119 research outputs found

    Oil seal effects and subsynchronous vibrations in high-speed compressors

    Get PDF
    Oil seals are commonly used in high speed multistage compressors. If the oil seal ring becomes locked up against the fixed portion of the seal, high oil film crosscoupled stiffnesses can result. A method of analysis for determining if the oil seals are locked up or not is discussed. The method is then applied to an oil seal in a compressor with subsynchronous vibration problems

    Aerodynamic stiffness of an unbound eccentric whirling centrifugal impeller with an infinite number of blades

    Get PDF
    An unbounded eccentric centrifugal impeller with an infinite number of log spiral blades undergoing synchronous whirling in an incompressible fluid is considered. The forces acting on it due to coriolis forces, centripetal forces, changes in linear momentum, changes in pressure due to rotating and changes in pressure due to changes in linear momentum are evaluated

    Chua's Circuit in Spread Spectrum Communication Systems

    Get PDF
    Communication system via chaotic modulations is demonstrated. It contains the well-known chaotic circuits as its basic elements - Chua's circuits. The proposed system has some standard properties of spread spectrum communication. The following advantage is found in simulations: a) Transmitted signals have broad spectra. b) Secure communications are possible in the sense that the better parameter matching is required in order to recover the signal. c) The circuit structure of the communication system is most simple and communication systems are easily built at a small outlay. Finally computer simulations are given to examine the validity of this system

    Effects of Spreading Sequences on the Performance of MC-CDMA System with Nonlinear Models of HPA

    Get PDF
    Performance evaluation and comparison of multi-carrier code division multiple access (MC-CDMA) system model for different spreading sequences at the presence of Saleh and Rapp model of high power amplifier (HPA) is investigated. Nonlinear amplification introduces degradation of bit error performance and destroys the orthogonality among subcarriers. In order to avoid performance degradation without requiring extremely large backoffs in the transmitter amplifier, it becomes convenient to use nonlinear multi-user detection techniques at the receiver side. In order to illustrate this fact, microstatistic multi-user receiver (MSF-MUD) and conventional minimum mean square error receiver (MMSE-MUD) are considered and mutually compared. The results of our analyses based on computer simulations will show very clearly, that the application of nonlinear MSF-MUD in combination with Golay codes can provide significantly better results than the other tested spreading codes and receivers. Besides this fact, a failure of Walsh codes especially at the Saleh model of HPA will be outlined by using constellation diagram

    Retrofit Of Gas Lubricated Face Seals In A Centrifugal Compressor.

    Get PDF
    LecturePg. 75-84There are significant advantages in using gas lubricated face seals (dry gas seals) in centrifugal compressor service. Foremost among these are the elimination of the seal oil system resulting in lower maintenance, increased safety, and higher operating availability. For these reasons, one of four identical compressors at an installation having severe problems with seal oil contamination was selected for trial conversion to dry gas seals. The rotordynamic engineering portion of this job was done by the compressor manufacturer in conjunction with the gas seal supplier. The seal assembly was designed so that it would be essentially a drop-in conversion from a mechanical standpoint. Rotordynamic studies indicated that the conversion would result in a "better" machine. Unfortunately, sustained operations were not possible, due to excessive vibration levels at startup with the new seals. The shaft vibration exceeded 0.007 in, peak-to-peak, at a subsynchronous frequency of 4900 rpm (the machine rated speed is in excess of 10,000 rpm). These levels were sufficiently high to cause extensive damage to all internal labyrinths. The midspan labyrinths were wiped open in excess of 0.060 in, radial. Analysis of tape recorded data indicated that the vibration was due to a rotor/bearing system dynamic instability. Additional computer simulations of the compressor rotordynamics revealed that the oil seals had provided sufficient damping to the system to bound the instability. This extra damping was not being provided by the gas seals. Bearing redesign to increase stability and realignment of the rotor within the bundle to remove suspected excitation appear to have eliminated the problem

    Case Study 08: Torsional Oscillation Trouble on VFD Motor Driven Recip Compressor

    Get PDF
    Case StudyHigh vibration problems including failed coupling parts on a VFD motor driven reciprocating compressor are analyzed and the root causes and solutions are discussed in this costly field issue

    Paying for parking : improving stated-preference surveys

    Get PDF
    This article describes an experiment which introduced random ranges into the variables used for the design of a stated preference survey and its effects on willingness to pay for parking. User behaviour at the time of parking was modelled to determine their willingness to pay in order to get to their final destination more quickly. Calculating willingness to pay is fundamental during the social and economic assessment of projects. It is important to correctly model how car parks and their users interact in order to get values which represent reality as closely as possible. Willingness to pay is calculated using a stated preference survey and by calibrating multinomial logit models, taking variable tastes into account. It is shown that a value with a low variability can be obtained for willingness to pay by correctly establishing the context of the choice and randomly changing the variables around an average value
    corecore