microhabitat preferences of Biomphalaria pfeifferi and Lymnaea natalensis in a natural and a man-made habitat in southeastern Tanzania.
Schistosoma mansoni is an important human parasitic disease which is widespread throughout Africa. As Biomphalaria pfeifferi snails act as intermediate host, knowledge of their population ecology is an essential prerequisite towards understanding disease transmission. We conducted a field study and assessed the density and microhabitat preferences of B.pfeifferi in a natural habitat which was a residual pool of a river. Repeated removal collecting revealed a density of 26.6 [95% confidence interval (CI): 24.9-28.3] snails/m2. B. pfeifferi showed microhabitat preferences for shallow water (depths: 0-4cm). They were found most abundantly close to the shoreline (distances: 0-40cm), and preferred either plant detritus or bedrock as substratum. Lymnaea natalensis, a snail which may act as a host for human Fasciola gigantica, also occurred in this habitat with a density of 34.0 (95% CI: 24.7-43.3) snails/m2, and preferred significantly different microhabitats when compared to B.pfeifferi. Microhabitat selection by these snail species was also investigated in a man-made habitat nearby, which consisted of a flat layer of concrete fixed on the riverbed, covered by algae. Here, B.pfeifferi showed no preference for locations close to the shoreline, probably because the habitat had a uniform depth. We conclude that repeated removal collecting in shallow habitats provides reliable estimates of snail densities and that habitat changes through constructions may create favourable microhabitats and contribute to additional disease transmission
Review of antiskid and brake dynamics research
The behavior of various antiskid systems was investigated under controlled conditions. Results from utilizing a single main wheel of a DC-9 aircraft suggest that the systems investigated perform well under most circumstances but there may be room for improvement. For example, it was demonstrated that pressure bias modulation can adversely affect the response of antiskid systems to rapid changes in the runway friction level. Results also indicate that antiskid systems designed to operate at a slip ratio of approximately 0.1 can provide a maximum braking effort without undue loss in the cornering capability of the tire. Time histories of braking friction coefficient were shown to provide a means of determining antiskid system performance and for systems that employed pressure bias modulation it was shown that performance could also be estimated from time histories of brake pressure and torque
Status of recent aircraft braking and cornering research
The sources of degraded performance which sometimes occurs under adverse runway conditions, are investigated to obtain data necessary to the development of more advanced systems, in an effort to insure safe ground handling operations under all-weather conditions. Tire-to-ground friction characteristics are determined under braking conditions which closely resemble those of airplanes under heavy braking. Braking data from single-wheel landing loads track tests are related with those available from full-scale flight tests
Behavior of aircraft antiskid breaking systems on dry and wet runway surfaces: A slip-ratio-controlled system with ground speed reference from unbraked nose wheel
An experimental investigation was conducted at the Langley aircraft landing loads and traction facility to study the braking and cornering response of a slip ratio controlled aircraft antiskid braking system with ground speed reference derived from an unbraked nose wheel. The investigation, conducted on dry and wet runway surfaces, utilized one main gear wheel, brake, and tire assembly of a DC-9 series 10 airplane. During maximum braking, the average ratio of the drag force friction coefficient developed by the antiskid system to the maximum drag force friction coefficient available was higher on the dry surface than on damp and flooded surfaces, and was reduced with lighter vertical loads, higher yaw angles, and when new tire treads were replaced by worn treads. Similarly, the average ratio of side force friction coefficient developed by the tire under antiskid control to the maximum side force friction coefficient available to a freely rolling yawed tire decreased with increasing yaw angle, generally increased with ground speed, and decreased when tires with new treads were replaced by those with worn treads
Technique for measuring side forces on a banked aircraft with a free-swiveling nose gear
An experimental investigation was conducted at the Langley Research Center to determine a method for towing an aircraft to measure the side forces of a free-swiveling nose gear due to variations in bank angle. A F-106 aircraft and the Space Shuttle orbiter OV-101 were towed to measure side forces on full-size aircraft for bank angles up to 3 deg. These tests indicate that substantial side forces will occur if an aircraft is rolling on a runway in a banked attitude even when the nose gear is free to swivel. Corotation of a twin-tire nose gear appears to cause a substantial increase in side force due to bank angle compared with a nose gear with indepdendently rotating wheels
