10,939 research outputs found
Forced convection boiling near inception in zero-gravity
Forced-convection boiling at low heat flux and flow velocities in zero gravity for slightly subcooled distilled wate
Body rotation effects on melting ablation
Rotation effects on melting ablation on reentry of axisymmetric bodie
Burning of solids in oxygen-rich environments in normal and reduced gravity
An experimental program was conducted to investigate the combustion characteristics of solids burning in a weightless environment. The combustion characteristics of thin cellulose acetate material were obtained from specimens burned in supercritical as well as in low pressure oxygen atmospheres. Flame spread rates were measured and found to depend on material thickness and pressure in both normal gravity (1-g) and reduced gravity (0-g). A gravity effect on the burning process was also observed; the ratio of 1-g to 0-g flame spread rate becomes larger with increasing material thickness. Qualitative results on the combustion characteristics of metal screens (stainless steel, Inconel, copper, and aluminum) burning in supercritical oxygen and normal gravity are also presented. Stainless steel (300 sq mesh) was successfully ignited in reduced gravity; no apparent difference in the flame spread pattern was observed between 1-g and 0-g
Recommended from our members
Gravitational Instabilities In A Protoplanetary Disk Including The Effects Of Magnetic-Fields
We investigate the gravitational instability of a thin, Keplerian protoplanetary disk including the effects of a largely azimuthal magnetic field. The model follows that of our previous work (Noh, Vishniac, & Cochran 1991) except for the inclusion of a magnetic field. The disk is assumed to consist of neutral and ionized gas and neutral dust which are coupled by gravity and friction. The growth rates and eigenfunctions are calculated numerically using nonaxisymmetric linear perturbation methods. The results show that the growth rate has a maximum at some intermediate azimuthal number m, but for each value of m it is reduced relative to the unmagnetized case. The effects of the magnetic field appear more strongly on small scales. As the strength of the equilibrium magnetic field increases the growth rates decrease, and the maximum instability occurs at a lower value of m due to the increasing magnetic pressure. The response of each component to the magnetic field is discussed using the behavior of the eigenfunctions in the radial direction. With the inclusion of the magnetic field, the effects of the ionization fraction and friction on the growth rates also appear to be important for high m modes. Increasing the ionization fraction or the friction suppresses instability, but only slightly changes the maximally unstable azimuthal scales. The enhanced growth rates due to a dust component for which thermal pressure is negligible are somewhat reduced by the inclusion of a magnetic field. The effects of different boundary conditions (reflecting and transmitting) on the growth rates are also shown.NASA NAGW 2418Astronom
Forced-convection peak heat flux on cylindrical heaters in water and refrigerant 113
An investigation was conducted of the peak heat flux on cylindrical heaters in a fluid flowing perpendicular to the major axis of the heater. The test fluids were water and Refrigerant 113. Heaters of 0.049 to 0.181 cm diameter were tested over a fluid velocity range of 10.1 to 81.1 cm/sec. The experimental results were observed to fall within two regions based on the vapor removal geometry: jets or sheets. Mathematical models for each region successfully correlated the data for both fluids
Effects of gravity on laminar gas jet diffusion flames
Zero gravity effects on laminar gas jet diffusion flame
Effects of pressure, oxygen concentration, and forced convection on flame spread rate of Plexiglas, Nylon and Teflon
Experiments were conducted in which the burning of cylindrical materials in a flowing oxidant stream was studied. Plexiglas, Nylon, and Teflon fuel specimens were oriented such that the flames spread along the surface in a direction opposed to flowing gas. Correlations of flame spread rate were obtained that were power law relations in terms of pressure, oxygen concentration, and gas velocity
Failure mechanisms of graphene under tension
Recent experiments established pure graphene as the strongest material known
to mankind, further invigorating the question of how graphene fails. Using
density functional theory, we reveal the mechanisms of mechanical failure of
pure graphene under a generic state of tension. One failure mechanism is a
novel soft-mode phonon instability of the -mode, whereby the graphene
sheet undergoes a phase transition and is driven towards isolated benzene rings
resulting in a reduction of strength. The other is the usual elastic
instability corresponding to a maximum in the stress-strain curve. Our results
indicate that finite wave vector soft modes can be the key factor in limiting
the strength of monolayer materials
Simulation of spacecraft attitude dynamics using TREETOPS and model-specific computer Codes
The simulation of spacecraft attitude dynamics and control using the generic, multi-body code called TREETOPS and other codes written especially to simulate particular systems is discussed. Differences in the methods used to derive equations of motion--Kane's method for TREETOPS and the Lagrangian and Newton-Euler methods, respectively, for the other two codes--are considered. Simulation results from the TREETOPS code are compared with those from the other two codes for two example systems. One system is a chain of rigid bodies; the other consists of two rigid bodies attached to a flexible base body. Since the computer codes were developed independently, consistent results serve as a verification of the correctness of all the programs. Differences in the results are discussed. Results for the two-rigid-body, one-flexible-body system are useful also as information on multi-body, flexible, pointing payload dynamics
- …