2,379 research outputs found

    Sub-kHz lasing of a CaF_2 Whispering Gallery Mode Resonator Stabilized Fiber Ring Laser

    Full text link
    We utilize a high quality calcium fluoride whispering-gallery-mode resonator to stabilize a simple erbium doped fiber ring laser with an emission frequency of 196 THz (wavelenght 1530 nm) to a linewidth below 650 Hz. This corresponds to a relative stability of 3.3 x 10^(-12) over 16 \mus. In order to characterize the linewidth we use two identical self-built lasers and a commercial laser to determine the individual lasing linewidth via the three-cornered hat method.Comment: 4 pages, 3 figure

    A comparative investigation of the efficacy of CO2 and high power diode lasers for the forming of EN3 mild steel sheets

    Get PDF
    A comparative investigation of the effectiveness of a high power diode laser (HPDL) and a CO2 laser for the forming of thin section EN3 mild steel sheet has been conducted. The buckling mechanism was identified as the laser forming mechanism responsible for the induced bending. For both lasers it was found that the induced bending angles increased with an increasing number of irradiations and high laser powers, whilst decreasing as the traverse speed was increased. Also, it was apparent from the experimental results that the laser bending angle was only linearly proportional to the number of irradiations when the latter was small due to local material thickening along the bend edge with a high number of irradiations. Owing to the mild steel’s greater beam absorption at the HPDL wavelength, larger bending angles were induced when using the HPDL. However, under certain conditions the performance of the CO2 laser in terms of induced bending angle was seen to approach that of the HPDL. Nevertheless, similar results between the two lasers were only achieved with increasing irradiations, thus it was concluded that the efficacy of the HPDL was higher than that of the CO2 laser insofar as it was more efficient. From graphical results and the employment of an analytical procedure, the laser line energy range in which accurate control of the HPDL bending of the mild steel sheets could be exercised efficiently was found to be 53 J mm-1 < P/v < 78 J mm-1, whilst for the CO2 laser the range was 61 J mm-1 < P/v < 85 J mm-1

    Neutrino spin oscillations in gravitational fields

    Full text link
    We study neutrino spin oscillations in black hole backgrounds. In the case of a charged black hole, the maximum frequency of oscillations is a monotonically increasing function of the charge. For a rotating black hole, the maximum frequency decreases with increasing the angular momentum. In both cases, the frequency of spin oscillations decreases as the distance from the black hole grows. As a phenomenological application of our results, we study simple bipolar neutrino system which is an interesting example of collective neutrino oscillations. We show that the precession frequency of the flavor pendulum as a function of the neutrino number density will be higher for a charged/non-rotating black hole compared with a neutral/rotating black hole respectively.Comment: Replaced with the version accepted for publication in Gravitation and Cosmology, Springer. 10 pages. 4 figure

    From in situ to ex vivo: the effect of autolysis and fixation on quantitative MRI markers for myelin

    Get PDF
    Ex vivo histology remains the gold standard against which MRI biophysical models, e.g. the MR g-ratio which characterises the fraction of a fibre’s diameter that is myelinated, are evaluated. The MR g-ratio model requires a measure of myelin density, for which magnetization transfer saturation (MT) has been used as a biomarker. However, changes occurring post mortem, e.g. autolysis, temperature changes and fixation, significantly alter the MRI signal. Here we investigate how these changes impact MT. We found that MT decreased post mortem but greatlyincreased upon fixation. These effects are similar to reported changes of other established MRI myelin-markers

    Dielectronic Recombination of Fe XV forming Fe XIV: Laboratory Measurements and Theoretical Calculations

