Influence of anodizing process on fatigue life of a machined aluminium alloy

In order to investigate the coupled effects of machining and anodizing processes on fatigue life of alloy 7010-T7451, a series of rotating bending fatigue tests were conducted at 60Hz. In the as machined condition, test results showed that fatigue life is surface roughness dependent and that fatigue life decreases with an increase in surface roughness and this effect is found to be more pronounced in high cycle fatigue where major portion of fatigue life is consumed in nucleating the cracks. Effects of pretreatments, like degreasing and pickling employed prior to anodizing, on fatigue life of the given alloy were also studied. Results demonstrated that degreasing showed no change in fatigue life while pickling had negative impact on fatigue life of specimens. The small decrease in fatigue life of anodized specimens as compare to pickled specimens is attributed to brittle and microcracking of the coating. Scanning electron microscopic (SEM) examination revealed multi-site crack initiation for the pickled and anodized specimens. SEM examination showed that pickling solution attacked the grain boundaries and intermetallic inclusions present on the surface resulting in pits formation. These pits are of primary concern with respect to accelerated fatigue crack nucleation and subsequent anodized coating formation

Volume 3 Chapter 6: Transformation paths

There is little doubt that the currently observed patterns of climate change are predominantly caused by human activity (Volume 1, Chapter 1). This chapter addresses the challenge of stabilizing climate change at 2 degrees C and particularly focuses on the questions which mitigation and adaptation measures in Austria can contribute to achieve this goal. Additionally, a number of desirable co-benefits pertaining to socio-ecological transformation leading towards limiting climate change are analysed. In the Copenhagen Accord (UNFCC) and in the EU-Ruling, a goal of limiting the rise of global average temperature to +2 degrees C compared to pre-industrial times has been deemed as necessary to limit dangerous anthropogenic climate change impacts, despite calls from scientists to consider a +1.5 degrees C target. It is an internationally accepted target supported by a broad number of supporters, including industrialized and developing countries as well as non-state actors. Without actions towards reducing emissions, significant negative impacts on the socio-economic conditions in Austria can be expected. This derives an important obligation to undertake necessary mitigation measures in Austria. Mitigation and adaptation measures are necessary, but by themselves provide insufficient conditions for sustainable development. Achievement of the 2 degrees C target requires a focus on climate friendly technologies, as well as behavioural - and institutional change. In particular, the activities of energy provision and consumption, industrial processes and agriculture deserve attention: in 2012, the energy sector activities caused 74.6% of GHG emissions (with one third originating from road transport), industrial processes caused 13.6%, and agriculture triggered 9.4% of emissions, (excluding emission effects of forest cover expansion, cf. Anderl et al., 2014). The corresponding figures for 2010 are: energy sector 75.9%, industrial processes: 12.7%, agriculture: 8.8% (Anderl et al., 2014). To stabilize the climate, the climate impact criteria have to be integrated in all decisions regarding investment, production, politics and consumption, in order to reduce the risk of irreversible changes. At the same time, the social- and economic framing conditions must be respected. Measures to address climate change have to be integrated into the broader criteria of sustainability. Discussions of climate protection measures are typically reduced to additional costs and undesirable changes. Thereby the manifold potential co-benefits of such measures, for example with respect to quality of life, health, employment, rural development, environmental protection, security of supply, and international trade balances are mostly ignored. Integrating these criteria and effects into the analysis is required for being able to display the full spectrum of options for addressing climate change

The comparison between two methods of basic life support instruction: Video self-instruction versus traditional method

Introduction: Medical education is changing and evolving. Teachers need to re-evaluate their medical teaching practice to enhance student learning. The data about the ideal training method of Basic Life Support (BLS) is lacking. The goal of this study was to analyse the use and performance of video self-instruction (VSI) method in BLS, in order to develop an efficient BLS training method. Methods: Eighty-one undergraduate medical interns were enrolled in a prospective clinical study in 2011. They were divided into VSI group and traditional group. We provided the first group with a DVD containing a 20-minute training video while the second group took part in a 4-hour training class of BLS. Subjects participated in a pre-test and post-test based on 2010 American Heart Association Resuscitation guideline. Results: The average scores of VSI group and the traditional group before training were 8.85±2.42 and 8.57±2.22 respectively (p=0.592). After training, the average scores of the VSI and the traditional group were 20.24±0.83 and 18.05±1.86 respectively. VSI group achieved slightly better scores compared with the traditional group (p<0.001). Conclusions: Training through VSI achieves more satisfying results than the traditional lecture method. VSI method can be considered a useful technique in undergraduate educational programs. Developing VSI can increase significantly the access to the BLS training. © 2015, Medcom Limited. All rights reserved

