Chemistry of new particle growth in mixed urban and biogenic emissions - Insights from CARES

Regional new particle formation and growth events (NPEs) were observed on most days over the Sacramento and western Sierra foothills area of California in June 2010 during the Carbonaceous Aerosols and Radiative Effect Study (CARES). Simultaneous particle measurements at both the T0 (Sacramento, urban site) and the T1 (Cool, rural site located ~40 km northeast of Sacramento) sites of CARES indicate that the NPEs usually occurred in the morning with the appearance of an ultrafine mode at ~15 nm (in mobility diameter, Dm, measured by a mobility particle size spectrometer operating in the range 10-858 nm) followed by the growth of this modal diameter to ~50 nm in the afternoon. These events were generally associated with southwesterly winds bringing urban plumes from Sacramento to the T1 site. The growth rate was on average higher at T0 (7.1 ± 2.7 nm h−1) than at T1 (6.2 ± 2.5 nm h−1), likely due to stronger anthropogenic influences at T0. Using a high-resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS), we investigated the evolution of the size-resolved chemical composition of new particles at T1. Our results indicate that the growth of new particles was driven primarily by the condensation of oxygenated organic species and, to a lesser extent, ammonium sulfate. New particles appear to be fully neutralized during growth, consistent with high NH3 concentration in the region. Nitrogen-containing organic ions (i.e., CHN+, CH4N+, C2H3N+, and C2H4N+) that are indicative of the presence of alkyl-amine species in submicrometer particles enhanced significantly during the NPE days, suggesting that amines might have played a role in these events. Our results also indicate that the bulk composition of the ultrafine mode organics during NPEs was very similar to that of anthropogenically influenced secondary organic aerosol (SOA) observed in transported urban plumes. In addition, the concentrations of species representative of urban emissions (e.g., black carbon, CO, NOx, and toluene) were significantly higher whereas the photo-oxidation products of biogenic VOCs (volatile organic compounds) and the biogenically influenced SOA also increased moderately during the NPE days compared to the non-event days. These results indicate that the frequently occurring NPEs over the Sacramento and Sierra Nevada regions were mainly driven by urban plumes from Sacramento and the San Francisco Bay Area, and that the interaction of regional biogenic emissions with the urban plumes has enhanced the new particle growth. This finding has important implications for quantifying the climate impacts of NPEs on global scale

Implementation of a Markov Chain Monte Carlo method to inorganic aerosol modeling of observations from the MCMA-2003 campaign ? Part I: Model description and application to the La Merced site

International audienceThe equilibrium inorganic aerosol model ISORROPIA was embedded in a Markov Chain Monte Carlo algorithm to develop a powerful tool to analyze aerosol data and predict gas phase concentrations where these are unavailable. The method directly incorporates measurement uncertainty, prior knowledge, and provides a formal framework to combine measurements of different quality. The method was applied to particle- and gas-phase precursor observations taken at La Merced during the Mexico City Metropolitan Area (MCMA) 2003 Field Campaign and served to discriminate between diverging gas-phase observations of ammonia and predict gas-phase concentrations of hydrochloric acid. The model reproduced observations of particle-phase ammonium, nitrate, and sulfate well. The most likely concentrations of ammonia were found to vary between 4 and 26 ppbv, while the range for nitric acid was 0.1 to 55 ppbv. During periods where the aerosol chloride observations were consistently above the detection limit, the model was able to reproduce the aerosol chloride observations well and predicted the most likely gas-phase hydrochloric acid concentration varied between 0.4 and 5 ppbv. Despite the high ammonia concentrations observed and predicted by the model, when the aerosols were assumed to be in the efflorescence branch they are predicted to be acidic (pH~3)

Characterization of submicron particles influenced by mixed biogenic and anthropogenic emissions using high-resolution aerosol mass spectrometry: Results from CARES