    Get PDF
    We have measured resonance strengths and energies for dielectronic recombination (DR) of Mg-like Fe XV forming Al-like Fe XIV via N=3 -> N' = 3 core excitations in the electron-ion collision energy range 0-45 eV. All measurements were carried out using the heavy-ion Test Storage Ring at the Max Planck Institute for Nuclear Physics in Heidelberg, Germany. We have also carried out new multiconfiguration Breit-Pauli (MCBP) calculations using the AUTOSTRUCTURE code. For electron-ion collision energies < 25 eV we find poor agreement between our experimental and theoretical resonance energies and strengths. From 25 to 42 eV we find good agreement between the two for resonance energies. But in this energy range the theoretical resonance strengths are ~ 31% larger than the experimental results. This is larger than our estimated total experimental uncertainty in this energy range of +/- 26% (at a 90% confidence level). Above 42 eV the difference in the shape between the calculated and measured 3s3p(^1P_1)nl DR series limit we attribute partly to the nl dependence of the detection probabilities of high Rydberg states in the experiment. We have used our measurements, supplemented by our AUTOSTRUCTURE calculations, to produce a Maxwellian-averaged 3 -> 3 DR rate coefficient for Fe XV forming Fe XIV. The resulting rate coefficient is estimated to be accurate to better than +/- 29% (at a 90% confidence level) for k_BT_e > 1 eV. At temperatures of k_BT_e ~ 2.5-15 eV, where Fe XV is predicted to form in photoionized plasmas, significant discrepancies are found between our experimentally-derived rate coefficient and previously published theoretical results. Our new MCBP plasma rate coefficient is 19-28% smaller than our experimental results over this temperature range

    Establishment of a validation and benchmark database for the assessment of ship operation in adverse conditions

    Get PDF
    The Energy Efficiency Design Index (EEDI), introduced by the IMO [1] is applicable for various types of new-built ships since January 2013. Despite the release of an interim guideline [2], concerns regarding the sufficiency of propulsion power and steering devices to maintain manoeuvrability of ships in adverse conditions were raised. This was the motivation for the EU research project SHOPERA (Energy Efficient Safe SHip OPERAtion, 2013-2016 [3-6]). The aim of the project is the development of suitable methods, tools and guidelines to effectively address these concerns and to enable safe and green shipping. Within the framework of SHOPERA, a comprehensive test program consisting of more than 1,300 different model tests for three ship hulls of different geometry and hydrodynamic characteristics has been conducted by four of the leading European maritime experimental research institutes: MARINTEK, CEHIPAR, Flanders Hydraulics Research and Technische Universität Berlin. The hull types encompass two public domain designs, namely the KVLCC2 tanker (KRISO VLCC, developed by KRISO) and the DTC container ship (Duisburg Test Case, developed by Universität Duisburg-Essen) as well as a RoPax ferry design, which is a proprietary hull design of a member of the SHOPERA consortium. The tests have been distributed among the four research institutes to benefit from the unique possibilities of each facility and to gain added value by establishing data sets for the same hull model and test type at different under keel clearances (ukc). This publication presents the scope of the SHOPERA model test program for the two public domain hull models – the KVLCC2 and the DTC. The main particulars and loading conditions for the two vessels as well as the experimental setup is provided to support the interpretation of the examples of experimental data that are discussed. The focus lies on added resistance at moderate speed and drift force tests in high and steep regular head, following and oblique waves. These climates have been selected to check the applicability of numerical models in adverse wave conditions and to cover possible non-linear effects. The obtained test results with the KVLCC2 model in deep water at CEHIPAR are discussed and compared against the results obtained in shallow water at Flanders Hydraulics Research. The DTC model has been tested at MARINTEK in deep water and at Technische Universität Berlin and Flanders Hydraulics Research in intermediate/shallow water in different set-ups. Added resistance and drift force measurements from these facilities are discussed and compared. Examples of experimental data is also presented for manoeuvring in waves. At MARINTEK, turning circle and zig-zag tests have been performed with the DTC in regular waves. Parameters of variation are the initial heading, the wave period and height

