Toward production of jet fuel functionality in oilseeds: identification of FatB acyl-acyl carrier protein thioesterases and evaluation of combinatorial expression strategies in \u3ci\u3eCamelina\u3c/i\u3e seeds

Seeds of members of the genus Cuphea accumulate medium-chain fatty acids (MCFAs; 8:0–14:0). MCFA- and palmitic acid- (16:0) rich vegetable oils have received attention for jet fuel production, given their similarity in chain length to Jet A fuel hydrocarbons. Studies were conducted to test genes, including those from Cuphea, for their ability to confer jet fuel-type fatty acid accumulation in seed oil of the emerging biofuel crop Camelina sativa. Transcriptomes from Cuphea viscosissima and Cuphea pulcherrima developing seeds that accumulate \u3e90% of C8 and C10 fatty acids revealed three FatB cDNAs (CpuFatB3, CvFatB1, and CpuFatB4) expressed predominantly in seeds and structurally divergent from typical FatB thioesterases that release 16:0 from acyl carrier protein (ACP). Expression of CpuFatB3 and CvFatB1 resulted in Camelina oil with capric acid (10:0), and CpuFatB4 expression conferred myristic acid (14:0) production and increased 16:0. Co-expression of combinations of previously characterized Cuphea and California bay FatBs produced Camelina oils with mixtures of C8–C16 fatty acids, but amounts of each fatty acid were less than obtained by expression of individual FatB cDNAs. Increases in lauric acid (12:0) and 14:0, but not 10:0, in Camelina oil and at the sn-2 position of triacylglycerols resulted from inclusion of a coconut lysophosphatidic acid acyltransferase specialized for MCFAs. RNA interference (RNAi) suppression of Camelina β-ketoacyl-ACP synthase II, however, reduced 12:0 in seeds expressing a 12:0-ACP-specific FatB. Camelina lines presented here provide platforms for additional metabolic engineering targeting fatty acid synthase and specialized acyltransferases for achieving oils with high levels of jet fuel-type fatty acids

Toward production of jet fuel functionality in oilseeds: identification of FatB acyl-acyl carrier protein thioesterases and evaluation of combinatorial expression strategies in \u3ci\u3eCamelina\u3c/i\u3e seeds

Seeds of members of the genus Cuphea accumulate medium-chain fatty acids (MCFAs; 8:0–14:0). MCFA- and palmitic acid- (16:0) rich vegetable oils have received attention for jet fuel production, given their similarity in chain length to Jet A fuel hydrocarbons. Studies were conducted to test genes, including those from Cuphea, for their ability to confer jet fuel-type fatty acid accumulation in seed oil of the emerging biofuel crop Camelina sativa. Transcriptomes from Cuphea viscosissima and Cuphea pulcherrima developing seeds that accumulate \u3e90% of C8 and C10 fatty acids revealed three FatB cDNAs (CpuFatB3, CvFatB1, and CpuFatB4) expressed predominantly in seeds and structurally divergent from typical FatB thioesterases that release 16:0 from acyl carrier protein (ACP). Expression of CpuFatB3 and CvFatB1 resulted in Camelina oil with capric acid (10:0), and CpuFatB4 expression conferred myristic acid (14:0) production and increased 16:0. Co-expression of combinations of previously characterized Cuphea and California bay FatBs produced Camelina oils with mixtures of C8–C16 fatty acids, but amounts of each fatty acid were less than obtained by expression of individual FatB cDNAs. Increases in lauric acid (12:0) and 14:0, but not 10:0, in Camelina oil and at the sn-2 position of triacylglycerols resulted from inclusion of a coconut lysophosphatidic acid acyltransferase specialized for MCFAs. RNA interference (RNAi) suppression of Camelina β-ketoacyl-ACP synthase II, however, reduced 12:0 in seeds expressing a 12:0-ACP-specific FatB. Camelina lines presented here provide platforms for additional metabolic engineering targeting fatty acid synthase and specialized acyltransferases for achieving oils with high levels of jet fuel-type fatty acids

Toward production of jet fuel functionality in oilseeds: identification of FatB acyl-acyl carrier protein thioesterases and evaluation of combinatorial expression strategies in \u3ci\u3eCamelina\u3c/i\u3e seeds

