5,348 research outputs found

    Development of improved low-strain creep strength in Cabot alloy R-41 sheet

    Get PDF
    The feasibility of improving the low-strain creep properties of a thin gauge nickel base sheet alloy through modified heat treatment or through development of a preferred crystal-lographic texture was investigated. The basic approach taken to improve the creep strength of the material by heat treatment was to increase grain size by raising the solution treatment temperature for the alloy to the range of 1420 K to 1475 K (2100 F to 2200 F). The key technical issue involved was maintenance of adequate tensile ductility following the solutioning of M6C primary carbides during the higher temperature solution treatment. The approach to improve creep properties by developing a sheet texture involved varying both annealing temperatures and the amount of prior cold work. Results identified a heat treatment for alloy R-14 sheet which yields a substantial creep-life advantage at temperatures above 1090 K (1500 F) when compared with material given the standard heat treatment. At the same time, this treatment provides reasonable tensile ductility over the entire temperature range of interest. The mechanical properties of the material given the new heat treatment are compared with those for material given the standard heat treatment. Attempts to improve creep strength by developing a sheet texture were unsuccessful

    Two-dimensional hydrodynamic lattice-gas simulations of binary immiscible and ternary amphiphilic fluid flow through porous media

    Full text link
    The behaviour of two dimensional binary and ternary amphiphilic fluids under flow conditions is investigated using a hydrodynamic lattice gas model. After the validation of the model in simple cases (Poiseuille flow, Darcy's law for single component fluids), attention is focussed on the properties of binary immiscible fluids in porous media. An extension of Darcy's law which explicitly admits a viscous coupling between the fluids is verified, and evidence of capillary effects are described. The influence of a third component, namely surfactant, is studied in the same context. Invasion simulations have also been performed. The effect of the applied force on the invasion process is reported. As the forcing level increases, the invasion process becomes faster and the residual oil saturation decreases. The introduction of surfactant in the invading phase during imbibition produces new phenomena, including emulsification and micellisation. At very low fluid forcing levels, this leads to the production of a low-resistance gel, which then slows down the progress of the invading fluid. At long times (beyond the water percolation threshold), the concentration of remaining oil within the porous medium is lowered by the action of surfactant, thus enhancing oil recovery. On the other hand, the introduction of surfactant in the invading phase during drainage simulations slows down the invasion process -- the invading fluid takes a more tortuous path to invade the porous medium -- and reduces the oil recovery (the residual oil saturation increases).Comment: 48 pages, 26 figures. Phys. Rev. E (in press

    Effects of interdot dipole coupling in mesoscopic epitaxial Fe(100) dot arrays

    Get PDF
    The domain structure and the coercivity of epitaxial Fe(100) circular dot arrays of different diameters and separations have been studied using magnetic force microscopy (MFM) and focused magneto-optical Kerr effect (MOKE). The MFM images of the 1 ”m diameter single domain dot arrays show direct evidence of strong interdot dipole coupling when the separation is reduced down to 0.1 ”m. The coercivity of the dots is also found to be dependent on the separation, indicating the effect of the interdot dipole coupling on the magnetization reversal process

    Shear-Induced Isotropic-to-Lamellar Transition in a Lattice-Gas Model of Ternary Amphiphilic Fluids

    Full text link
    Although shear-induced isotropic-to-lamellar transitions in ternary systems of oil, water and surfactant have been observed experimentally and predicted theoretically by simple models for some time now, their numerical simulation has not been achieved so far. In this work we demonstrate that a recently introduced hydrodynamic lattice-gas model of amphiphilic fluids is well suited for this purpose: the two-dimensional version of this model does indeed exhibit a shear-induced isotropic-to-lamellar phase transition.Comment: 17 pages, LaTeX with epsf and REVTeX, PostScript and EPS illustrations included. To appear in J. Phys. Cond. Ma

    Digital health care solution for proactive heart failure management with the Cordella Heart Failure System : results of the SIRONA first‐in‐human study

    Get PDF
    Aims Incorporation of remote monitoring of pulmonary artery pressure and vital signs has been demonstrated to reduce heart failure (HF) hospitalization and all‐cause mortality in selected symptomatic HF patients. The aim of this study is to investigate the safety and accuracy of the new CordellaTM Pulmonary Artery Pressure Sensor (Endotronix, Inc., Chicago, IL, USA) and the usability of the comprehensive CordellaTM Heart Failure System (CHFS). Methods and results Multicentre, open‐label, first‐in‐human, feasibility study to evaluate the CHFS and the safety and accuracy of the Cordellaℱ Pulmonary Artery Pressure Sensor in 15 patients with New York Heart Association class III HF. All patients were successfully implanted with the Cordella Pulmonary Artery Pressure Sensor, without sensor failure. No device system‐related complications, defined as invasive treatment, device explant or death, occurred. The primary efficacy endpoint of a mean pulmonary artery pressure at 90 days was met in all but one patients with a cohort difference of 2.7 mmHg (Cordella Sensor 22.5 ± 11.8 mmHg, Swan–Ganz catheter 25.2 ± 8.5 mmHg). One patient did not go through the 90‐day right heart catheterization for safety reasons. Patient adherence to daily measurement, transmission of vital signs and pulmonary artery pressure sensor readings were recorded 99% of the time. Conclusion The initial experience of the CHFS incorporating comprehensive vital signs and pulmonary artery pressure monitoring enables safe and accurate monitoring of HF status

    Three dimensional hysdrodynamic lattice-gas simulations of binary immiscible and ternary amphiphilic flow through porous media

    Full text link
    We report the results of a study of multiphase flow in porous media. A Darcy's law for steady multiphase flow was investigated for both binary and ternary amphiphilic flow. Linear flux-forcing relationships satisfying Onsager reciprocity were shown to be a good approximation of the simulation data. The dependence of the relative permeability coefficients on water saturation was investigated and showed good qualitative agreement with experimental data. Non-steady state invasion flows were investigated, with particular interest in the asymptotic residual oil saturation. The addition of surfactant to the invasive fluid was shown to significantly reduce the residual oil saturation.Comment: To appear in Phys. Rev.

