998 research outputs found

    Theory and measure of certain image norms in SAR

    Get PDF
    The principal properties of synthetic aperture radar SAR imagery of point and distributed objects are summarized. Against this background, the response of a SAR (Synthetic Aperture Radar) to the moving surface of the sea is considered. Certain conclusions are drawn as to the mechanism of interaction between microwaves and the sea surface. Focus and speckle spectral tests may be used on selected SAR imagery for areas of the ocean. The fine structure of the sea imagery is sensitive to processor focus and adjustment. The ocean reflectivity mechanism must include point like scatterers of sufficient radar cross section to dominate the return from certain individual resolution elements. Both specular and diffuse scattering mechanisms are observed together, to varying degree. The effect is sea state dependent. Several experiments are proposed based on imaging theory that could assist in the investigation of reflectivity mechanisms

    An alternative multi-mode SAR for RADARSAT

    Get PDF
    The RADARSAT project was asked by the Canadian government in the spring of 1986 to design for reduced costs and increased radar performance as compared to the well-known baseline design. Both the Project Office and Canadian industry (lead by SPAR Aerospace of Montreal) have undertaken to meet this request, with a proposal to cabinet to be submitted in the fall of 1986. One alternative SAR concept is outlined which is under consideration for a revised RADARSAT configuration. The radar system described uses two frequencies (C&L band) over four possible modes: near range swath; far range swath; wide swath; and high resolution. Good sensitivity, resolution, and coverage are obtained with modest power and data rates. The antenna systems are relatively simple. Indeed, no break-through technological developments are needed. The design allows several mode combinations for simultaneous data collection or performance enhancement. The principal parameters are described. A nominal mean altitude of 700 km is assumed

    A solution to the problem of SAR range curvature

    Get PDF
    When synthetic aperture radar systems are pushed to attain finer resolution at larger ranges than was previously the case for remote sensing purposes, the geometric signal aberration known as range curvature arises. Known techniques for correcting range curvature are exact at only one selected range, thus forcing neighboring ranges to use the same correction as an approximation. A solution to the problem is proposed that is exact at all ranges, thus simplifying and improving the image processing for such systems

    Using Tablet Technology to Teach Secondary Content Vocabulary: A Collective Case Study

    Get PDF
    The purpose of this collective case study was to provide an understanding of the instructional methods of teachers who use tablet technology in middle school classrooms to teach complex content vocabulary. Dewey’s theory of constructivism guided this study, as it explains that students learn by building upon what they know. Middle school students add new terms to their existing vocabulary banks so that they can learn the related concepts in their content-area classes. The study took place in a southern state with technology standards that require students to use technology for reading and learning purposes. There is extensive research about vocabulary instruction and secondary content-area reading, but there is limited research about how middle school teachers use tablet technology for vocabulary instruction. Data gathered in this study were used to identify and describe the perceptions of technology, successes, and challenges of middle school content teachers using tablet technology in teaching vocabulary as well as the strategies and activities used to incorporate tablet technology in their vocabulary lessons. Data were collected through participants’ lesson plans, interviews, observations of teacher participants, focus groups, and memoing. Data were triangulated and analyzed to detect common themes that described middle school teachers’ perceptions of technology and their successes and challenges using the technology and to provide an understanding of the methods of instruction that the middle school teachers use to teach vocabulary with tablets. The study revealed that teachers use tablet technology to supplement the direct instruction of vocabulary and not as a replacement for teacher-to-student interaction

    Preliminary noise tradeoff study of a Mach 2.7 cruise aircraft

    Get PDF
    NASA computer codes in the areas of preliminary sizing and enroute performance, takeoff and landing performance, aircraft noise prediction, and economics were used in a preliminary noise tradeoff study for a Mach 2.7 design supersonic cruise concept. Aerodynamic configuration data were based on wind-tunnel model tests and related analyses. Aircraft structural characteristics and weight were based on advanced structural design methodologies, assuming conventional titanium technology. The most advanced noise prediction techniques available were used, and aircraft operating costs were estimated using accepted industry methods. The 4-engines cycles included in the study were based on assumed 1985 technology levels. Propulsion data was provided by aircraft manufacturers. Additional empirical data is needed to define both noise reduction features and other operating characteristics of all engine cycles under study. Data on VCE design parameters, coannular nozzle inverted flow noise reduction and advanced mechanical suppressors are urgently needed to reduce the present uncertainties in studies of this type