    The Effects of Twitter Sentiment on Stock Price Returns

    Get PDF
    Social media are increasingly reflecting and influencing behavior of other complex systems. In this paper we investigate the relations between a well-know micro-blogging platform Twitter and financial markets. In particular, we consider, in a period of 15 months, the Twitter volume and sentiment about the 30 stock companies that form the Dow Jones Industrial Average (DJIA) index. We find a relatively low Pearson correlation and Granger causality between the corresponding time series over the entire time period. However, we find a significant dependence between the Twitter sentiment and abnormal returns during the peaks of Twitter volume. This is valid not only for the expected Twitter volume peaks (e.g., quarterly announcements), but also for peaks corresponding to less obvious events. We formalize the procedure by adapting the well-known "event study" from economics and finance to the analysis of Twitter data. The procedure allows to automatically identify events as Twitter volume peaks, to compute the prevailing sentiment (positive or negative) expressed in tweets at these peaks, and finally to apply the "event study" methodology to relate them to stock returns. We show that sentiment polarity of Twitter peaks implies the direction of cumulative abnormal returns. The amount of cumulative abnormal returns is relatively low (about 1-2%), but the dependence is statistically significant for several days after the events

    Altered resting-state functional connectivity in patients with chronic bilateral vestibular failure

    Get PDF
    AbstractPatients with bilateral vestibular failure (BVF) suffer from gait unsteadiness, oscillopsia and impaired spatial orientation. Brain imaging studies applying caloric irrigation to patients with BVF have shown altered neural activity of cortical visual–vestibular interaction: decreased bilateral neural activity in the posterior insula and parietal operculum and decreased deactivations in the visual cortex. It is unknown how this affects functional connectivity in the resting brain and how changes in connectivity are related to vestibular impairment.We applied a novel data driven approach based on graph theory to investigate altered whole-brain resting-state functional connectivity in BVF patients (n= 22) compared to age- and gender-matched healthy controls (n= 25) using resting-state fMRI. Changes in functional connectivity were related to subjective (vestibular scores) and objective functional parameters of vestibular impairment, specifically, the adaptive changes during active (self-guided) and passive (investigator driven) head impulse test (HIT) which reflects the integrity of the vestibulo-ocular reflex (VOR).BVF patients showed lower bilateral connectivity in the posterior insula and parietal operculum but higher connectivity in the posterior cerebellum compared to controls. Seed-based analysis revealed stronger connectivity from the right posterior insula to the precuneus, anterior insula, anterior cingulate cortex and the middle frontal gyrus. Excitingly, functional connectivity in the supramarginal gyrus (SMG) of the inferior parietal lobe and posterior cerebellum correlated with the increase of VOR gain during active as compared to passive HIT, i.e., the larger the adaptive VOR changes the larger was the increase in regional functional connectivity.Using whole brain resting-state connectivity analysis in BVF patients we show that enduring bilateral deficient or missing vestibular input leads to changes in resting-state connectivity of the brain. These changes in the resting brain are robust and task-independent as they were found in the absence of sensory stimulation and without a region-related a priori hypothesis. Therefore they may indicate a fundamental disease-related change in the resting brain. They may account for the patients' persistent deficits in visuo-spatial attention, spatial orientation and unsteadiness. The relation of increasing connectivity in the inferior parietal lobe, specifically SMG, to improvement of VOR during active head movements reflects cortical plasticity in BVF and may play a clinical role in vestibular rehabilitation

    Quadrupole Susceptibility and Elastic Softening due to a Vacancy in Silicon Crystal

    Full text link
    We investigate the electronic states around a single vacancy in silicon crystal by using the Green's function approach. The triply degenerate vacancy states within the band gap are found to be extended over a large distance 20A˚\sim20 {\rm \AA} from the vacancy site and contribute to the reciprocal temperature dependence of the quadrupole susceptibility resulting in the elastic softening at low temperture. The Curie constant of the quadrupole susceptibility for the trigonal mode (Oyz,Ozx,OxyO_{yz},O_{zx},O_{xy}) is largely enhanced as compared to that for the tetragonal mode (O20,O22O_{2}^{0},O_{2}^{2}). The obtained results are consistent with the recent ultrasonic experiments in silicon crystal down to 20 mK. We also calculate the dipole and octupole susceptibilities and find that the octupole susceptibilities are extremely enhannced for a specific mode.Comment: 6 pages, with 5 figure
    corecore