106 research outputs found
Bridging the gap of storage ring light sources and linac-driven free-electron lasers
High-gain free-electron lasers (FELs) are driven by short, high-charge density electron beams as only produced at dedicated single pass or recirculating linear accelerators. We describe new conceptual, technical, and modeling solutions to produce subpicosecond, up to 100 \u3bcJ energy extreme ultra-violet and soft x-ray FEL pulses at high- and tunable repetition rates, from diffraction-limited storage ring light source. In contrast to previously proposed schemes, we show that lasing can be simultaneous to the standard multibunch radiation emission from short insertion devices, and that it can be obtained with limited impact on the storage ring infrastructure. By virtue of the high-average power but moderate pulse energy, the storage ring-driven high-gain FEL would open the door to unprecedented accuracy in time-resolved spectroscopic analysis of matter in the linear response regime, in addition to inelastic scattering experiments
Suppression of microbunching instability with magnetic bunch length compression in a linac-based free electron laser
impact of non gaussian electron energy heating upon the performance of a seeded free electron laser
E. Ferrari, E. Allaria, W. Fawley, L. Giannessi, Z. Huang, G. Penco, and S. Spampinati Elettra-Sincrotrone Trieste S.C.p.A. di interesse nazionale, Strada Statale 14-km 163,5 in AREA Science Park, 34149 Basovizza, Trieste, Italy Universita degli Studi di Trieste, Dipartimento di Fisica, Piazzale Europa 1, 34127 Trieste, Italy SLAC National Accelerator Laboratory, Menlo Park, California 94025, USA Enea, via Enrico Fermi 45, 00044 Frascati, Roma, Italy Laboratory of Quantum Optics, University of Nova Gorica, 5000 Nova Gorica, Slovenia Department of Physics, University of Liverpool, Oxford Street L69 7ZE, Liverpool, United Kingdom Cockcroft Institute, Sci-Tech Daresbury, Keckwick Lane WA4 4AD, Daresbury, Warrington, United Kingdom (Received 11 October 2013; published 21 March 2014
Two-colour generation in a chirped seeded Free-Electron Laser
We present the experimental demonstration of a method for generating two
spectrally and temporally separated pulses by an externally seeded, single-pass
free-electron laser operating in the extreme-ultraviolet spectral range. Our
results, collected on the FERMI@Elettra facility and confirmed by numerical
simulations, demonstrate the possibility of controlling both the spectral and
temporal features of the generated pulses. A free-electron laser operated in
this mode becomes a suitable light source for jitter-free, two-colour
pump-probe experiments
Developments in CLARA accelerator design and simulations
We present recent developments in the accelerator design of CLARA (Compact Linear Accelerator for Research and Applications), the proposed UK FEL test facility at Daresbury Laboratory. Updates on the electron beam simulations and code comparisons including wakefields are described. Simulations of the effects of geometric wakefields in the small-aperture FEL undulator are shown, as well as further simulations on potential FEL experiments using chirped beams. We also present the results of simulations on post-FEL diagnostics
Experimental evidence of intrabeam scattering in a free-electron laser driver
Abstract
The effect of multiple small-angle Coulomb scattering, or intrabeam scattering (IBS) is routinely observed in electron storage rings over the typical damping time scale of milliseconds. So far, IBS has not been observed in single pass electron accelerators because charge density orders of magnitude higher than in storage rings would be needed. We show that such density is now available at high brightness electron linacs for free-electron lasers (FELs). We report measurements of the beam energy spread in the FERMI linac in the presence of the microbunching instability, which are consistent with a revisited IBS model for single pass systems. We also show that neglecting the hereby demonstrated effect of IBS in the parameter range typical of seeded VUV and soft x-ray FELs, results in too conservative a facility design, or failure to realise the accessible potential performance. As an example, an optimization of the FERMI parameters driven by an experimentally benchmarked model, opens the door to the extension of stable single spectral line emission to the water window (2.3–4.4 nm), with far-reaching implications for experiments in a variety of disciplines, ranging from physics and chemistry to biology and material sciences, and including nonlinear x-ray optics based on the four-wave-mixing approach.</jats:p
The FEL SASE operation, bunch compression and the beam heater
We discuss the conditions required for an optimal SASE FEL operation when
bunch compression techniques are exploited to enhance the bunch peak current.
We discuss the case of velocity bunching and magnetic bunch compression. With
the reference to the latter technique we provide a quantitative estimate of the
amount of laser heater power necessary to suppress the micro-bunching
instability without creating any problem to the SASE dynamic
Recommended from our members
Design and Commissioning Plan for a Laser Heater for FERMI@elettra
The purpose of a laser heater is to increase the electron beam uncorrelated energy spread as a way to control and ideally suppress the microbunching instability in the linac drive for x-rays FELs. We review the motivations for equipping FERMI with a laser heater and provide a specification for the basics parameters as well as a description of a practical layout including desired diagnostics provisions for both the electron and laser beams. We also outline some useful operational guidelines for commissioning
Microbunching instability characterization via temporally modulated laser pulses
High-brightness electron bunches, such as those generated and accelerated in free-electron lasers (FELs), can develop small-scale structure in the longitudinal phase space. This causes variations in the slice energy spread and current profile of the bunch which then undergo amplification, in an effect known as the microbunching instability. By imposing energy spread modulations on the bunch in the low-energy section of an accelerator, using an undulator and a modulated laser pulse in the center of a dispersive chicane, it is possible to manipulate the bunch longitudinal phase space. This allows for the control and study of the instability in unprecedented detail. We report measurements and analysis of such modulated electron bunches in the 2D spectrotemporal domain at the Fermi FEL, for three different bunch compression schemes. We also perform corresponding simulations of these experiments and show that the codes are indeed able to reproduce the measurements across a wide spectral range. This detailed experimental verification of the ability of codes to capture the essential beam dynamics of the microbunching instability will benefit the design and performance of future FELs
Single-shot transverse coherence in seeded and unseeded free-electron lasers: A comparison
The advent of x-ray free-electron lasers (FELs) drastically enhanced the capabilities of several analytical techniques, for which the degree of transverse (spatial) coherence of the source is essential. FELs can be operated in self-amplified spontaneous emission (SASE) or seeded configurations, which rely on a qualitatively different initialization of the amplification process leading to light emission. The degree of transverse coherence of SASE and seeded FELs has been characterized in the past, both experimentally and theoretically. However, a direct experimental comparison between the two regimes in similar operating conditions is missing, as well as an accurate study of the sensitivity of transverse coherence to key working parameters. In this paper, we carry out such a comparison, focusing in particular on the evolution of coherence during the light amplification process
- …