Behavior of Biaxially Loaded Slab-Column Connections with Shear Studs

Results are presented from four non-prestressed concrete slabcolumn connection subassemblies tested under simulated gravity and earthquake-type loading. Each specimen consisted of a largescale first-story interior slab-column connection reinforced with headed shear studs, loaded to a gravity-shear ratio of 50%, and subjected to biaxial lateral displacements. The slabs, which were nominally identical aside from the shear stud reinforcement design, had a flexural reinforcement ratio in the column strip, based on the effective depth, of 0.7%. Shear stud reinforcement in the test specimens varied in terms of amount and spacing, both between and within stud peripheral lines. All four specimens exhibited drift capacities significantly lower than shown by previous studies. Although the lateral strength of the specimens was governed by the flexural capacity of the slab, severe concrete degradation ultimately limited the drift capacity of the connections. Signs of punching-related damage were first observed during the cycle to 1.85% drift in each loading direction. Test results suggest that the minimum amount of shear reinforcement required in Section 21.13.6 of ACI 318-11 when neither a drift nor a combined shear-stress check is performed (vs ≥ 3.5√fc′, psi [0.29√fc′, MPa]) is adequate for connections subjected to a gravity shear ratio of up to 50% and resultant drifts from biaxial displacements of up to 2.0% if studs are spaced at less than 2d within the first two peripheral lines. For larger drift demands, a maximum stud spacing within the first three peripheral lines of 1.5d is recommended.Network for Earthquake Engineering Simulation (NEES) Program (Grant No. 0936519

Modeling and Monitoring the Long-Term Behavior of Post-Tensioned Concrete Bridges

The time-dependent and temperature-dependent behavior of post-tensioned concrete bridges were investigated through a case study of the St. Anthony Falls Bridge, consisting of laboratory testing of concrete time-dependent behaviors (i.e., creep and shrinkage), examination of data from the in situ instrumented bridge, and time-dependent finite element models. Laboratory results for creep and shrinkage were measured for 3.5 years after casting, and the data were best predicted by the 1978 CEB/FIP Model Code provisions. To compare the in situ readings to constant-temperature finite element models, the time-dependent behavior was extracted from the measurements using linear regression. The creep and shrinkage rates of the in situ bridge were found to depend on temperature. An adjusted age using the Arrhenius equation was used to account for the interactions between temperature and time-dependent behavior in the measured data. Results from the time-dependent finite element models incorporating the full construction sequence revealed that the 1990 CEB/FIP Model Code and ACI-209 models best predicted the in situ behavior. Finite element analysis also revealed that problems associated with excessive deflections or development of tension over the lifetime of the bridge would be unlikely. The interactions between temperature and time-dependent behavior were further investigated using a simplified finite element model, which indicated that vertical deflections and stresses can be affected by the cyclic application of thermal gradients. The findings from this study were used to develop an anomaly detection routine for the linear potentiometer data, which was successfully used to identify short-term and long-term artificial anomalies in the data

Diazoxide-responsive hyperinsulinemic hypoglycemia caused by HNF4A gene mutations

Objective: The phenotype associated with heterozygous HNF4A gene mutations has recently been extended to include diazoxide responsive neonatal hypoglycemia in addition to maturity-onset diabetes of the young (MODY). To date, mutation screening has been limited to patients with a family history consistent with MODY. In this study, we investigated the prevalence of HNF4A mutations in a large cohort of patients with diazoxide responsive hyperinsulinemic hypoglycemia (HH). Subjects and methods: We sequenced the ABCC8, KCNJ11, GCK, GLUD1, and/or HNF4A genes in 220 patients with HH responsive to diazoxide. The order of genetic testing was dependent upon the clinical phenotype. Results: A genetic diagnosis was possible for 59/220 (27%) patients. KATP channel mutations were most common (15%) followed by GLUD1 mutations causing hyperinsulinism with hyperammonemia (5.9%), and HNF4A mutations (5%). Seven of the 11 probands with a heterozygous HNF4A mutation did not have a parent affected with diabetes, and four de novo mutations were confirmed. These patients were diagnosed with HI within the first week of life (median age 1 day), and they had increased birth weight (median +2.4 SDS). The duration of diazoxide treatment ranged from 3 months to ongoing at 8 years. Conclusions: In this large series, HNF4A mutations are the third most common cause of diazoxide responsive HH. We recommend that HNF4A sequencing is considered in all patients with diazoxide responsive HH diagnosed in the first week of life irrespective of a family history of diabetes, once KATP channel mutations have been excluded

