3,111 research outputs found
Correlation measurements in high-multiplicity events
Requirements for correlation measurements in high--multiplicity events are
discussed. Attention is focussed on detection of so--called hot spots,
two--particle rapidity correlations, two--particle momentum correlations (for
quantum interferometry) and higher--order correlations. The signal--to--noise
ratio may become large in the high--multiplicity limit, allowing meaningful
single--event measurements, only if the correlations are due to collective
behavior.Comment: MN 55455, 20 pages, KSUCNR-011-92 and TPI-MINN-92/47-T (revised).
Revised to correct typo in equation (30), and to fill in a few steps in
calculations. Now published as Phys. Rev. C 47 (1993) 232
European retrievable carrier (Eureca) and evolutionary space carrier for microgravity, Earth observation and technology demonstration
The Spacelab relatively short stay-time in orbit has led to consideration of the European Retrievable Carrier (EURECA) concept as a reusable carrier. The EURECA concept is a free-flying carrier of experiments which is launched and recovered by the space shuttle. It is commensurate with the size of payloads that can be economically developed in Europe and combines the advantages of Spacelab (high mass and power capability, recovery) with those of a free flyer (extended operating time in a non-polluted environment). The launch of the first EURECA mission is scheduled for October 1987. The Eureca spacecraft will be deployed from the Shuttle cargo bay in orbit, will operate in a free-flying mode for about six months, and will then be retrieved, together with its payloads, returned to Earth by the Space Shuttle and prepared for the next mission. The first mission of EURECA is dedicated to research in the fields of life sciences and material sciences. The experimental hardware of the first mission consist of a variety of processin chambers for crystal growth and equipment for biological investigations viz plant growth and protein crystallization, and there is the possibility to perform experiments in the field of exobiology
The Starburst Nature of Lyman-Break Galaxies: Testing UV Extinction with X-rays
We derive the bolometric to X-ray correlation for a local sample of normal
and starburst galaxies and use it, in combination with several UV reddening
schemes, to predict the 2--8 keV X-ray luminosity for a sample of 24
Lyman-break galaxies in the HDF/CDF-N. We find that the mean X-ray luminosity,
as predicted from the Meurer UV reddening relation for starburst galaxies,
agrees extremely well with the Brandt stacking analysis. This provides
additional evidence that Lyman-break galaxies can be considered as scaled-up
local starbursts and that the locally derived starburst UV reddening relation
may be a reasonable tool for estimating the UV extinction at high redshift. Our
analysis shows that the Lyman-break sample can not have far-IR to far-UV flux
ratios similar to nearby ULIGs, as this would predict a mean X-ray luminosity
100 times larger than observed, as well as far-IR luminosities large enough to
be detected in the sub-mm. We calculate the UV reddening expected from the
Calzetti effective starburst attenuation curve and the radiative transfer
models of Witt & Gordon for low metallicity dust in a shell geometry with
homogeneous or clumpy dust distributions and find that all are consistent with
the observed X-ray emission. Finally, we show that the mean X-ray luminosity of
the sample would be under predicted by a factor of 6 if the the far-UV is
unattenuated by dust.Comment: 7 pages, 3 figures. Accepted for publication in A
On the calculation of the topographic wetness index: evaluation of different methods based on field observations
The topographic wetness index (TWI, ln(<i>a</i>/tan<I>β</I>)), which combines local upslope contributing area and slope, is commonly used to quantify topographic control on hydrological processes. Methods of computing this index differ primarily in the way the upslope contributing area is calculated. In this study we compared a number of calculation methods for TWI and evaluated them in terms of their correlation with the following measured variables: vascular plant species richness, soil pH, groundwater level, soil moisture, and a constructed wetness degree. The TWI was calculated by varying six parameters affecting the distribution of accumulated area among downslope cells and by varying the way the slope was calculated. All possible combinations of these parameters were calculated for two separate boreal forest sites in northern Sweden. We did not find a calculation method that performed best for all measured variables; rather the best methods seemed to be variable and site specific. However, we were able to identify some general characteristics of the best methods for different groups of measured variables. The results provide guiding principles for choosing the best method for estimating species richness, soil pH, groundwater level, and soil moisture by the TWI derived from digital elevation models
- …