674 research outputs found
Thermal analysis of water in reinforced plasma-polymerised poly(2-hydroxyethyl acrylate) hydrogels
Thermal analysis of water in reinforce hydrogels of plasma-polymerised poly(2-hydroxyethyl acrylate) (plPHEA) grafted onto macroporous poly(methyl methacrylate) (PMMA) are explained in a simple thermodynamic framework based on the transition diagram. Water in bulk PHEA was also analysed for comparison with plPHEA. These two hydrophilic polymers were prepared with a broad range of water mass fractions from 0.05 to 0.72. Thermal transition diagrams of water/PHEA and water/plPHEA were determined showing less undercooling of water crystallisation in plPHEA than in PHEA. Kinetics of water crystallisation for high and low water contents were studied in both hydrophilic systems following several thermal treatments. Water crystallises much faster in plPHEA than in PHEA for high water contents. For low water contents, crystallisation becomes possible holding at 30 degrees C for some time due to water segregation in both PHEA systems. However, much less water is segregated from the water/plPHEA mixture due to the influence of the hydrophobic component.This work was supported by a Marie Curie Host Fellowship and by the Spanish Science and Technology Ministry through the MAT2001-2678-C02-01 and MAT2002-04239-C03-03 projects. CIBER-BBN is an initiative funded by the VI National R&D&i Plan 2008-2011, Iniciativa Ingenio 2010, Consolider Program, CIBER Actions and financed by the Instituto de Salud Carlos III with assistance from the European Regional Development Fund.Serrano Aroca, Á.; Monleón Pradas, M.; Gómez Ribelles, JL.; Rault, J. (2015). Thermal analysis of water in reinforced plasma-polymerised poly(2-hydroxyethyl acrylate) hydrogels. European Polymer Journal. 72:523-534. https://doi.org/10.1016/j.eurpolymj.2015.05.032S5235347
Time-resolved PhotoEmission Spectroscopy on a Metal/Ferroelectric Heterostructure
In thin film ferroelectric capacitor the chemical and electronic structure of
the electrode/FE interface can play a crucial role in determining the kinetics
of polarization switching. We investigate the electronic structure of a
Pt/BaTiO3/SrTiO3:Nb capacitor using time-resolved photoemission spectroscopy.
The chemical, electronic and depth sensitivity of core level photoemission is
used to probe the transient response of different parts of the upper
electrode/ferroelectric interface to voltage pulse induced polarization
reversal. The linear response of the electronic structure agrees quantitatively
with a simple RC circuit model. The non-linear response due to the polarization
switch is demonstrated by the time-resolved response of the characteristic core
levels of the electrode and the ferroelectric. Adjustment of the RC circuit
model allows a first estimation of the Pt/BTO interface capacitance. The
experiment shows the interface capacitance is at least 100 times higher than
the bulk capacitance of the BTO film, in qualitative agreement with theoretical
predictions from the literature.Comment: 7 pages, 10 figures. Submitted to Phys. Rev.
Interface Electronic Structure in a Metal/Ferroelectric Heterostructure under Applied Bias
The effective barrier height between an electrode and a ferroelectric (FE)
depends on both macroscopic electrical properties and microscopic chemical and
electronic structure. The behavior of a prototypical electrode/FE/electrode
structure, Pt/BaTiO3/Nb-doped SrTiO3, under in-situ bias voltage is
investigated using X-Ray Photoelectron Spectroscopy. The full band alignment is
measured and is supported by transport measurements. Barrier heights depend on
interface chemistry and on the FE polarization. A differential response of the
core levels to applied bias as a function of the polarization state is
observed, consistent with Callen charge variations near the interface.Comment: 9 pages, 8 figures. Submitted to Phys. Rev.
- …