88 research outputs found
Road Use Behaviour of Urban Primary School Children in Ghana: Case Study of Ablekuma South Education Circuit of Metropolitan Accra
School children form majority of injured children on Ghanaian roads. The objective was to observe the road use behaviour of public primary school pupils in Ablekuma Education Circuit, Accra. This unobtrusive observational study targeted Primary one to six pupils. Five behaviours were studied: Walking while crossing road; Stopping at the kerb; Looking left-right-left before crossing; Keep looking left-right-left while crossing and Facing traffic while walking. 882 pupils on their way to or from school were observed from eight schools. A little over two in three children stopped at the kerb before crossing the road while almost three in four children looked for cars before stepping off the kerb. A little over three in four children walked while crossing and less than one in four children kept looking while crossing. Not looking for cars before crossing, not facing on-coming traffic and not keeping looking for cars while crossing, were more associated with boys than girls (p < 0.001; 95%CI in all cases). Girls behaved significantly more safely than boys. In stopping at the kerb, there was no difference in gender behaviour (p < 0.135; 95%CI). Child Road Safety Education in Schools and Communities is recommended
The Ghana Highway Code as a Teaching and Learning Material
The Ghana Highway Code is the official state-recognised traffic teaching and learning material widely used in traffic schools and by motorists in Ghana. Ghana changed its traffic from left-hand to right-hand drive in 1974; the Code was subsequently published to, besides other reasons, guide road users to be reconditioned to a fresh standard of behaviour. However, 46 years after its publication, the content of the Code has been outgrown by new developments in the road environment and traffic systems, rendering the Code ineffective. Content analysis was used to ascertain the validity and reliability of the Code. Out of 95 motorists interviewed, 91.5% indicated they use or had ever used the Code, while 3.2% had not used it before and 5.3% did not know about it at all. Hundred percent of driving schools used the Code as teaching and learning material. It was concluded that the Code was an obsolete teaching and learning material. The implication was that, the wide user population of the Code had an adverse impact on learners. It was recommended that the Code be revised and republished as new edition
Effectiveness And Safety Assessment Of Mist tonica, A Herbal Haematinic
Anaemia is a widespread public health problem, and in Ghana it is the fourth leading cause of hospital admissions and the second factor contributing to death. Mist Tonica, an herbal haematinic produced by the Centre for Scientific Research into Plant Medicine (CSRPM), Ghana, was assessed for its effectiveness and safety in humans after Ethics Committee approval. Clinically established anaemic-patients aged, 13 years and above, with haemoglobin levels less than 11.5 g/dl and 13.5g/dl for females and males respectively were treated with Mist tonica, 8.96 g/ 40 mls three times daily for two weeks . The mean haemoglobin rise per week caused by Mist Tonica was 1.92 (0.76) g/dl, range (1.66 - 2.55) g/dl/week and over 88 % of the patients on Mist Tonica had their
appetite for food improved. Haematological profile, liver and kidney functions were not adversely affected by Mist tonica. Results of the study suggest that Mist Tonica is an effective and safe herbal haematinic. Keywords: Anaemia, haemoglobin, herbal, haematinic, safety, effectivenessAfr. Jnl of Trad Comp Alt medicine Vol. 5 (2) 2008: pp. 115-11
Evaluating the effects of storage conditions on dry matter loss and nutritional quality of grain legume fodders in West Africa
Feed scarcity is a major challenge for livestock production in West Africa, especially during the dry season when grass quality and quantity on grazing lands are inadequate. In the dry season, crop residues are a key source of livestock feed. The residues of grain legumes, also known as grain legume fodders (GLFs), are stored and traded for feeding in the dry season. The objectives of our experiment were to evaluate the effects of storage conditions and duration on dry matter (DM) and nutritional quality of GLFs, and to assess the risk of aflatoxin in stored groundnut fodder. The experiment was designed as a factorial trial with 18 treatment combinations with four replicates (4 farms). The treatments included: 3 types of GLFs (cowpea, groundnut and soybean fodder), 3 types of storage locations (rooftop, room and tree-fork) and 2 types of packaging (packed in polythene sacks and unpacked but tied with rope). Over a 120 day storage period, DM quantity reduced by an average of 24 % across all storage conditions, showing a range from 14 % in the best condition (sacks and rooms) to 35 % in the worst condition (bundles tied with rope and stored on rooftops or tree-forks). Soybean fodder had no leaves, the lowest crude protein content (CP) and organic matter digestibility (OMD), and the highest content of cell wall components compared to cowpea and groundnut fodder. These nutritional quality parameters in soybean fodder hardly changed during storage. Cowpea and groundnut fodder showed a decrease in leaf-to-stem ratio (LSR), CP and OMD, and an increase in the content of cell wall components during storage, but their nutritional value remained better than that of soybean fodder. Storage in sacks resulted in less DM loss, in less reduction of LSR and in a smaller increase of the content of cell wall components than storage of bundles tied with rope. Our study shows that the DM loss, the decrease in LSR, and the increase in the content of cell wall components can be prevented partly by storing GLFs in sacks instead of tying bundles with rope, and to a minor extent by storing in rooms instead of in the open air. Aflatoxin was not detectable in the groundnut fodder samples. Our results highlight that attention to storage conditions can improve the feeding value of GLFs which are key for livestock nutrition during the dry season.</p
Overview of preparedness and response to COVID-19 in Ghana