Seeds of members of the genus Cuphea accumulate medium-chain fatty acids (MCFAs; 8:0–14:0). MCFA- and palmitic acid- (16:0) rich vegetable oils have received attention for jet fuel production, given their similarity in chain length to Jet A fuel hydrocarbons. Studies were conducted to test genes, including those from Cuphea, for their ability to confer jet fuel-type fatty acid accumulation in seed oil of the emerging biofuel crop Camelina sativa. Transcriptomes from Cuphea viscosissima and Cuphea pulcherrima developing seeds that accumulate \u3e90% of C8 and C10 fatty acids revealed three FatB cDNAs (CpuFatB3, CvFatB1, and CpuFatB4) expressed predominantly in seeds and structurally divergent from typical FatB thioesterases that release 16:0 from acyl carrier protein (ACP). Expression of CpuFatB3 and CvFatB1 resulted in Camelina oil with capric acid (10:0), and CpuFatB4 expression conferred myristic acid (14:0) production and increased 16:0. Co-expression of combinations of previously characterized Cuphea and California bay FatBs produced Camelina oils with mixtures of C8–C16 fatty acids, but amounts of each fatty acid were less than obtained by expression of individual FatB cDNAs. Increases in lauric acid (12:0) and 14:0, but not 10:0, in Camelina oil and at the sn-2 position of triacylglycerols resulted from inclusion of a coconut lysophosphatidic acid acyltransferase specialized for MCFAs. RNA interference (RNAi) suppression of Camelina β-ketoacyl-ACP synthase II, however, reduced 12:0 in seeds expressing a 12:0-ACP-specific FatB. Camelina lines presented here provide platforms for additional metabolic engineering targeting fatty acid synthase and specialized acyltransferases for achieving oils with high levels of jet fuel-type fatty acids

Epidemiology of Japanese Encephalitis in the Philippines prior to routine immunization.

BACKGROUND In 2015, we published our findings highlighting the endemicity of Japanese encephalitis (JE) in the Philippines. The policymakers responded by conducting an immunization campaign and strengthening the surveillance system. Using the data on the revitalized surveillance system, we updated the epidemiology of JE in the country METHODS: Electronic databases were searched, and conference proceedings related to JE in the Philippines were identified until 31 December 2018. We used surveillance data from 1 January 2014 to 31 December 2017. We used the 2015 population census to estimate the national and regional incidence for children <15 years old. RESULTS Four studies reported on the seroprevalence of JE in the Philippines, which showed increasing seroprevalence with increasing age. Seroprevalence rates were from zero for infants (<1 year old) to 65.7% in adolescents (12-18 years old) before the immunization campaign. Among five studies on clinical profile JE, case fatality ranged from zero to 21.1%, and neurologic sequelae ranged from 5.2% to 81.8% of diagnosed cases. In the surveillance data, JE cases peaked annually from July to October, coinciding with the wet season. The national incidence was estimated at 0.7 JE cases/100,000 among children <15 years at a minimum, but higher rates were seen in the northern regions of the country. CONCLUSION Improved surveillance affirmed the burden of JE in the Philippines. A subnational immunization campaign in April 2019 was conducted in the northern regions of the country. We highlight the importance of the inclusion of JE vaccine in the immunization program and sustained high-quality surveillance to monitor its impact on JE control

Silent onset of postmenopausal endometriosis in a woman with renal failure in hormone replacement therapy: a case report

<p>Abstract</p> <p>Introduction</p> <p>Postmenopausal endometriosis is a rare form of a common disease, since the absence of estrogenic hormone production should halt disease progression.</p> <p>Case presentation</p> <p>We present the case of a 54-year-old Italian Caucasian woman in surgical menopause with a history of ovarian endometriosis, who underwent voluntary hormone replacement therapy for seven years. She developed postrenal renal failure due to bilateral compression of the pelvic ureteral tract caused by two large, deeply infiltrating endometriotic nodules with no pelvic pain. She underwent operative laparoscopy with adhesiolysis of enteroenteric adhesions and excision of the endometriotic nodules encompassing the juxtavesical tract of the ureters, without obtaining improvement of renal failure.</p> <p>Conclusion</p> <p>Postmenopausal endometriosis can manifest itself in an unpredictable and potentially very serious manner. It is therefore important to carefully evaluate the risks and benefits of administering hormone replacement therapy to patients with previous endometriosis.</p

