Thin film temperature sensor

Thin film surface temperature sensors were developed. The sensors were made of platinum-platinum/10 percent rhodium thermocouples with associated thin film-to-lead wire connections and sputtered on aluminum oxide coated simulated turbine blades for testing. Tests included exposure to vibration, low velocity hydrocarbon hot gas flow to 1250 K, and furnace calibrations. Thermal electromotive force was typically two percent below standard type S thermocouples. Mean time to failure was 42 hours at a hot gas flow temperature of 1250 K and an average of 15 cycles to room temperature. Failures were mainly due to separation of the platinum thin film from the aluminum oxide surface. Several techniques to improve the adhesion of the platinum are discussed

Adaptive Bayesian decision feedback equalizer for dispersive mobile radio channels

The paper investigates adaptive equalization of time dispersive mobile ratio fading channels and develops a robust high performance Bayesian decision feedback equalizer (DFE). The characteristics and implementation aspects of this Bayesian DFE are analyzed, and its performance is compared with those of the conventional symbol or fractional spaced DFE and the maximum likelihood sequence estimator (MLSE). In terms of computational complexity, the adaptive Bayesian DFE is slightly more complex than the conventional DFE but is much simpler than the adaptive MLSE. In terms of error rate in symbol detection, the adaptive Bayesian DFE outperforms the conventional DFE dramatically. Moreover, for severely fading multipath channels, the adaptive MLSE exhibits significant degradation from the theoretical optimal performance and becomes inferior to the adaptive Bayesian DFE

From bench to bedside: Tracing the payback forwards from basic or early clinical research – A preliminary exercise and proposals for a future study

