Influence of nanotube length and density on the plasmonic terahertz response of single-walled carbon nanotubes

We measure the conductivity spectra of thin films comprising bundled single-walled carbon nanotubes (CNTs) of different average lengths in the frequency range 0.3-1000 THz and temperature interval 10-530 K. The observed temperature-induced changes in the terahertz conductivity spectra are shown to depend strongly on the average CNT length, with a conductivity around 1 THz that increases/decreases as the temperature increases for short/long tubes. This behaviour originates from the temperature dependence of the electron scattering rate, which we obtain from Drude fits of the measured conductivity in the range 0.3-2 THz for 10 $\mu$m length CNTs. This increasing scattering rate with temperature results in a subsequent broadening of the observed THz conductivity peak at higher temperatures and a shift to lower frequencies for increasing CNT length. Finally, we show that the change in conductivity with temperature depends not only on tube length, but also varies with tube density. We record the effective conductivities of composite films comprising mixtures of WS$_2$ nanotubes and CNTs vs CNT density for frequencies in the range 0.3-1 THz, finding that the conductivity increases/decreases for low/high density films as the temperature increases. This effect arises due to the density dependence of the effective length of conducting pathways in the composite films, which again leads to a shift and temperature dependent broadening of the THz conductivity peak.Comment: Submitted to Journal of Physics D. Main manuscript: 9 pages, 8 figures. Supplementary material: 5 pages, 6 figure

Modeling the electrical properties of three-dimensional printed meshes with the theory of resistor lattices

The electrical properties of conducting meshes are investigated numerically by solving the related Kirchhoff equations with the Lanczos algorithm. The method is directly inspired by the recursion technique widely used to study the electronic and vibrational spectra of solids. The method is demonstrated to be very efficient and fast when applied to resistor networks. It is used to calculate equivalent resistances between arbitrary pairs of nodes in simple resistive lattices. When the resistance fluctuates statistically from bond to bond, the method makes it possible to evaluate the fluctuations of the electrical properties of the network. It is also employed to assign an effective bulk resistivity to a discrete conducting three-dimensional mesh

Effect of chemical potential on Dyakonov-Tamm waves guided by a graphene-coated structurally chiral medium (vol 21, 055002, 2019)

We numerically investigated the effect of chemical potential on Dyakonov--Tamm waves (DTWs) guided by a graphene-coated structurally chiral medium in the terahertz and the visible spectral regimes. Only one DTW can propagate in a specific direction in wide angular sectors, but multiple DTWs can propagate in a specific direction in narrow angular sectors, in both spectral regimes. Although the phase speed of a DTW depends weakly on the chemical potential in both spectral regimes, the propagation distance can be strongly dependent on the chemical potential in the terahertz regime but not in the visible regime. This difference can be attributed to the real part of the surface conductivity of graphene, which varies significantly with the chemical potential in the terahertz regime but not in the visible regime

How effectively do carbon nanotube inclusions contribute to the electromagnetic performance of a composite material? Estimation criteria from microwave and terahertz measurements

Screening effect in finite-length carbon nanotubes (CNT) and their agglomerates hinders significantly the electromagnetic interaction in composite materials. Screening effect is strong in the microwave range, and it decreases with increasing frequency resulting in a strong frequency dependence of the effective conductivity of the composite. Since screening effect is rather small in the terahertz range, the effective conductivity in this range is determined directly by the intrinsic conductivity of the inclusions. The ratio of the microwave to terahertz effective conductivities was proposed as a parameter to estimate how effectively carbon nanotube inclusions contribute to the electromagnetic performance of composite materials in the microwave range. CNT film was considered as a material where maximal possible interaction of the CNTs with EM field occurs. Single-walled CNT films and CNT-based composite materials, as well as hybrid film comprising mixtures of WS2 nanotubes and CNTs were fabricated and measured in the microwave and terahertz ranges. The electromagnetic field interaction with the inclusions has been estimated for all the samples fabricated

