37,367 research outputs found
A range expanding signal conditioner
Telemetry system modifications to improve signal resolution are described. Process uses zero suppression technique which consists of subtracting known voltage from input and amplifying remainder. Schematic diagram of circuit is provided and details of operation are presented
Comparison of visualized turbine endwall secondary flows and measured heat transfer patterns
Various flow visualization techniques were used to define the secondary flows near the endwall in a large heat transfer data. A comparison of the visualized flow patterns and the measured Stanton number distribution was made for cases where the inlet Reynolds number and exit Mach number were matched. Flows were visualized by using neutrally buoyant helium-filled soap bubbles, by using smoke from oil soaked cigars, and by a few techniques using permanent marker pen ink dots and synthetic wintergreen oil. Details of the horseshoe vortex and secondary flows can be directly compared with heat transfer distribution. Near the cascade entrance there is an obvious correlation between the two sets of data, but well into the passage the effect of secondary flow is not as obvious
Streakline flow visualization of discrete-hole film cooling with normal, slanted, and compound angle injection
Film injection from discrete holes in a three-row, staggered array with five-diameter spacing was studied for three hole angles: (1) normal, (2) slanted 30 deg to the surface in the direction of the main stream, and (3) slanted 30 deg to the surface and 45 deg laterally to the main stream. The ratio of the boundary layer thickness-to-hole diameter and Reynolds number were typical of gas-turbine film-cooling applications. Detailed streaklines showing the turbulent motion of the injected air were obtained by photographing very small neutrally buoyant, helium-filled soap bubbles which follow the flow field
Flow visualization of discrete hole film cooling for gas turbine applications
Film injection from discrete holes in a three row staggered array with 5-diameter spacing is studied. The boundary layer thickness-to-hole diameter ratio and Reynolds number are typical of gas turbine film cooling applications. Two different injection locations are studied to evaluate the effect of boundary layer thickness on film penetration and mixing. Detailed streaklines showing the turbulent motion of the injected air are obtained by photographing neutrally buoyant helium filled soap bubbles which follow the flow field. The bubble streaklines passing downstream injection locations are clearly identifiable and can be traced back to their origin. Visualization of surface temperature patterns obtained from infrared photographs of a similar film cooled surface are also included
Can U.S. oil production survive the 20th century?
The plunge in world oil prices has brought further difficulties to U.S. oil production, which has been declining in recent years. At the current low prices, most domestic oil wells are not profitable. This calls into question the long-run viability of oil production in the United States. Whether oil production remains a viable part of the U.S. economy in the next century will depend on how long oil prices remain at their current low levels.> Lamb and Wilkerson show how the recent low prices for oil on world markets reflect a combination of demand and supply effects, with both short-run and long-run forces at work. For example, sluggish demand growth reflects both milder weather in some parts of the world (a short-run phenomenon) and the impacts of the Asian financial crisis, which could persist for some time. Meanwhile, supply has mushroomed, in part due to the short-run effect of Iraq's return to higher levels of oil production. In the main, however, the increase in supply reflects sharp declines in the cost of discovering and extracting oil reserves. On balance, the current low prices appear to be mainly the result of longer run demand and supply forces, suggesting that prices are likely to remain low for some time to come. If world oil prices do remain low, U.S. oil is unlikely to be competitive in world markets. Therefore, the domestic oil sector is likely to continue to lose market share for the foreseeable future.Petroleum industry and trade ; Prices
Flow visualization study of the horseshoe vortex in a turbine stator cascade
Flow visualization techniques were used to show the behavior of the horseshoe vortex in a large scale turbine stator cascade. Oil drops on the end wall surface flowed in response to local shear stresses, indicating the limiting flow streamlines at the surface. Smoke injected into the flow and photographed showed time averaged flow behavior. Neutrally bouyant helium filled soap bubbles followed the flow and showed up on photographs as streaks, indicating the paths followed by individual fluid particles. Preliminary attempts to control the vortex were made by injecting air through control jets drilled in the end wall near the vane leading edge. Seventeen different hole locations were tested, one at a time, and the effect of the control jets on the path follwed by smoke in the boundary layer was recorded photographically
Sinuosity and the affect grid: A method for adjusting repeated mood scores
Copyright @ 2012 Ammons Scientific. The article can be accessed from the links below.This article has been made available through the Brunel Open Access Publishing Fund.Sinuosity is a measure of how much a travelled pathway deviates from a straight line. In this paper, sinuosity is applied to the measurement of mood. The Affect Grid is a mood scale that requires participants to place a mark on a 9 x 9 grid to indicate their current mood. The grid has two dimensions: pleasure-displeasure (horizontal) and arousal-sleepiness (vertical). In studies where repeated measurements are required, some participants may exaggerate their mood shifts due to faulty interpretation of the scale or a feeling of social obligation to the experimenter. A new equation is proposed, based on the sinuosity measure in hydrology, a measure of the meandering of rivers. The equation takes into account an individual's presumed tendency to exaggerate and meander to correct the score and reduce outliers. The usefulness of the equation is demonstrated by applying it to Affect Grid data from another study.This article is made available through the Brunel Open Access Publishing Fund
An excess of damped Lyman alpha galaxies near QSOs
We present a sample of 33 damped Lyman alpha systems (DLAs) discovered in the
Sloan Digital Sky Survey (SDSS) whose absorption redshifts (z_abs) are within
6000 km/s of the QSO's systemic redshift (z_sys). Our sample is based on 731
2.5 < z_sys < 4.5 non-broad-absorption-line (non-BAL) QSOs from Data Release 3
(DR3) of the SDSS. We estimate that our search is ~100 % complete for absorbers
with N(HI) >= 2e20 cm^-2. The derived number density of DLAs per unit redshift,
n(z), within v < 6000 km/s is higher (3.5 sigma significance) by almost a
factor of 2 than that of intervening absorbers observed in the SDSS DR3, i.e.
there is evidence for an overdensity of galaxies near the QSOs. This provides a
physical motivation for excluding DLAs at small velocity separations in surveys
of intervening 'field' DLAs. In addition, we find that the overdensity of
proximate DLAs is independent of the radio-loudness of the QSO, consistent with
the environments of radio-loud and radio-quiet QSOs being similar.Comment: Accepted for publication in MNRAS (13 pages, 6 figures
Streakline flow visualization of discrete hole film cooling with holes inclined 30 deg to surface
Film injection from three rows of discrete holes angled 30 deg to the surface in line with mainstream flow and spaced 5 diameters apart in a staggered array was visualized by using helium bubbles as tracer particles. Both the main stream and the film injectant were ambient air. Detailed streaklines showing the turbulent motion of the film mixing with the main stream were obtained by photographing small, neutrally buoyant helium-filled soap bubbles which followed the flow field. The ratio of boundary layer thickness to hole diameter and the Reynolds number were typical of gas turbine film cooling applications. The results showed the behavior of the film and its interaction with the main stream for a range of blowing rates and two initial boundary layer thicknesses
- …