1,718 research outputs found
Reinforcement of polymeric structures with asbestos fibrils
Investigation determines structural potential of asbestos fibrils. Methods are developed for dispersing macrofibers of the asbestos into colloidal-sized ultimate fibrils and incorporating these fibrils in matrices without causing reagglomeration
The reinforcement of polymeric structures by asbestos fibrils Final report, 1 Apr. 1965 - 30 Apr. 1966
Dispersion techniques for asbestos fibril reinforcement of polymeric structures, and tensile strength data on reinforced composite
Exploratory studies of contact angle hysteresis, wetting of solidified rare gases and surface properties of mercury Final report
Contact angle hysteresis, wetting of solidified rare gases, and surface properties of mercur
The Impact of Multi-layered Data-blocks on Controller Performance
As a consequence of the push to increase National Airspace System capacity, air traffic control displays will not only have to show the increasing number of aircraft, but also all the associated data such as airspeed and altitude. The representation of aircraft data and associated relational information, often superimposed on a map, leads to cluttered displays, which could negatively affect controller performance, especially as aircraft numbers increase. To investigate these issues further, an experiment was conducted that examined the effect of increasing data-block lines on
controller performance in an aircraft vectoring task. Data-block design, the primary factor, varied in the number of lines displayed (2-5). In addition a data-block information priority factor was examined that addressed the frequency of information access across data-block lines. Results demonstrated that while task load, measured as an increasing number of planes under control, negatively influenced reaction times and task accuracy, the number of lines in a data block was not statistically significant. However there was a trend towards reduced performance when data-blocks exceeded more than three lines on a base layer. In addition, the data blocks that contained prioritized information across levels promoted faster reaction times, but at a cost of lower situation awareness. This research demonstrated that the design of data-blocks should consider the balance between reduction in data-block interaction time against the need to allow enough interaction time to build situation awareness.Civil Aerospace Medical Institut
Correlated Electrons Step-by-Step: Itinerant-to-Localized Transition of Fe Impurities in Free-Electron Metal Hosts
High-resolution photoemission spectroscopy and realistic ab-initio
calculations have been employed to analyze the onset and progression of d-sp
hybridization in Fe impurities deposited on alkali metal films. The interplay
between delocalization, mediated by the free-electron environment, and Coulomb
interaction among d-electrons gives rise to complex electronic configurations.
The multiplet structure of a single Fe atom evolves and gradually dissolves
into a quasiparticle peak near the Fermi level with increasing the host
electron density. The effective multi-orbital impurity problem within the exact
diagonalization scheme describes the whole range of hybridizations.Comment: 10 pages, 4 figure
Probing two topological surface bands of Sb2Te3 by spin-polarized photoemission spectroscopy
Using high resolution spin- and angle-resolved photoemission spectroscopy, we
map the electronic structure and spin texture of the surface states of the
topological insulator Sb2Te3. In combination with density functional
calculations (DFT), we directly show that Sb2Te3 exhibits a partially occupied,
single spin-Dirac cone around the Fermi energy, which is topologically
protected. DFT obtains a spin polarization of the occupied Dirac cone states of
80-90%, which is in reasonable agreement with the experimental data after
careful background subtraction. Furthermore, we observe a strongly spin-orbit
split surface band at lower energy. This state is found at 0.8eV below the
Fermi level at the gamma-point, disperses upwards, and disappears at about
0.4eV below the Fermi level into two different bulk bands. Along the gamma-K
direction, the band is located within a spin-orbit gap. According to an
argument given by Pendry and Gurman in 1975, such a gap must contain a surface
state, if it is located away from the high symmetry points of the Brillouin
zone. Thus, the novel spin-split state is protected by symmetry, too.Comment: 8 pages, 10 figure
Magnetism and interlayer coupling in fcc Fe/Co films
The magnetism of epitaxial fee Fe films deposited on Co(100) and sandwiched between two Co(100) films was investigated by x-ray magnetic circular dichroism. The dependence of the Fe magnetism on the film thickness is complex and qualitatively similar on Co(100) and in fee Co/Fe/Co(100) trilayers. The fee Fe film magnetization presents a pronounced oscillation, suggesting a partial antiferromagnetic ordering in the 5-10 monolayer thickness range. The fee Fe films mediate an oscillatory, indirect coupling in Co/Fe/Co(100) structures that alternates in correspondence with the changes of the Fe magnetization
Quantitative determination of spin-dependent quasiparticle lifetimes and electronic correlations in hcp cobalt
We report on a quantitative investigation of the spin-dependent quasiparticle
lifetimes and electron correlation effects in ferromagnetic hcp Co(0001) by
means of spin and angle-resolved photoemission spectroscopy. The experimental
spectra are compared in detail to state-of-the-art many-body calculations
within the dynamical mean field theory and the three-body scattering
approximation, including a full calculation of the one-step photoemission
process. From this comparison we conclude that although strong local many-body
Coulomb interactions are of major importance for the qualitative description of
correlation effects in Co, more sophisticated many-body calculations are needed
in order to improve the quantitative agreement between theory and experiment,
in particular concerning the linewidths. The quality of the overall agreement
obtained for Co indicates that the effect of non-local correlations becomes
weaker with increasing atomic number
Properties of continuous Fourier extension of the discrete cosine transform and its multidimensional generalization
A versatile method is described for the practical computation of the discrete
Fourier transforms (DFT) of a continuous function given by its values
at the points of a uniform grid generated by conjugacy classes
of elements of finite adjoint order in the fundamental region of
compact semisimple Lie groups. The present implementation of the method is for
the groups SU(2), when is reduced to a one-dimensional segment, and for
in multidimensional cases. This simplest case
turns out to result in a transform known as discrete cosine transform (DCT),
which is often considered to be simply a specific type of the standard DFT.
Here we show that the DCT is very different from the standard DFT when the
properties of the continuous extensions of these two discrete transforms from
the discrete grid points to all points are
considered. (A) Unlike the continuous extension of the DFT, the continuous
extension of (the inverse) DCT, called CEDCT, closely approximates
between the grid points . (B) For increasing , the derivative of CEDCT
converges to the derivative of . And (C), for CEDCT the principle of
locality is valid. Finally, we use the continuous extension of 2-dimensional
DCT to illustrate its potential for interpolation, as well as for the data
compression of 2D images.Comment: submitted to JMP on April 3, 2003; still waiting for the referee's
Repor
- …