EXECUTIVE SUMMARY Chapter 1 : Introduction • The members of the research team from HERG and the Wellcome Trust have conducted previous studies showing that it is possible both to assess the payback from applied health research, and to use bibliometrics to trace the links between generations of research and clinical guidelines. In another of the team’s studies, however, it proved difficult to replicate the major study by Comroe and Dripps (1976) that had identified clinical advances and then worked backwards to show that they had relied on earlier basic research. Therefore, the study reported here sets out to use the methods developed in our previous studies of payback to undertake analysis that starts with more basic or early clinical research and traces the research lines forwards to clinical applications. Whilst this preliminary study involved preparation for a future large-scale study, it was hoped that it would also provide an interesting case study. • Starting with the research outputs of one team 20 years ago, called the 1st generation papers, the preliminary study has three main elements: standard bibliometric analysis through several generations of papers; categorisation of the citations; and qualitative analysis using questionnaires, critical pathway analysis and interviews to trace the impact of the 1st generation of research. • Diabetes and cardiology were suggested as possible topics on which to base the study. Initial reviews identified two bodies of research in diabetes as being potentially suitable for reasons such as the continuing activity of key members of the team. • The research into diabetes conducted in 1981 by George Alberti and his team at Newcastle, and collaborators elsewhere, was selected to provide the case study for this preliminary stage for several reasons. It was thought to have been important science and there was a belief that some of it had made a contribution to clinical practice. Chapter 2 : Bibliometric analysis • An original plan to look at publications produced over a three year period was changed to looking at the output of just one year, 1981, because in that year alone Alberti and colleagues published 29 articles. These form the 1st generation papers and the average number of citations they received is high. Identifying the citations given to these 29 papers resulted in 799 2nd generation papers and 12,891 3rd generation papers. The numbers involved meant that it was impractical to go beyond the 3rd generation. Within the high overall average, the variation in the number of citations per paper was iii considerable going from 76 to just one. Similarly, the half-lives of the 29 papers, ie the time taken for an article to receive 50% of its citations, ranged from two years to 11. • Articles can be given a Research Level (ie one of four levels from clinical observation to basic) based on the journals in which they appear. Such analysis demonstrates the breadth of Alberti’s work because the 29 articles are spread across all four Research Levels. Crucially, there was not a shift from basic to more clinical levels across the generations. The higher than average number of authors and addresses per paper is testimony to Alberti’s extensive collaborations. • The funding acknowledgements reveal the high proportion of papers supported, at least partially, by one funder: the British Diabetic Association, now Diabetes UK, which provided core support for Alberti’s Newcastle team. Chapter 3 : Categorisation of citations • Traditional citation analysis does not allow identification of the importance of the cited article to the citing article, and therefore limits the ability to use citation analysis to trace the impact of basic or early research on later research. We conducted a review of the literature of the meaning of citations. • From this review, a template was devised that allowed the location, nature and importance of citations to be recorded as well as the type of research (basic or clinical) described in the paper. This was used by six assessors on a sample of papers and inter-rater reliability was tested. Further work is required to refine the template and its definitions, and to improve its consistency in application. • Nevertheless, for initial analysis, it was applied to 623 out of the 799 2nd generation papers. A four point scale was used for the importance of the cited paper to the citing paper. In just 9% of cases was the cited 1st generation paper thought to be in one of the top two categories, ie of Considerable or Essential importance to the citing paper. • Statistical analysis revealed no relationship between the number of citations a paper received and the proportion of citations where the cited paper was classified as being of high (ie. Considerable or Essential) importance to the citing paper. Self-citations, however, were shown to be significantly more likely to be in this category. • The classification of the type of research (basic or clinical) by our analysis of each paper broadly agreed with the classification of the journals by Research Level. • The time constraints involved in applying the template, plus the lack of any overall pattern in terms of correlations between number and importance of citations, might point to the desirability of adopting a more selective approach, guided by qualitative analysis. In any selective approach, however, it is likely that self-citations should feature. iv Chapter 4 : Qualitative analysis • Given the number of co-authors, it seemed appropriate to send them a questionnaire rather than attempt to interview them. Therefore the interviewing was rather more concentrated than originally intended. Only one formal critical pathway was created, but it was undertaken by an expert in the field who worked with Alberti at Newcastle. • Some problems emerged in taking 1981 as the starting point for the study. Alberti identified 10 selected papers from the 1970s and 1980s that he felt had had most impact on clinical practice. These helped to give us both a better understanding of the payback from our 1st generation, or 1981, papers, and provided further material for analysis. • Attempting to describe the impact from the 1981 body of work, and from the 10 selected papers, underlines the complex reality of how science advances and influences clinical practice. If they make a contribution at all, most studies make a small, incremental one. • A few papers, however, have been shown to have a considerably greater impact. A possible key to the level of payback indicated is the enormous breadth of Alberti’s contacts, and fields and methods of working, to which various references were made. This is well illustrated in the account of how the idea for subcutaneous pumps came about. Similarly, the ability to produce the very important guidelines on treating diabetics during surgery, and diabetic coma, partly resulted from the application to clinical problems of the understandings gained from some of the basic/early clinical studies. It is significant that the key papers on these issues, all of which come from the list of 10 selected papers from the 1970s and 1980s, were having an impact on the 1981 work. • How far the collection of papers from 1981 have been drawn upon in similar ways is less clear. Nevertheless, papers on treating diabetics during open heart surgery, and on bolus delivery of insulin at meal times, were key parts of these wider streams, despite variable citation levels. Furthermore, various papers, including on acarbose, on portal infusion of insulin, and on semi-human insulin, were important steps in bodies of work in their respective areas. The complexity was illustrated by a paper that helped debunk the Chlorpropamide alcohol flushing hypothesis, and thus end a line of scientific enquiry: there was payback in stopping an incorrect line of inquiry, but nothing on which to build. • Each technique in the qualitative study produced information about the successful subsequent careers followed by many researchers trained through working with Alberti. • Historical perspectives, and insider expert opinions, were important in the qualitative analysis. Overall, the qualitative methods highlighted some limitations in the bibliometric approach but also showed how aspects of the citation analysis can complement the opinions expressed, for example about the importance of the breadth of Alberti’s work. v Chapter 5 : Lessons learnt and the way forward • Lessons learnt: a variety of methods can be used successfully to gather considerable data about the payback from a body of research undertaken 20 years ago. Traditional citation analysis alone, however, is not sufficient: the importance of the surgery papers despite their relatively low citation rates illustrates this. The qualitative methods are important and much of the analysis is strengthened by drawing on multiple approaches. Several problems remain, including: identifying a coherent starting point for the analysis; coping with the enormous number of papers involved in later generations; and refining the template for categorising citations and developing ways of fully utilising the results from applying it. • Preparing for the large-scale study: this preliminary study provides a basis on which to attempt to undertake the larger study we envisaged. Issues now being addressed include identification of the level of bibliometric/citation analysis necessary to complement any qualitative studies. To provide confidence in the findings from an eventual large-scale study, we will need to expand the focus. The study will need to cover at least four sets of case studies. Ideally, each set should focus on a number of research groups working in a country in the same field. We hope there will be sets of case studies in two or three fields and in at least two countries. The issues to be explored will include ones highlighted by this study such as breadth of work, level of collaboration, and the role of core funding. • Methods for the large-scale study: for each case study we now propose to employ two methodological elements based on the qualitative and quantitative techniques adopted in the preliminary study. They will work in parallel but the quantitative bibliometric analysis would be applied selectively to parts of ‘research lines’ (ie discrete themes of research) identified in the qualitative studies as being important in influencing clinical practice. • Presenting the findings: each research line could be written-up in a standardised document that would use the HERG payback model and categories to describe the impact of that research. We shall use the qualitative and quantitative data to compare and contrast the ‘payback’ of research lines by country and disease, and then identify common factors that correlate with the translation of basic or early clinical research. • Concluding comments: in the era of ‘evidence based policy’, research funders are looking for value for money in the research they support and for evidence on the effectiveness of different research strategies. In this study we have begun developing a methodology that will allow us to understand the complexity of research development over a series of generations. The utility of the policy research we propose here will only be realised when it is scaled up to cover a number of different fields in different settings.NHS Executive, London Regio