An Aerodyne high resolution time-of-flight aerosol mass spectrometer (HR-ToF-AMS) was deployed during the Carbonaceous Aerosols and Radiative Effects Study (CARES) that took place in northern California in June 2010. We present results obtained at Cool (denoted as the T1 site of the project) in the foothills of the Sierra Nevada Mountains, where intense biogenic emissions are periodically mixed with urban outflow transported by daytime southwesterly winds from the Sacramento metropolitan area. During this study, the average mass loading of submicrometer particles (PM1) was 3.0 μg m−3, dominated by organics (80%) and sulfate (9.9%). The organic aerosol (OA) had a nominal formula of C1H1.38N0.004OM0.44, thus an average organic mass-to-carbon (OM/OC) ratio of 1.70. Two distinct oxygenated OA factors were identified via Positive matrix factorization (PMF) of the high-resolution mass spectra of organics. The more oxidized MO-OOA (O/C = 0.54) was interpreted as a surrogate for secondary OA (SOA) influenced by biogenic emissions whereas the less oxidized LO-OOA (O/C = 0.42) was found to represent SOA formed in photochemically processed urban emissions. LO-OOA correlated strongly with ozone and MO-OOA correlated well with two 1st generation isoprene oxidation products (methacrolein and methyl vinyl ketone), indicating that both SOAs were relatively fresh. A hydrocarbon like OA (HOA) factor was also identified, representing primary emissions mainly due to local traffic. On average, SOA (= MO-OOA + LO-OOA) accounted for 91% of the total OA mass and 72% of the PM1 mass observed at Cool. Twenty three periods of urban plumes from T0 (Sacramento) to T1 (Cool) were identified using the Weather Research and Forecasting model coupled with Chemistry (WRF-Chem). The average PM1 mass loading was considerably higher in urban plumes than in air masses dominated by biogenic SOA. The change in OA mass relative to CO (ΔOA/ΔCO) varied in the range of 5-196 μg m−3 ppm−1, reflecting large variability in SOA production. The highest ΔOA/ΔCO was reached when air masses were dominated by anthropogenic emissions in the presence of a high concentration of biogenic volatile organic compounds (BVOCs). This ratio, which was 97 μg m−3 ppm−1 on average, was much higher than when urban plumes arrived in a low BVOC environment (~36 μg m−3 ppm−1) or during other periods dominated by biogenic SOA (35 μg m−3 ppm−1). These results demonstrate that SOA formation is enhanced when anthropogenic emissions interact with biogenic precursors

Implementation of a Markov Chain Monte Carlo method to inorganic aerosol modeling of observations from the MCMA-2003 campaign ? Part II: Model application to the CENICA, Pedregal and Santa Ana sites

International audienceA Markov Chain Monte Carlo model for integrating the observations of inorganic species with a thermodynamic equilibrium model was presented in Part I of this series. Using observations taken at three ground sites, i.e. a residential, industrial and rural site, during the MCMA-2003 campaign in Mexico City, the model is used to analyze the inorganic particle and ammonia data and to predict gas phase concentrations of nitric and hydrochloric acid. In general, the model is able to accurately predict the observed inorganic particle concentrations at all three sites. The agreement between the predicted and observed gas phase ammonia concentration is excellent. The NOz concentration calculated from the NOy, NO and NO2 observations is of limited use in constraining the gas phase nitric acid concentration given the large uncertainties in this measure of nitric acid and additional reactive nitrogen species. Focusing on the acidic period of 9?11 April identified by Salcedo et al. (2006), the model accurately predicts the particle phase observations during this period with the exception of the nitrate predictions after 10:00 a.m. (Central Daylight Time, CDT) on 9 April, where the model underpredicts the observations by, on average, 20%. This period had a low planetary boundary layer, very high particle concentrations, and higher than expected nitrogen dioxide concentrations. For periods when the particle chloride observations are consistently above the detection limit, the model is able to both accurately predict the particle chloride mass concentrations and provide well-constrained HCl (g) concentrations. The availability of gas-phase ammonia observations helps constrain the predicted HCl (g) concentrations. When the particles are aqueous, the most likely concentrations of HCl (g) are in the sub-ppbv range. The most likely predicted concentration of HCl (g) was found to reach concentrations of order 10 ppbv if the particles are dry. Finally, the atmospheric relevance of HCl (g) is discussed in terms of its indicator properties for the possible influence of chlorine-mediated photochemistry in Mexico City

Effect of the Aerosol-Phase State on Secondary Organic Aerosol Formation from the Reactive Uptake of Isoprene-Derived Epoxydiols (IEPOX)

Acid-catalyzed reactions between gas- and particle-phase constituents are critical to atmospheric secondary organic aerosol (SOA) formation. The aerosol-phase state is thought to influence the reactive uptake of gas-phase precursors to aerosol particles by altering diffusion rates within particles. However, few experimental studies have explored the precise role of the aerosol-phase state on reactive uptake processes. This laboratory study systematically examines the reactive uptake coefficient (γ) of trans-β-isoprene epoxydiol (trans-β-IEPOX), the predominant IEPOX isomer, on acidic sulfate particles coated with SOA derived from α-pinene ozonolysis. γIEPOX is obtained for core-shell particles, the morphology of which was confirmed by microscopy, as a function of SOA coating thickness and relative humidity. γIEPOX is reduced, in some cases by half of the original value, when SOA coatings are present prior to uptake, especially when coating thicknesses are > 15 nm. The diurnal trend of IEPOX lost to acid-catalyzed reactive uptake yielding SOA compared with other known atmospheric sinks (gas-phase oxidation or deposition) is derived by modeling the experimental coating effect with field data from the southeastern United States. IEPOX-derived SOA is estimated to be reduced by 16-27% due to preexisting organic coatings during the afternoon (12:00 to 7:00 p.m., local time), corresponding to the period with the highest level of production