    A methodology for selective removal of orbital debris

    Get PDF
    Earth-orbiting objects, large enough to be tracked, were surveyed for possible systematic debris removal. Based upon the statistical collision studies of others, it was determined that objects in orbits approximately 1000 km above the Earth's surface are at greatest collisional risk. Russian C-1B boosters were identified as the most important target of opportunity for debris removal. Currently, more than 100 in tact boosters are orbiting the Earth with apogees between 950 km and 1050 km. Using data provided by Energia USA, specific information on the C-1B booster, in terms of rendezvous and capture strategies, was discussed

    Nonlinear viscoelasticity of freestanding and polymer-anchored vertically aligned carbon nanotube foams

    Get PDF
    Vertical arrays of carbon nanotubes (VACNTs) show unique mechanical behavior in compression, with a highly nonlinear response similar to that of open cell foams and the ability to recover large deformations. Here, we study the viscoelastic response of both freestanding VACNT arrays and sandwich structures composed of a VACNT array partially embedded between two layers of poly(dimethylsiloxane) (PDMS) and bucky paper. The VACNTs tested are ∼2 mm thick foams grown via an injection chemical vapor deposition method. Both freestanding and sandwich structures exhibit a time-dependent behavior under compression. A power-law function of time is used to describe the main features observed in creep and stress-relaxation tests. The power-law exponents show nonlinear viscoelastic behavior in which the rate of creep is dependent upon the stress level and the rate of stress relaxation is dependent upon the strain level. The results show a marginal effect of the thin PDMS/bucky paper layers on the viscoelastic responses. At high strain levels (ɛ = 0.8), the peak stress for the anchored CNTs reaches ∼45 MPa, whereas it is only ∼15 MPa for freestanding CNTs, suggesting a large effect of PDMS on the structural response of the sandwich structures

    Multiscale Mass-Spring Models of Carbon Nanotube Arrays Accounting for Mullins-like Behavior and Permanent Deformation

    Get PDF
    Based on a one-dimensional discrete system of bistable springs, a mechanical model is introduced to describe plasticity and damage in carbon nanotube (CNT) arrays. The energetics of the mechanical system are investigated analytically, the stress-strain law is derived, and the mechanical dissipation is computed, both for the discrete case as well as for the continuum limit. An information-passing approach is developed that permits the investigation of macroscopic portions of the material. As an application, the simulation of a cyclic compression experiment on real CNT foam is performed, considering both the material response during the primary loading path from the virgin state and the damaged response after preconditioning

    Joint Strong and Weak Lensing Analysis of the Massive Cluster Field J0850+3604

    Full text link
    We present a combined strong and weak lensing analysis of the J085007.6+360428 (J0850) field, which was selected by its high projected concentration of luminous red galaxies and contains the massive cluster Zwicky 1953. Using Subaru/Suprime-Cam BVRcIcizBVR_{c}I_{c}i^{\prime}z^{\prime} imaging and MMT/Hectospec spectroscopy, we first perform a weak lensing shear analysis to constrain the mass distribution in this field, including the cluster at z=0.3774z = 0.3774 and a smaller foreground halo at z=0.2713z = 0.2713. We then add a strong lensing constraint from a multiply-imaged galaxy in the imaging data with a photometric redshift of z5.03z \approx 5.03. Unlike previous cluster-scale lens analyses, our technique accounts for the full three-dimensional mass structure in the beam, including galaxies along the line of sight. In contrast with past cluster analyses that use only lensed image positions as constraints, we use the full surface brightness distribution of the images. This method predicts that the source galaxy crosses a lensing caustic such that one image is a highly-magnified "fold arc", which could be used to probe the source galaxy's structure at ultra-high spatial resolution (<30< 30 pc). We calculate the mass of the primary cluster to be Mvir=2.930.65+0.71×1015 M\mathrm{M_{vir}} = 2.93_{-0.65}^{+0.71} \times 10^{15}~\mathrm{M_{\odot}} with a concentration of cvir=3.460.59+0.70\mathrm{c_{vir}} = 3.46_{-0.59}^{+0.70}, consistent with the mass-concentration relation of massive clusters at a similar redshift. The large mass of this cluster makes J0850 an excellent field for leveraging lensing magnification to search for high-redshift galaxies, competitive with and complementary to that of well-studied clusters such as the HST Frontier Fields.Comment: Accepted for publication in The Astrophysical Journal; 14 pages, 13 figures, 3 table
    corecore