Neonatal weight loss in breast and formula-fed infants

We have observed an increase in the number of breast fed babies presenting with dehydration and/or failure to thrive because of lactation failure and non-recognition of feeding problems. Recent reports1,2 support this experience and recommend monitoring of the weight of infants through the neonatal period. However, these reports acknowledge uncertainty as to what actually constitutes normal neonatal weight loss. Maisels and colleagues published two studies which have been quoted as giving guidance on normal loss. Both studies were designed primarily to study factors that influence breast milk jaundice. The first3 reported a mean weight loss of about 6% in 100 unselected well babies during the first 3 days. The subsequent study4 reported a mean weight loss of 6.86% in 186 infants. The timescale over which babies were weighed was not clearly indicated, although it may have only been 2-3 days. The sample was neither population based nor randomly selected, being largely preselected because of the presence of more pronounced jaundice. The distribution of data points for early neonatal weight loss are likely to be skewed, yet both studies reported the results as mean (SD). Owing to the design and method of data presentation, these studies cannot reliably inform the debate as to what constitutes the norm. Marchini and colleagues published reports also designed primarily to study other issues. One5 indicated a mean early weight loss of 5.7%. Measurements were recorded over a three day period, and no indication is given of the skewness of the data. Another study6 reported a median weight loss of about 6% recorded over a four day period. At least one baby lost > 15% of his/her birth weight during this time, but there is no clear information as to the frequency with which more extreme degrees of weight loss are observed

The development of a high temperature static strain gage system

The objective of this program is to develop electrical resistance strain gages which will permit the measurement of static strains on nickel and cobalt superalloy parts inside gas turbine engines running on a test stand. The specific goal is to develop a complete system able to make strain measurements up to plus or minus 2000 mu strain with a total error of no more than plus or minus 10 percent over a 50 hour period at 1250 K. The initial part of this work consisted of a strain gage alloy development effort in which a variety of alloys were evaluated after being prepared by drop-casting or splat cooling

Turbine Blade Temperature Measurements Using Thin Film Temperature Sensors

The development of thin film temperature sensors is discussed. The technology for sputtering 2 micron thin film platinum versus platinum 10 percent rhodium thermocouples on alumina forming coatings was improved and extended to applications on actual turbine blades. Good adherence was found to depend upon achieving a proper morphology of the alumina surface. Problems of adapting fabrication procedures to turbine blades were uncovered, and improvements were recommended. Testing at 1250 K at one atmosphere pressure was then extended to a higher Mach No. (0.5) in combustor flow for 60 hours and 71 thermal cycles. The mean time to failure was 47 hours accumulated during 1 hour exposures in the combustor. Calibration drift was about 0.1 percent per hour, attributable to oxidation of the rhodium in the thin films. An increase in film thickness and application of a protective overcoat are recommended to reduce drift in actual engine testing

High temperature static strain gage development contract, tasks 1 and 2

Results are presented for the first two tasks to develop resistive strain gage systems for use up to 1250 K on blades and vanes in gas turbine engines under tests. The objective of these two tasks was to further improve and evaluate two static strain gage alloys identified as candidates in a previous program. Improved compositions were not found for either alloy. Further efforts on the Fe-11.9Al-10.6Cr weigth percent alloy were discontinued because of time dependent drift problems at 1250 K in air. When produced as a 6.5 micrometer thick sputtered film, the Pd-13Cr weight percent alloys is not sufficiently stable for this use in air at 1250 K and a protective overcoat system will need to be developed

Using ACIS on the Chandra X-ray Observatory as a particle radiation monitor II

The Advanced CCD Imaging Spectrometer is an instrument on the Chandra X-ray Observatory. CCDs are vulnerable to radiation damage, particularly by soft protons in the radiation belts and solar storms. The Chandra team has implemented procedures to protect ACIS during high-radiation events including autonomous protection triggered by an on-board radiation monitor. Elevated temperatures have reduced the effectiveness of the on-board monitor. The ACIS team has developed an algorithm which uses data from the CCDs themselves to detect periods of high radiation and a flight software patch to apply this algorithm is currently active on-board the instrument. In this paper, we explore the ACIS response to particle radiation through comparisons to a number of external measures of the radiation environment. We hope to better understand the efficiency of the algorithm as a function of the flux and spectrum of the particles and the time-profile of the radiation event.Comment: 10 pages, 5 figures, to be published in Proc. SPIE 8443, "Space Telescopes and Instrumentation 2012: Ultraviolet to Gamma Ray