Podoconiosis and soil-transmitted helminths (STHs): double burden of neglected tropical diseases in Wolaita zone, rural southern Ethiopia

Background Both podoconiosis and soil-transmitted helminth (STH) infections occur among barefoot people in areas of extreme poverty; however, their co-morbidity has not previously been investigated. We explored the overlap of STH infection and podoconiosis in Southern Ethiopia and quantified their separate and combined effects on prevalent anemia and hemoglobin levels in podoconiosis patients and health controls from the same area. Methods and Principal Findings A two-part comparative cross-sectional study was conducted in Wolaita zone, southern Ethiopia. Data were collected from adult patients presenting with clinically confirmed podoconiosis, and unmatched adult neighborhood controls living in the same administrative area. Information on demographic and selected lifestyle factors was collected using interviewer-administered questionnaires. Stool samples were collected and examined qualitatively using the modified formalin-ether sedimentation method. Hemoglobin level was determined using two different methods: hemoglobinometer and automated hematology analyzer. A total of 913 study subjects (677 podoconiosis patients and 236 controls) participated. The prevalence of any STH infection was 47.6% among patients and 33.1% among controls (p<0.001). The prevalence of both hookworm and Trichuris trichiura infections was significantly higher in podoconiosis patients than in controls (AOR 1.74, 95% CI 1.25 to2.42, AOR 6.53, 95% CI 2.34 to 18.22, respectively). Not wearing shoes and being a farmer remained significant independent predictors of infection with any STH. There was a significant interaction between STH infection and podoconiosis on reduction of hemoglobin level (interaction p value = 0.002). Conclusions Prevalence of any STH and hookworm infection was higher among podoconiosis patients than among controls. A significant reduction in hemoglobin level was observed among podoconiosis patients co-infected with hookworm and ‘non-hookworm STH’. Promotion of consistent shoe-wearing practices may have double advantages in controlling both podoconiosis and hookworm infection in the study area

Estimating uncertainty of alcohol-attributable fractions for infectious and chronic diseases

Background: Alcohol is a major risk factor for burden of disease and injuries globally. This paper presents a systematic method to compute the 95% confidence intervals of alcohol-attributable fractions (AAFs) with exposure and risk relations stemming from different sources.Methods: The computation was based on previous work done on modelling drinking prevalence using the gamma distribution and the inherent properties of this distribution. The Monte Carlo approach was applied to derive the variance for each AAF by generating random sets of all the parameters. A large number of random samples were thus created for each AAF to estimate variances. The derivation of the distributions of the different parameters is presented as well as sensitivity analyses which give an estimation of the number of samples required to determine the variance with predetermined precision, and to determine which parameter had the most impact on the variance of the AAFs.Results: The analysis of the five Asian regions showed that 150 000 samples gave a sufficiently accurate estimation of the 95% confidence intervals for each disease. The relative risk functions accounted for most of the variance in the majority of cases.Conclusions: Within reasonable computation time, the method yielded very accurate values for variances of AAFs

Secondary somatic mutations restoring RAD51C and RAD51D associated with acquired resistance to the PARP inhibitor rucaparib in high-grade ovarian carcinoma

High-grade epithelial ovarian carcinomas (OC) containing mutated BRCA1 or BRCA2 (BRCA1/2) homologous recombination (HR) genes are sensitive to platinum-based chemotherapy and poly(ADP-ribose) polymerase inhibitors (PARPi), while restoration of HR function due to secondary mutations in BRCA1/2 has been recognized as an important resistance mechanism. We sequenced core HR pathway genes in 12 pairs of pre-treatment and post-progression tumor biopsy samples collected from patients in ARIEL2 Part 1, a phase 2 study of the PARPi rucaparib as treatment for platinum-sensitive, relapsed OC. In six of 12 pre-treatment biopsies, a truncation mutation in BRCA1, RAD51C or RAD51D was identified. In five of six paired post-progression biopsies, one or more secondary mutations restored the open reading frame. Four distinct secondary mutations and spatial heterogeneity were observed for RAD51C. In vitro complementation assays and a patient-derived xenograft (PDX), as well as predictive molecular modeling, confirmed that resistance to rucaparib was associated with secondary mutations

The relationship between different dimensions of alcohol use and the burden of disease-an update.

