252 research outputs found
10 µm minority-carrier diffusion lengths in Si wires synthesized by Cu-catalyzed vapor-liquid-solid growth
The effective electron minority-carrier diffusion length, L_(n,eff), for 2.0 µm diameter Si wires that were synthesized by Cu-catalyzed vapor-liquid-solid growth was measured by scanning photocurrent microscopy. In dark, ambient conditions, L_(n,eff) was limited by surface recombination to a value of ≤ 0.7 µm. However, a value of L_(n,eff) = 10.5±1 µm was measured under broad-area illumination in low-level injection. The relatively long minority-carrier diffusion length observed under illumination is consistent with an increased surface passivation resulting from filling of the surface states of the Si wires by photogenerated carriers. These relatively large L_(n,eff) values have important implications for the design of high-efficiency, radial-junction photovoltaic cells from arrays of Si wires synthesized by metal-catalyzed growth processes
Addressing Alex From A Dynamic Team Approach
Research poster describing investigation of the question: How is collaboration essential or vital to patient-centered care?https://dune.une.edu/cecespring2020/1004/thumbnail.jp
High-performance Si microwire photovoltaics
Crystalline Si wires, grown by the vapor–liquid–solid (VLS)
process, have emerged as promising candidate materials for lowcost, thin-film photovoltaics. Here, we demonstrate VLS-grown Si microwires that have suitable electrical properties for high-performance photovoltaic applications, including long minority-carrier diffusion lengths (L_n » 30 µm) and low surface recombination velocities (S « 70 cm·s^(-1)). Single-wire radial p–n junction solar cells were fabricated with amorphous silicon and silicon nitride
surface coatings, achieving up to 9.0% apparent photovoltaic efficiency, and exhibiting up to ~600 mV open-circuit voltage with over 80% fill factor. Projective single-wire measurements and optoelectronic simulations suggest that large-area Si wire-array solar cells have the potential to exceed 17% energy-conversion efficiency, offering a promising route toward cost-effective crystalline Si photovoltaics
Si microwire-array solar cells
Si microwire-array solar cells with Air Mass 1.5 Global conversion efficiencies of up to 7.9% have been fabricated using an active volume of Si equivalent to a 4 μm thick Si wafer. These solar cells exhibited open-circuit voltages of 500 mV, short-circuit current densities (J_(sc)) of up to 24 mA cm^(-2), and fill factors >65% and employed Al_2O_3 dielectric particles that scattered light incident in the space between the wires, a Ag back reflector that prevented the escape of incident illumination from the back surface of the solar cell, and an a-SiN_x:H passivation/anti-reflection layer. Wire-array solar cells without some or all of these design features were also fabricated to demonstrate the importance of the light-trapping elements in achieving a high J_(sc). Scanning photocurrent microscopy images of the microwire-array solar cells revealed that the higher J_(sc) of the most advanced cell design resulted from an increased absorption of light incident in the space between the wires. Spectral response measurements further revealed that solar cells with light-trapping elements exhibited improved red and infrared response, as compared to solar cells without light-trapping elements
Photoelectrochemical Hydrogen Evolution Using Si Microwire Arrays
Arrays of B-doped p-Si microwires, diffusion-doped with P to form a radial n+ emitter and subsequently coated with a 1.5-nm-thick discontinuous film of evaporated Pt, were used as photocathodes for H_2 evolution from water. These electrodes yielded thermodynamically based energy-conversion efficiencies >5% under 1 sun solar simulation, despite absorbing less than 50% of the above-band-gap incident photons. Analogous p-Si wire-array electrodes yielded efficiencies <0.2%, largely limited by the low photovoltage generated at the p-Si/H_2O junction
Self Reported Incidence and Morbidity of Acute Respiratory Illness among Deployed U.S. Military in Iraq and Afghanistan
BACKGROUND: Historically, respiratory infections have had a significant impact on U.S. military missions. Deployed troops are particularly at high risk due to close living conditions, stressful work environments and increased exposure to pathogens. To date, there are limited data available on acute respiratory illness (ARI) among troops deployed in support of ongoing military operations, specifically Operation Enduring Freedom (OEF) and Operation Iraqi Freedom (OIF). METHODS: Using self-report data from two sources collected from troops deployed to Iraq, Afghanistan and the surrounding region, we analyzed incidence and risk factors for ARI. Military personnel on mid-deployment Rest & Recuperation (R&R) or during redeployment were eligible to participate in the voluntary self-report survey. RESULTS: Overall, 39.5% reported having at least one ARI. Of these, 18.5% sought medical care and 33.8% reported having decreased job performance. The rate of self-reported ARI was 15 episodes per 100 person-months among those taking the voluntary survey, and 24.7 episodes per 100 person-months among those taking the clinic health questionnaire. Negative binomial regression analysis found female sex, Navy branch of service and lack of flush toilets to be independently associated with increased rates of ARI. Deployment to OIF, increasing age and higher rank were also positively associated with ARI risk. CONCLUSIONS: The overall percentage of deployed military personnel reporting at least one acute respiratory illness decreased since earlier parts of OIF/OEF. However, the reported effect on job performance increased tremendously. The most important factors associated with increased respiratory infection are female sex, Navy branch of service, lack of improved latrine facilities, deployment to OIF, increasing age and higher rank
