Gamma-Ray Bursts Observed with the Spectrometer SPI Onboard INTEGRAL

The spectrometer SPI is one of the main detectors of ESA's INTEGRAL mission. The instrument offers two interesting and valuable capabilities for the detection of the prompt emission of Gamma-ray bursts. Within a field of view of 16 degrees, SPI is able to localize Gamma-ray bursts with an accuracy of 10 arcmin. The large anticoincidence shield, ACS, consisting of 512 kg of BGO crystals, detects Gamma-ray bursts quasi omnidirectionally above ~70 keV. Burst alerts from SPI/ACS are distributed to the interested community via the INTEGRAL Burst Alert System. The ACS data have been implemented into the 3rd Interplanetary Network and have proven valuable for the localization of bursts using the triangulation method. During the first 8 months of the mission approximately one Gamma-ray burst per month was localized within the field of fiew of SPI and 145 Gamma-ray burst candidates were detected by the ACS from which 40 % have been confirmed by other instruments.Comment: 4 pages, 2 figures, to appear in the Proceedings of the Conference "30 Years of GRB Discovery", Santa Fe, New Mexico, USA, September 8-12, 200

Confined One Dimensional Harmonic Oscillator as a Two-Mode System

The one-dimensional harmonic oscillator in a box problem is possibly the simplest example of a two-mode system. This system has two exactly solvable limits, the harmonic oscillator and a particle in a (one-dimensional) box. Each of the two limits has a characteristic spectral structure describing the two different excitation modes of the system. Near each of these limits, one can use perturbation theory to achieve an accurate description of the eigenstates. Away from the exact limits, however, one has to carry out a matrix diagonalization because the basis-state mixing that occurs is typically too large to be reproduced in any other way. An alternative to casting the problem in terms of one or the other basis set consists of using an "oblique" basis that uses both sets. Through a study of this alternative in this one-dimensional problem, we are able to illustrate practical solutions and infer the applicability of the concept for more complex systems, such as in the study of complex nuclei where oblique-basis calculations have been successful. Keywords: one-dimensional harmonic oscillator, particle in a box, exactly solvable models, two-mode system, oblique basis states, perturbation theory, coherent states, adiabatic mixing.Comment: 11 pages and 9 figures; Submitted to American Journal of Physic

Nonlinear Oscillatory Dynamics of the Hardening of Calcium Phosphate Bone Cements

Here we report on the nonlinear, oscillatory dynamics detected in the evolution of phase composition during the setting of different calcium phosphate cements, two of which evolved toward brushite and one toward hydroxyapatite as the final product. Whereas both brushite-forming cements contained iondoped b-tricalcium phosphate as the initial phase, the zinc-containing one yielded scholzite as an additional phase during setting and the oscillations between these two products were pronounced throughout the entire 80 h setting period, long after the hardening processes was over from the mechanical standpoint. Oscillations in the copper-containing system involved the amount of brushite as the main product of the hardening reaction and they progressed faster toward an equilibrium point than in the zinc-containing system. Initially detected with the use of in situ energy-dispersive X-ray diffractometry, the oscillations were confirmed with a sufficient level of temporal matching in an in situ Fourier transform infrared spectroscopic analysis. The kinetic reaction analysis based on the Johnson– Mehl–Avrami–Kolmogorov model indicated an edge-controlled nucleation mechanism for brushite. The hydroxyapatite-forming cement comprised gelatin as an additional phase with a role of slowing down diffusion and allowing the detection of otherwise rapid oscillations in crystallinity and in the amount of the apatitic phase on the timescale of minutes. A number of possible causes for these dynamic instabilities were discussed. The classical chemical oscillatory model should not apply to these systems unless in combination with less exotic mechanisms of physicochemical nature. One possibility is that the variations in viscosity, directly affecting diffusion and nucleation rates and accompanying growth and transformation from the lower to the higher interfacial energy per the Ostwald–Lussac rule, are responsible for the oscillatory dynamics. The conception of bone replacement materials and tissue engineering constructs capable of engaging in the dynamics of integration with the natural tissues in compliance with this oscillatory nature may open a new avenue for the future of this type of medical devices. To succeed in this goal, the mechanism of these and similar instabilities must be better understood

Confined Jet Impingement with Boiling on a Variety of Enhanced Surfaces

Confined jet impingement with boiling offers unique and attractive performance characteristics for thermal management of high heat flux components. Two-phase operation of jet impingement has been shown to provide high heat transfer coefficients while maintaining a uniform temperature over a target surface. This can be achieved with minimal increases in pumping power compared to single-phase operation. To investigate further enhancements in heat transfer coefficients and increases in the maximum heat flux supported by two-phase jet impingement, an experimental study of surface enhancements is performed using the dielectric working fluid HFE-7100. The performance of a single, 3.75 mm-diameter jet orifice is compared across four distinct copper target surfaces of varying enhancement scales: a baseline smooth flat surface, a flat surface coated with a microporous layer, a surface with macroscale area enhancement (extended square pin fins), and a hybrid surface on which the pin fins are coated with the microporous layer. The heat transfer performance of each surface is compared in single- and two-phase operation at three volumetric flow rates (450 ml/min, 900 ml/min, and 1800 ml/min); area-averaged heat transfer parameters and pressure drop are reported. The mechanisms resulting in enhanced performance for the different surfaces are identified, with a special focus on the coated pin fins. This hybrid surface showed the best enhancement of all those tested, and resulted in an extension of critical heat flux (CHF) by a maximum of 2.42 times compared to the smooth flat surface at the lowest flow rate investigated; no increase in the overall pressure drop was measured

Pathway to a Compact SASE FEL Device

Newly developed high peak power lasers have opened the possibilities of driving coherent light sources operating with laser plasma accelerated beams and wave undulators. We speculate on the combination of these two concepts and show that the merging of the underlying technologies could lead to new and interesting possibilities to achieve truly compact, coherent radiator devices

Bond Orientational Order, Molecular Motion and Free Energy of High Density DNA Mesophases

By equilibrating condensed DNA arrays against reservoirs of known osmotic stress and examining them with several structural probes, it has been possible to achieve a detailed thermodynamic and structural characterization of the change between two distinct regions on the liquid crystalline phase digram: a higher-density hexagonally packed region with long-range bond orientational order in the plane perpendicular to the average molecular direction; and a lower-density cholesteric region with fluid-like positional order. X-rays scattering on highly ordered DNA arrays at high density and with the helical axis oriented parallel to the incoming beam showed a six-fold azimuthal modulation of the first order diffraction peak that reflects the macroscopic bond-orientational order. Transition to the less-dense cholesteric phase through osmotically controlled swelling shows the loss of this bond orientational order that had been expected from the change in optical birefringence patterns and that is consistent with a rapid onset of molecular positional disorder. This change in motion was previously inferred from intermolecular force measurements and is now confirmed by $\rm ^{31}P$ NMR. Controlled reversible swelling and compaction under osmotic stress, spanning a range of densities between $\sim 120$ mg/ml to $\sim 600$ mg/ml, allows measurement of the free energy changes throughout each phase and at the phase transition, essential information for theories of liquid-crystalline states.Comment: 14 pages, 3 figures in gif format available at http://abulafia.mgsl.dcrt.nih.gov/pics.html E-mail: [email protected]