    Evaluating the stability of atmospheric lines with HARPS

    Full text link
    Context: In the search for extrasolar systems by radial velocity technique, a precise wavelength calibration is necessary for high-precision measurements. The choice of the calibrator is a particularly important question in the infra-red domain, where the precision and exploits still fall behind the achievements of the optical. Aims: We investigate the long-term stability of atmospheric lines as a precise wavelength reference and analyze their sensitivity to different atmospheric and observing conditions. Methods: We use HARPS archive data on three bright stars, Tau Ceti, Mu Arae and Epsilon Eri, spanning 6 years and containing high-cadence measurements over several nights. We cross-correlate this data with an O2 mask and evaluate both radial velocity and bisector variations down to a photon noise of 1 m/s. Results: We find that the telluric lines in the three data-sets are stable down to 10 m/s (r.m.s.) over the 6 years. We also show that the radial velocity variations can be accounted for by simple atmospheric models, yielding a final precision of 1-2 m/s. Conclusions: The long-term stability of atmospheric lines was measured as being of 10 m/s over six years, in spite of atmospheric phenomena. Atmospheric lines can be used as a wavelength reference for short-time-scales programs, yielding a precision of 5 m/s "out-of-the box". A higher precision, down to 2 m/s can be reached if the atmospheric phenomena are corrected for by the simple atmospheric model described, making it a very competitive method even on long time-scales.Comment: 7 pages, accepted for publication in A&

    Computer simulations of domain growth and phase separation in two-dimensional binary immiscible fluids using dissipative particle dynamics

    Full text link
    We investigate the dynamical behavior of binary fluid systems in two dimensions using dissipative particle dynamics. We find that following a symmetric quench the domain size R(t) grows with time t according to two distinct algebraic laws R(t) = t^n: at early times n = 1/2, while for later times n = 2/3. Following an asymmetric quench we observe only n = 1/2, and if momentum conservation is violated we see n = 1/3 at early times. Bubble simulations confirm the existence of a finite surface tension and the validity of Laplace's law. Our results are compared with similar simulations which have been performed previously using molecular dynamics, lattice-gas and lattice-Boltzmann automata, and Langevin dynamics. We conclude that dissipative particle dynamics is a promising method for simulating fluid properties in such systems.Comment: RevTeX; 22 pages, 5 low-resolution figures. For full-resolution figures, connect to http://www.tcm.phy.cam.ac.uk/~ken21/tension/tension.htm

    Southern Europe as an example of interaction between various environmental factors: a systematic review of the epidemiologic evidence

    Get PDF
    Hepatitis B virus (HBV), hepatitis C virus (HCV) and alcohol consumption are major causes of hepatocellular carcinoma (HCC) worldwide. We performed a systematic review of epidemiologic studies carried out on HCC aetiology in Southern Europe, an area with an intermediate– high prevalence of these agents as well as of putative risk factors such as tobacco smoking, diabetes and obesity. To retrieve the articles, we performed a Medline search for titles and abstracts of articles. After the Medline search, we reviewed the papers and reference lists to identify additional articles. A synergism between HCV infection and HBV infection, overt (hepatitis B virus antigen (HbsAg) positivity) or occult (HBsAg negativity with presence of HBV DNA in liver or serum), is suggested by the results of some studies. The pattern of the risk for HCC due to alcohol intake shows a continuous dose–effect curve without a definite threshold, although most studies found that HCC risk increased only for alcohol consumption above 40–60 g of ethanol per day. Some evidence supports a positive interaction of alcohol intake probably with HCV infection and possibly with HBV infection. A few studies found that coffee has a protective effect on HCC risk due to various risk factors. Some data also support a role of tobacco smoking, diabetes and obesity as single agents or preferably cofactors in causing HCC. In countries with a relatively high alcohol consumption and intermediate levels of HCV and HBV infections (1–3% of population infected by each virus), such as Mediterranean countries, the three main risk factors together account for about 85% of the total HCC cases, leaving little space to other known risk factors, such as haemochromatosis, and to new, still unrecognised, factors as independent causes of HCC. Oncogene (2006) 25, 3756–3770. doi:10.1038/sj.onc.120955

    Holonomy invariance, orbital resonances, and kilohertz QPOs

    Get PDF
    Quantized orbital structures are typical for many aspects of classical gravity (Newton's as well as Einstein's). The astronomical phenomenon of orbital resonances is a well-known example. Recently, Rothman, Ellis and Murugan (2001) discussed quantized orbital structures in the novel context of a holonomy invariance of parallel transport in Schwarzschild geometry. We present here yet another example of quantization of orbits, reflecting both orbital resonances and holonomy invariance. This strong-gravity effect may already have been directly observed as the puzzling kilohertz quasi-periodic oscillations (QPOs) in the X-ray emission from a few accreting galactic black holes and several neutron stars
    • 

    corecore