Alcohol use is a major contributor to injuries, mortality and the burden of disease. This review updates knowledge on risk relations between dimensions of alcohol use and health outcomes to be used in global and national Comparative Risk Assessments (CRAs). Systematic review of reviews and meta-analyses on alcohol consumption and health outcomes attributable to alcohol use. For dimensions of exposure: volume of alcohol use, blood alcohol concentration and patterns of drinking, in particular heavy drinking occasions were studied. For liver cirrhosis, quality of alcohol was additionally considered. For all outcomes (mortality and/or morbidity): cause of death and disease/injury categories based on International Classification of Diseases (ICD) codes used in global CRAs; harm to others. In total, 255 reviews and meta-analyses were identified. Alcohol use was found to be linked causally to many disease and injury categories, with more than 40 ICD-10 three-digit categories being fully attributable to alcohol. Most partially attributable disease categories showed monotonic relationships with volume of alcohol use: the more alcohol consumed, the higher the risk of disease or death. Exceptions were ischaemic diseases and diabetes, with curvilinear relationships, and with beneficial effects of light to moderate drinking in people without heavy irregular drinking occasions. Biological pathways suggest an impact of heavy drinking occasions on additional diseases; however, the lack of medical epidemiological studies measuring this dimension of alcohol use precluded an in-depth analysis. For injuries, except suicide, blood alcohol concentration was the most important dimension of alcohol use. Alcohol use caused marked harm to others, which has not yet been researched sufficiently. Research since 2010 confirms the importance of alcohol use as a risk factor for disease and injuries; for some health outcomes, more than one dimension of use needs to be considered. Epidemiological studies should include measurement of heavy drinking occasions in line with biological knowledge

Combining best evidence: A novel method to calculate the alcohol-attributable fraction and its variance for injury mortality

<p>Abstract</p> <p>Background</p> <p>The alcohol-attributable fraction for injury mortality is defined as the proportion of fatal injury that would disappear if consumption went to zero. Estimating this fraction has previously been based on a simplistic view of drinking and associated risk. This paper develops a new way to calculate the alcohol-attributable fraction for injury based on different dimensions of drinking, mortality data, experimental data, survey research, new risk scenarios, and by incorporating different distributions of consumption within populations. For this analysis, the Canadian population in 2005 was used as the reference population.</p> <p>Methods</p> <p>Binge drinking and average daily consumption were modeled separately with respect to the calculation of the AAF. The acute consumption risk was calculated with a probability-based method that accounted for both the number of binge drinking occasions and the amount of alcohol consumed per occasion. The average daily consumption was computed based on the prevalence of daily drinking at various levels. These were both combined to get an overall estimate. 3 sensitivity analyses were performed using different alcohol consumption parameters to test the robustness of the model. Calculation of the variance to generate confidence limits around the point estimates was accomplished via Monte Carlo resampling methods on randomly generated AAFs that were based on the distribution and prevalence of drinking in the Canadian population.</p> <p>Results</p> <p>Overall, the AAFs decrease with age and are significantly lower for women than men across all ages. As binge drinking increases, the injury mortality AAF also increases. Motor vehicle collisions show the largest relative increases in AAF as alcohol consumption is increased, with over a 100% increase in AAF from the lowest to highest consumption category. Among non-motor vehicle collisions, the largest change in total AAF occurred both for homicide and other intentional injuries at about a 15% increase in the AAF from the lowest to the highest binge consumption scenarios.</p> <p>Conclusions</p> <p>This method combines the best available evidence to generate new alcohol-attributable fractions for alcohol-attributable injury mortality. Future research is needed to refine the risk function for non-motor vehicle injury types and to investigate potential interactions between binge drinking and average volume of alcohol consumption.</p