Static and yawed-rolling mechanical properties of two type 7 aircraft tires
Selected mechanical properties of 18 x 5.5 and 49 x 17 size, type 7 aircraft tires were evaluated. The tires were subjected to pure vertical loads and to combined vertical and lateral loads under both static and rolling conditions. Parameters for the static tests consisted of tire load in the vertical and lateral directions, and parameters for the rolling tests included tire vertical load, yaw angle, and ground speed. Effects of each of these parameters on the measured tire characteristics are discussed and, where possible, compared with previous work. Results indicate that dynamic tire properties under investigation were generally insensitive to speed variations and therefore tend to support the conclusion that many tire dynamic characteristics can be obtained from static and low speed rolling tests. Furthermore, many of the tire mechanical properties are in good agreement with empirical predictions based on earlier research
Coronal Seismology and the Propagation of Acoustic Waves Along Coronal Loops
We use a combination of analytical theory, numerical simulation, and data
analysis to study the propagation of acoustic waves along coronal loops. We
show that the intensity perturbation of a wave depends on a number of factors,
including dissipation of the wave energy, pressure and temperature gradients in
the loop atmosphere, work action between the wave and a flow, and the
sensitivity properties of the observing instrument. In particular, the scale
length of the intensity perturbation varies directly with the dissipation scale
length (i.e., damping length) and the scale lengths of pressure, temperature,
and velocity. We simulate wave propagation in three different equilibrium loop
models and find that dissipation and pressure and temperature stratification
are the most important effects in the low corona where the waves are most
easily detected. Velocity effects are small, and cross-sectional area
variations play no direct role for lines-of-sight that are normal to the loop
axis. The intensity perturbation scale lengths in our simulations agree very
well with the scale lengths we measure in a sample of loops observed by TRACE.
The median observed value is 4.35x10^9 cm. In some cases the intensity
perturbation increases with height, which is likely an indication of a
temperature inversion in the loop (i.e., temperature that decreases with
height). Our most important conclusion is that thermal conduction, the primary
damping mechanism, is accurately described by classical transport theory. There
is no need to invoke anomalous processes to explain the observations.Comment: To appear in the Dec. 1, 2004 issue of the Astrophysical Journa
Behavior of aircraft antiskid braking systems on dry and wet runway surfaces. A slip-velocity-controlled, pressure-bias-modulated system
The braking and cornering response of a slip velocity controlled, pressure bias modulated aircraft antiskid braking system is investigated. The investigation, conducted on dry and wet runway surfaces, utilized one main gear wheel, brake, and tire assembly of a McDonnell Douglas DC 9 series 10 airplane. The landing gear strut was replaced by a dynamometer. The parameters, which were varied, included the carriage speed, tire loading, yaw angle, tire tread condition, brake system operating pressure, and runway wetness conditions. The effects of each of these parameters on the behavior of the skid control system is presented. Comparisons between data obtained with the skid control system and data obtained from single cycle braking tests without antiskid protection are examined
On the edge of a new frontier: Is gerontological social work in the UK ready to meet twenty-first-century challenges?
This article is available open access through the publisher’s website. Copyright @ 2013 The Authors.This article explores the readiness of gerontological social work in the UK for meeting the challenges of an ageing society by investigating the focus on work with older people in social work education and the scope of gerontological social work research. The discussion draws on findings from two exploratory studies: a survey of qualifying master's programmes in England and a survey of the content relating to older people over a six-year period in four leading UK social work journals. The evidence from master's programmes suggests widespread neglect of ageing in teaching content and practice learning. Social work journals present a more nuanced picture. Older people emerge within coverage of generic policy issues for adults, such as personalisation and safeguarding, and there is good evidence of the complexity of need in late life. However, there is little attention to effective social work interventions, with an increasingly diverse older population, or to the quality of gerontological social work education. The case is made for infusing content on older people throughout the social work curriculum, for extending practice learning opportunities in social work with older people and for increasing the volume and reporting of gerontological social work research.Brunel Institute for Ageing Studie
- …