Mixing state of carbonaceous aerosol in an urban environment: Single particle characterization using the soot particle aerosol mass spectrometer (SP-AMS)

10.5194/acp-15-1823-2015Atmospheric Chemistry and Physics1541823-184

Mass spectrometry of refractory black carbon particles from six sources: carbon-cluster and oxygenated ions

We discuss the major mass spectral features of different types of refractory carbonaceous particles, ionized after laser vaporization with an Aerodyne high-resolution soot-particle aerosol mass spectrometer (SP-AMS). The SP-AMS was operated with a switchable 1064 nm laser and a 600 °C thermal vaporizer, yielding respective measurements of the refractory and non-refractory particle components. Six samples were investigated, all of which were composed primarily of refractory material: fuel-rich and fuel-lean propane/air diffusion-flame combustion particles; graphite-spark-generated particles; a commercial fullerene-enriched soot; Regal Black, a commercial carbon black; and nascent aircraft-turbine combustion particles. All samples exhibited a spectrum of carbon-cluster ions Cxn+ in their refractory mass spectrum. Smaller clusters (x xn+ distribution. For fullerene soot, fuel-rich-flame particles and spark-generated particles, significant Cxn+ clusters at x &gg; 6 were present, with significant contributions from multiply charged ions (n > 1). In all six cases, the ions C1+ and C3+ contributed over 60% to the total C1+ intensity. Furthermore, the ratio of these major ions C1+ / C3+ could be used to predict whether significant Cxn+ signals with x > 5 were present. When such signals were present, C1+ / C3+ was close to 1. When absent, C1+ / C3+ was < 0.8. This ratio may therefore serve as a proxy to distinguish between the two types of spectra in atmospheric SP-AMS measurements. Significant refractory oxygenated ions such as CO+ and CO2+ were also observed for all samples. We discuss these signals in detail for Regal Black, and describe their formation via decomposition of oxygenated moieties incorporated into the refractory carbon structure. These species may be of importance in atmospheric processes such as water uptake and heterogeneous chemistry. If atmospherically stable, these oxidized species may be useful for distinguishing between different combustion sources. If unstable, they may provide a means to estimate the atmospheric age of an rBC sample. Future studies should attempt to establish which of these scenarios is more realistic

Collection efficiency of the soot-particle aerosol mass spectrometer (SP-AMS) for internally mixed particulate black carbon

10.5194/amt-7-4507-2014Atmospheric Measurement Techniques7124507-451

Measurements of Black Carbon Particles Chemical, Physical, and Optical Properties

Accurate measurements of the chemical, physical, and optical properties of aerosol particles containing black carbon are necessary to improve current estimates of the radiative forcing in the atmosphere. A collaborative research effort between Aerodyne Research, Inc. and Boston College has focused on conducting field and laboratory experiments on carbonaceous particles and the development and characterization of new particulate instrumentation. This presentation will focus on the chemical, physical, and optical properties of black carbon particles measured in the laboratory in order to understand the effects of atmospheric processing on black carbon particles. Results from a three-week study during July 2008 of mass- and optical-based black carbon measurements will be presented. The project utilized the Boston College laboratory flame apparatus and aerosol conditioning and characterization equipment. A pre-mixed flat flame burner operating at controlled fuel-to-air ratios produced stable and reproducible concentrations of soot particles with known sizes, morphologies, and chemical compositions. In addition, other black carbon particle types, including fullerene soot, glassy carbon spheres, oxidized flame soot, Regal black, and Aquadag, were also atomized, size selected, and sampled. The study covered an experimental matrix that systematically selected particle mobility size (30 to 300 nm) and black carbon particle mass, particle number concentration, particle shape (dynamic shape factor and fractal dimension), and particle chemistry and density (changed via coatings). Particles were coated with a measured thickness (few nm to {approx}150 nm) of sulfuric acid or bis (2-ethylhexyl) sebacate and passed through a thermal denuder to remove the coatings. Highlights of the study to be presented include: (1) Characterization of the chemical and physical properties of various types of black carbon particles, (2) Mass specific absorption measurements as a function of fuel-to-air ratio and carbon particle type, (3) Optical absorption nhancement measurements as a function of coatings, and (4) Particle shape determination as a function of fuel-to-air ratio and collapse observed due to coatings