A retrospective observational study of traumatic orthopaedic: related infections in Cambodia
Background: The objective of this study was to establish the type of microbiology along with antimicrobial resistance related to orthopedic related trauma infections in this area in order to help guide diagnosis and treatment regimens.Methods:This study evaluated the microbial etiology of orthopedic-related infections (ORI) between September 2015 and September 2016 in three tertiary hospitals in Phnom Penh, Cambodia. Clinical records were for clinical features and demographics. Standard laboratory bacteriology was used to recover, identified and perform antibiotic susceptibility testing (AST) by disk diffusion or broth microdilution.Results:119 patients were categorized as ORI cases. In the cases identified, median interquartile range (IQR) age was 38 (IQR: 26-46) years and 80.0% were male. Of the 119 ORI cases, a total of 156 bacterial strains were recovered, identified and after review, 128 of these pathogenic bacterial strains underwent AST. Among the gram-positive pathogens, the following susceptibilities were as follows: Staphylococcus aureus (n=57) (Methicillin-resistant S. aureus (n=35; 61.4%), (Methicillin‐sensitive S. aureus (n=22; 38.6%)), coagulase-negative staphylococcus (all MS-CoNS; n=6) and four isolates of Enterococcus sp. (non-VRE). A total of 44 gram-negative pathogens were recovered and AST was performed. Among these 44, a total of nine extended-spectrum beta-lactamase (ESBL) producing strains (20.5%) were discovered including Escherichia coli (n=8), Klebsiella pneumoniae (n=1) and carbapenemase-resistant Enterobacteriaceae (CRE) (Morganella morganii). In addition, a single E. coli isolate contained both the ESBL and CRE genotypes was noted.Conclusions:This data suggests that ORI rates in Cambodia appear to be comparable to other studies in the literature. However, further studies need to be done in order to establish definitive data related to orthopedic infections in the region
Energy-Conversion Properties of Vapor-Liquid-Solid–Grown Silicon Wire-Array Photocathodes
Silicon wire arrays, though attractive materials for use in photovoltaics and as photocathodes for hydrogen generation, have to date exhibited poor performance. Using a copper-catalyzed, vapor-liquid-solid–growth process, SiCl_4 and BCl_3 were used to grow ordered arrays of crystalline p-type silicon (p-Si) microwires on p^+-Si(111) substrates. When these wire arrays were used as photocathodes in contact with an aqueous methyl viologen^(2+/+) electrolyte, energy-conversion efficiencies of up to 3% were observed for monochromatic 808-nanometer light at fluxes comparable to solar illumination, despite an external quantum yield at short circuit of only 0.2. Internal quantum yields were at least 0.7, demonstrating that the measured photocurrents were limited by light absorption in the wire arrays, which filled only 4% of the incident optical plane in our test devices. The inherent performance of these wires thus conceptually allows the development of efficient photovoltaic and photoelectrochemical energy-conversion devices based on a radial junction platform
Cognitive Computation sans Representation
The Computational Theory of Mind (CTM) holds that cognitive processes are essentially computational, and hence computation provides the scientific key to explaining mentality. The Representational Theory of Mind (RTM) holds that representational content is the key feature in distinguishing mental from non-mental systems. I argue that there is a deep incompatibility between these two theoretical frameworks, and that the acceptance of CTM provides strong grounds for rejecting RTM. The focal point of the incompatibility is the fact that representational content is extrinsic to formal procedures as such, and the intended interpretation of syntax makes no difference to the execution of an algorithm. So the unique 'content' postulated by RTM is superfluous to the formal procedures of CTM. And once these procedures are implemented in a physical mechanism, it is exclusively the causal properties of the physical mechanism that are responsible for all aspects of the system's behaviour. So once again, postulated content is rendered superfluous. To the extent that semantic content may appear to play a role in behaviour, it must be syntactically encoded within the system, and just as in a standard computational artefact, so too with the human mind/brain - it's pure syntax all the way down to the level of physical implementation. Hence 'content' is at most a convenient meta-level gloss, projected from the outside by human theorists, which itself can play no role in cognitive processing
- …