156 research outputs found
A fast monolithic active pixel sensor with pixel level reset noise suppression and binary outputs for charged particle detection
In order to develop precision vertex detectors for the future linear collider, fast active monolithic active pixel sensors are studied. Standard CMOS 0.25 mum digital process is used to design a test chip which includes different pixel types, column-level discriminators and a digital control part. In-pixel amplification is implemented together with double sampling. Different charge-to-voltage conversion factors were obtained using amplifiers with different gains or diode sizes. Pixel architectures with DC and AC coupling to charge sensing element were proposed. As far, hits from conversion of 35Fe photons were registered for the DC-coupled pixel. Double sampling is functional and allows almost a complete cancellation if fixed pattern noise
Optimization of Tracking Performance of CMOS Monolithic Active Pixel Sensors
CMOS Monolithic Active Pixel Sensors (MAPS) provide an attractive solution for high precision tracking of minimum ionizing particles. In these devices, a thin, moderately doped, undepleted silicon layer is used as the active detector volume with the readout electronics implemented on top of it. Recently, a new MAPS prototype was fabricated using the AMS 0.35 m OPTO process, featuring a thick epitaxial layer. A systematic study of tracking performance of that prototype using high-energy particle beam is presented in this work. Noise performance, signal amplitude from minimum ionizing particles, detection efficiency, spurious hit suppression and spatial resolution are shown as a function of the readout pitch and the charge collecting diode size. A test array with a novel readout circuitry was also fabricated and tested. Each pixel circuit consists of a front-end voltage amplifier, capacitively coupled to the charge collecting diode, followed by two analog memory cells. This architecture implements an on-pixel correlated double sampling method, allowing for optimization of integration independently of full frame readout time and strongly reduces the pixel-to-pixel output signal dispersion. First measurements using this structure are also presented
A vertex detector for the International Linear Collider based on CMOS sensors
The physics programme at the International Linear Collider (ILC) calls for a vertex detector (VD) providing unprecedented flavour tagging performances, especially for c-quarks and τ leptons. This requirement makes a very granular, thin and multi-layer VD installed very close to the interaction region mandatory. Additional constraints, mainly on read-out speed and radiation tolerance, originate from the beam background, which governs the occupancy and the radiation level the detector should be able to cope with. CMOS sensors are being developed to fulfil these requirements. This report addresses the ILC requirements (highly related to beamstrahlung), the main advantages and features of CMOS sensors, the demonstrated performances and the specific aspects of a VD based on this technology. The status of the main R&D directions (radiation tolerance, thinning procedure and read-out speed) are also presented
Results from a prototype MAPS sensor telescope and readout system with zero suppression for the heavy flavor tracker at STAR
Beam energy dependent two-pion interferometry and the freeze-out eccentricity of pions in heavy ion collisions at STAR
We present results of analyses of two-pion interferometry in Au+Au collisions
at = 7.7, 11.5, 19.6, 27, 39, 62.4 and 200 GeV measured in the
STAR detector as part of the RHIC Beam Energy Scan program. The extracted
correlation lengths (HBT radii) are studied as a function of beam energy,
azimuthal angle relative to the reaction plane, centrality, and transverse mass
() of the particles. The azimuthal analysis allows extraction of the
eccentricity of the entire fireball at kinetic freeze-out. The energy
dependence of this observable is expected to be sensitive to changes in the
equation of state. A new global fit method is studied as an alternate method to
directly measure the parameters in the azimuthal analysis. The eccentricity
shows a monotonic decrease with beam energy that is qualitatively consistent
with the trend from all model predictions and quantitatively consistent with a
hadronic transport model.Comment: 27 pages; 27 figure
Charged-to-neutral correlation at forward rapidity in Au+Au collisions at =200 GeV
Event-by-event fluctuations of the ratio of inclusive charged to photon
multiplicities at forward rapidity in Au+Au collision at =200
GeV have been studied. Dominant contribution to such fluctuations is expected
to come from correlated production of charged and neutral pions. We search for
evidences of dynamical fluctuations of different physical origins. Observables
constructed out of moments of multiplicities are used as measures of
fluctuations. Mixed events and model calculations are used as baselines.
Results are compared to the dynamical net-charge fluctuations measured in the
same acceptance. A non-zero statistically significant signal of dynamical
fluctuations is observed in excess to the model prediction when charged
particles and photons are measured in the same acceptance. We find that, unlike
dynamical net-charge fluctuation, charge-neutral fluctuation is not dominated
by correlation due to particle decay. Results are compared to the expectations
based on the generic production mechanism of pions due to isospin symmetry, for
which no significant (<1%) deviation is observed.Comment: 14 pages, 6 figure
Azimuthal anisotropy in U+U and Au+Au collisions at RHIC
Collisions between prolate uranium nuclei are used to study how particle
production and azimuthal anisotropies depend on initial geometry in heavy-ion
collisions. We report the two- and four-particle cumulants, and
, for charged hadrons from U+U collisions at =
193 GeV and Au+Au collisions at = 200 GeV. Nearly fully
overlapping collisions are selected based on the amount of energy deposited by
spectators in the STAR Zero Degree Calorimeters (ZDCs). Within this sample, the
observed dependence of on multiplicity demonstrates that ZDC
information combined with multiplicity can preferentially select different
overlap configurations in U+U collisions. An initial-state model with gluon
saturation describes the slope of as a function of multiplicity in
central collisions better than one based on Glauber with a two-component
multiplicity model.Comment: Final paper version accepted for publication in Phys. Rev. Lett. New
version includes comparisons to a constituent quark glauber mode
Observation of charge asymmetry dependence of pion elliptic flow and the possible chiral magnetic wave in heavy-ion collisions
We present measurements of and elliptic flow, , at
midrapidity in Au+Au collisions at 200, 62.4, 39, 27,
19.6, 11.5 and 7.7 GeV, as a function of event-by-event charge asymmetry,
, based on data from the STAR experiment at RHIC. We find that
() elliptic flow linearly increases (decreases) with charge asymmetry
for most centrality bins at and higher.
At , the slope of the difference of
between and as a function of exhibits a
centrality dependence, which is qualitatively similar to calculations that
incorporate a chiral magnetic wave effect. Similar centrality dependence is
also observed at lower energies.Comment: 6 pages, 4 figure
- …