Wavelength conversion in a highly nonlinear chalcogenide microstructured fiber

International audienceWe report on all-optical wavelength conversion of a 56 Gb/s differential quadrature phase shift keying signal and a 42.7 Gb/s on-off keying signal. Wavelength conversion is based on four-wave mixing effect in a 1 m long highly nonlinear GeAsSe chalcogenide fiber. The high nonlinearity of the fiber allows low-power penalty operation with a total average power of less than 60 mW

Epstein-Barr Virus Reactivation After Paediatric Haematopoietic Stem Cell Transplantation: Risk Factors and Sensitivity Analysis of Mathematical Model

Epstein-Barr virus (EBV) establishes a lifelong latent infection in healthy humans, kept under immune control by cytotoxic T cells (CTLs). Following paediatric haematopoetic stem cell transplantation (HSCT), a loss of immune surveillance leads to opportunistic outgrowth of EBV-infected cells, resulting in EBV reactivation, which can ultimately progress to post-transplant lymphoproliferative disorder (PTLD). The aims of this study were to identify risk factors for EBV reactivation in children in the first 100 days post-HSCT and to assess the suitability of a previously reported mathematical model to mechanistically model EBV reactivation kinetics in this cohort. Retrospective electronic data were collected from 56 children who underwent HSCT at Great Ormond Street Hospital (GOSH) between 2005 and 2016. Using EBV viral load (VL) measurements from weekly quantitative PCR (qPCR) monitoring post-HSCT, a multivariable Cox proportional hazards (Cox-PH) model was developed to assess time to first EBV reactivation event in the first 100 days post-HSCT. Sensitivity analysis of a previously reported mathematical model was performed to identify key parameters affecting EBV VL. Cox-PH modelling revealed EBV seropositivity of the HSCT recipient and administration of anti-thymocyte globulin (ATG) pre-HSCT to be significantly associated with an increased risk of EBV reactivation in the first 100 days post-HSCT (adjusted hazard ratio (AHR) = 2.32, P = 0.02; AHR = 2.55, P = 0.04). Five parameters were found to affect EBV VL in sensitivity analysis of the previously reported mathematical model. In conclusion, we have assessed the effect of multiple covariates on EBV reactivation in the first 100 days post-HSCT in children and have identified key parameters in a previously reported mechanistic mathematical model that affect EBV VL. Future work will aim to fit this model to patient EBV VLs, develop the model to account for interindividual variability and model the effect of clinically relevant covariates such as rituximab therapy and ATG on EBV VL

Optimizing enzymatic dyeing of wool and leather

This work reports on the environmental friendly enzymatic dyeing of wool and leather performed at low temperature and mild pH conditions without any dyeing auxiliaries. The substrates have been dyed with “in situ” generated pigment by means of laccase-catalyzed oxidative coupling of dye modifier 2,2′-azino-bis(3-ethylbenzothiazoline-6-sulphonic acid) and dye precursor 1,3-benzenediol in a batchwise process. The process reaction variables (laccase, precursor and modifier concentrations, temperature and dyeing time) were optimized by response surface methodology using an appropriate experimental design. The temperature, precursor concentration, interaction between precursor and modifier and time are the most important factors in the dyeing process. The best-optimized wool dyeing conditions (2 h reaction time, 50 μl laccase (0.1 U), 500 mM precursor, 10 mM modifier at 40 °C) were then successfully applied onto leather material. The enzymatic-dyeing optimized process can be successfully performed on wool and leather at low temperature and mild pH obtaining different hues and depths of shades by varying the modifier concentration and time. The colouring enzymatic system has a good reusability (which has a huge advantage in terms of cost reduction) and washing durability and is comparable in terms of fastness properties to the traditional dyeing process for both wool and leather.The authors acknowledge the Portuguese Foundation for Science and Technology (FCT) for funding the project UID/CTM/00264/2019 and A. Zille contract IF/00071/2015