Temperature measurement on neurological pulse generators during MR scans

According to manufacturers of both magnetic resonance imaging (MRI) machines, and implantable neurological pulse generators (IPGs), MRI is contraindicated for patients with IPGs. A major argument for this restriction is the risk to induce heat in the leads due to the electromagnetic field, which could be dangerous for the surrounding brain parenchyma. The temperature change on the surface of the case of an ITREL-III (Medtronic Inc., Minneapolis, MN) and the lead tip during MRI was determined. An anatomical realistic and a cubic phantom, filled with phantom material mimicking human tissue, and a typical lead configuration were used to imitate a patient who carries an IPG for deep brain stimulation. The measurements were performed in a 1.5 T and a 3.0 T MRI. 2.1°C temperature increases at the lead tip uncovered the lead tip as the most critical part concerning heating problems in IPGs. Temperature increases in other locations were low compared to the one at the lead tip. The measured temperature increase of 2.1°C can not be considered as harmful to the patient. Comparison with the results of other studies revealed the avoidance of loops as a practical method to reduce heating during MRI procedures

On-resin N-methylation of cyclic peptides for discovery of orally bioavailable scaffolds.

Backbone N-methylation is common among peptide natural products and has a substantial impact on both the physical properties and the conformational states of cyclic peptides. However, the specific impact of N-methylation on passive membrane diffusion in cyclic peptides has not been investigated systematically. Here we report a method for the selective, on-resin N-methylation of cyclic peptides to generate compounds with drug-like membrane permeability and oral bioavailability. The selectivity and degree of N-methylation of the cyclic peptide was dependent on backbone stereochemistry, suggesting that conformation dictates the regiochemistry of the N-methylation reaction. The permeabilities of the N-methyl variants were corroborated by computational studies on a 1,024-member virtual library of N-methyl cyclic peptides. One of the most permeable compounds, a cyclic hexapeptide (molecular mass = 755 Da) with three N-methyl groups, showed an oral bioavailability of 28% in rat

Il10 Deficiency Rebalances Innate Immunity to Mitigate Alzheimer-Like Pathology

SummaryThe impact of inflammation suppressor pathways on Alzheimer’s disease (AD) evolution remains poorly understood. Human genetic evidence suggests involvement of the cardinal anti-inflammatory cytokine, interleukin-10 (IL10). We crossed the APP/PS1 mouse model of cerebral amyloidosis with a mouse deficient in Il10 (APP/PS1+Il10−/−). Quantitative in silico 3D modeling revealed activated Aβ phagocytic microglia in APP/PS1+Il10−/− mice that restricted cerebral amyloidosis. Genome-wide RNA sequencing of APP/PS1+Il10−/− brains showed selective modulation of innate immune genes that drive neuroinflammation. Il10 deficiency preserved synaptic integrity and mitigated cognitive disturbance in APP/PS1 mice. In vitro knockdown of microglial Il10-Stat3 signaling endorsed Aβ phagocytosis, while exogenous IL-10 had the converse effect. Il10 deficiency also partially overcame inhibition of microglial Aβ uptake by human Apolipoprotein E. Finally, the IL-10 signaling pathway was abnormally elevated in AD patient brains. Our results suggest that “rebalancing” innate immunity by blocking the IL-10 anti-inflammatory response may be therapeutically relevant for AD

Venous air embolisms and sitting position in Helsinki pineal region surgery

Peer reviewe

Improvement Least-Distance Measure Model with Coplanar DMU on Strong Hyperplanes

Technique of Data Envelopment Analysis (DEA) involves methods conducted for desirable objective management of Decision Making Unit (DMU) that is same increasing of efficiency level. Data envelopment analysis furthermore determines the efficiency level, provides situation, removes inefficiency with evaluated benchmarking information. In this paper the use of the improvement Least-Distance measure with relation previous model by coplanar DMU, is proposed for computational dissipation at assess distance on these interior combinations, for determination the shortest projection from a considered unit to the strongly efficient production frontier. Therefore locate nearest path to improvement efficiency the evaluated DMU

The promising applications of ultrasound in emergency medicine and critical care related to in cancer: A review

The referral of critically ill cancer patients to an Intensive Care Unit (ICU) is a matter of controversial debate. During the past decade, ultrasound imaging performed by emergency physicians and critical care providers has gained significant clinical importance. A number of researches reported the ability of emergency physicians and critical care providers to carry out and interpret bedside assessments exactly, along with a great effect on the quality of care. It is possible assessing ultrasound-mediated subjects who are very much instable to be evaluated through alternative imaging methods. Furthermore, ultrasound in the emergency medicine and critical care open a new way towards facilitate diagnosis, simplify rapid dispositions, and influence management decisions. The primarily perspective of bedside ultrasound by emergency physicians and critical care providers was limited to a few applications. However, it was observed a number of new applications due to the universal and extensive adaptation of ultrasound in emergency uses. In this review, we discussed the promising applications of ultrasound for emergency medicine and critical care that encompass telemedicine, prehospital setting, soft tissue, fractures, ocular, paracentesis, pneumothorax, foreign bodies, bladder and arthrocentesis ultrasound. © Oncology and Radiotherapy