Sign inversion in the terahertz photoconductivity of single-walled carbon nanotube films

| openaire: EC/H2020/696656/EU//GrapheneCore1  | openaire: EC/H2020/644076/EU//CoExAN | openaire: EC/H2020/734164/EU//Graphene 3DIn recent years, there have been conflicting reports regarding the ultrafast photoconductive response of films of single walled carbon nanotubes (CNTs), which apparently exhibit photoconductivities that can differ even in sign. Here, we observe explicitly that the THz photoconductivity of CNT films is a highly variable quantity which correlates with the length of the CNTs, while the chirality distribution has little influence. Moreover, by comparing the photoinduced change in THz conductivity with heat-induced changes, we show that both occur primarily due to heat-generated modification of the Drude electron relaxation rate, resulting in a broadening of the plasmonic resonance present in finite-length metallic and doped semiconducting CNTs. This clarifies the nature of the photoresponse of CNT films and demonstrates the need to carefully consider the geometry of the CNTs, specifically the length, when considering them for application in optoelectronic devices.Peer reviewe

Carbon nanotube sponges as tunable materials for electromagnetic applications

The microwave conductivity and permittivity of both single-walled and multi-walled carbon nanotube (SWCNT and MWCNT) sponges were measured while compressing the samples. Compression leads to a huge variation of the absorptance, reflectance, and transmittance of the samples. The dependence of the microwave conductivity on the sponge density follows a power-law relation with exponents 1.7 ± 0.1 and 2.0 ± 0.2 for MWCNT and SWCNT sponges, respectively. These exponents can be decreased slightly by the addition of a non-conducting component which partly electrically separates adjacent tubes within the samples. The conductivity of MWCNT sponge was measured in the terahertz range while heating in air from 300 to 513 K and it increased due to an increase of a number of conducting channels in MWCNTs

Carbon nanotube sponges as tunable materials for electromagnetic applications

The microwave conductivity and permittivity of both single-walled and multi-walled carbon nanotube (SWCNT and MWCNT) sponges were measured while compressing the samples. Compression leads to a huge variation of the absorptance, reflectance, and transmittance of the samples. The dependence of the microwave conductivity on the sponge density follows a power-law relation with exponents 1.7 ± 0.1 and 2.0 ± 0.2 for MWCNT and SWCNT sponges, respectively. These exponents can be decreased slightly by the addition of a non-conducting component which partly electrically separates adjacent tubes within the samples. The conductivity of MWCNT sponge was measured in the terahertz range while heating in air from 300 to 513 K and it increased due to an increase of a number of conducting channels in MWCNTs

Localized plasmon resonance in boron-doped multiwalled carbon nanotubes

Substitutionally boron-doped multiwalled carbon nanotubes (B-CNTs) with lengths mainly less than 0.5 μ m and diameters 10–30 nm have been obtained by arc-discharge evaporation of the graphite anode containing boron material. The broad peak has been observed in the midinfrared conductivity spectra of the thin film comprising B-CNTs. The peak was suggested to be associated with a phenomenon known as localized plasmon resonance. Theoretical analysis has been done to confirm the possibility of this phenomenon to occur in the B-CNTs

Study of nanometric thin pyrolytic carbon films for explosive electron emission cathode in high-voltage planar diode

We report on an experimental study of explosive electron emission properties of cathode made by nanometric thin pyrolytic carbon (PyC) films (2–150 nm) deposited on Cu substrate via methane-based chemical vapor deposition. High current density at level of 300 A/cm2 in 5 · 10− 5 Pa vacuum has been observed together with very stable explosive emission from the planar cathode. The Raman spectroscopy investigation proves that the PyC films remain the same after seven shots. According to the optical image analysis of the cathode before and after one and seven shots, we conclude that the most unusual and interesting feature of using the PyC films/Cu cathode for explosive emission is that the PyC layer on the top of the copper target prevents its evaporation and oxidation, which leads to higher emission stability compared to conventional graphitic/Cu cathodes, and therefore results in longer working life