The Coronavirus disease 2019 (COVID-19) outbreak in Ghana is part of an ongoing pandemic caused by the Severe Acute Respiratory Syndrome Coronavirus-2 (SARS-CoV-2). The first two cases of COVID-19 were confirmed in Ghana on 12th March 2020. COVID-19 was consequently declared a Public Health Emergency of National Concern, triggering several response actions, including enhanced surveillance, case detection, case management and contact tracing, closure of borders, suspension of international flights, ban on social gatherings and closure of schools. Preparedness and response plans were activated for implementation at the national, regional, district and community levels. Ghana’s Strategic approaches were to limit and stop the importation of cases; detect and contain cases early; expand infrastructure, logistics and capacity to provide quality healthcare for the sick; minimise disruption to social and economic life and increase the domestic capacity of all sectors to deal with existing and future shocks. The health sector strategic frame focused on testing, treatment, and tracking. As of 31st December 2020, a total of 535,168 cases, including 335 deaths (CFR: 0.61%), have been confirmed with 53,928 recoveries and 905 active cases. All the regions have reported cases, with Greater Accra reporting the highest number. The response actions in Ghana have seen highlevel political commitment, appropriate and timely decisions, and a careful balance of public health interventions with economic and socio-cultural dynamics. Efforts are ongoing to intensify non-pharmaceutical interventions, sustain the gains made so far and introduce COVID-19 vaccines to reduce the public health burden of the disease in Ghan
The absolute abundance calibration project: the <i>Lycopodium</i> marker-grain method put to the test
Traditionally, dinoflagellate cyst concentrations are calculated by adding an exotic marker or “spike” (such as Lycopodium clavatum) to each sample following the method of Stockmarr (1971). According to Maher (1981), the total error is controlled mainly by the error on the count of Lycopodium clavatum spores. In general, the more L. clavatum spores counted, the lower the error. A dinocyst / L. clavatum spore ratio of ~2 will give optimal results in terms of precision and time spent on a sample. It has also been proven that the use of the aliquot method yields comparable results to the marker-grain method (de Vernal et al., 1987). Critical evaluation of the effect of different laboratory procedures on the marker grain concentration in each sample has never been executed. Although, it has been reported that different processing methods (e.g. ultrasonication, oxidizing, etc.) are to a certain extent damaging to microfossils (e.g. Hodgkinson, 1991), it is not clear how this is translated into concentration calculations. It is wellknown from the literature that concentration calculations of dinoflagellate cysts from different laboratories are hard to resolve into a consistent picture. The aim of this study is to remove these inconsistencies and to make recommendations for the use of a standardized methodology. Sediment surface samples from four different localities (North Sea, Celtic Sea, NW Africa and Benguela) were macerated in different laboratories each using its own palynological maceration technique. A fixed amount of Lycopodium clavatum tablets was added to each sample. The uses of different preparation methodologies (sieving, ultrasonicating, oxidizing …) are compared using both concentrations – calculated from Lycopodium tablets - and relative abundances (more destructive methods will increase the amount of resistant taxa). Additionally, this study focuses on some important taxonomic issues, since obvious interlaboratorial differences in nomenclature are recorded
Looking back and moving forward: 50 years of soil and soil fertility management research in sub-Saharan Africa
Article purchased; Published online: 02 Nov 2017Low and declining soil fertility has been recognized for a long time as a major impediment to intensifying agriculture in sub-Saharan Africa (SSA). Consequently, from the inception of international agricultural research, centres operating in SSA have had a research programme focusing on soil and soil fertility management, including the International Institute of Tropical Agriculture (IITA). The scope, content, and approaches of soil and soil fertility management research have changed over the past decades in response to lessons learnt and internal and external drivers and this paper uses IITA as a case study to document and analyse
the consequences of strategic decisions taken on technology development, validation, and ultimately uptake by smallholder farmers in SSA. After an initial section describing the external environment within which soil and soil fertility management research is operating, various dimensions of this research area are covered: (i) ‘strategic research’, ‘Research for Development’, partnerships, and balancing acts, (ii) changing role of characterization due to the expansion in geographical scope and shift from soils to farms and livelihoods, (iii) technology development: changes in vision, content, and scale of intervention, (iv) technology validation and delivery to farming communities, and (v) impact and feedback to the technology development and validation process. Each of the above sections follows a chronological approach, covering the last five decades (from the late 1960s till today). The paper ends with a number of lessons learnt which could be considered for future initiatives aiming at developing and
delivering improved soil and soil fertility management practices to smallholder farming communities in SSA
Can sub-Saharan Africa feed itself?
Although global food demand is expected to increase 60% by 2050 compared with 2005/2007, the rise will be much greater in sub-Saharan Africa (SSA). Indeed, SSA is the region at greatest food security risk because by 2050 its population will increase 2.5-fold and demand for cereals approximately triple, whereas current levels of cereal consumption already depend on substantial imports. At issue is whether SSA can meet this vast increase in cereal demand without greater reliance on cereal imports or major expansion of agricultural area and associated biodiversity loss and greenhouse gas emissions. Recent studies indicate that the global increase in food demand by 2050 can be met through closing the gap between current farm yield and yield potential on existing cropland. Here, however, we estimate it will not be feasible to meet future SSA cereal demand on existing production area by yield gap closure alone. Our agronomically robust yield gap analysis for 10 countries in SSA using location-specific data and a spatial upscaling approach reveals that, in addition to yield gap closure, other more complex and uncertain components of intensification are also needed, i.e., increasing cropping intensity (the number of crops grown per 12 mo on the same field) and sustainable expansion of irrigated production area. If intensification is not successful and massive cropland land expansion is to be avoided, SSA will depend much more on imports of cereals than it does today
Interfacial Reaction During High Energy Ball Milling Dispersion of Carbon Nanotubes into Ti6Al4V
The unique thermal and mechanical properties of carbon nanotubes (CNTs) have made them choice reinforcements for metal matrix composites (MMCs). However, there still remains a critical challenge in achieving homogeneous dispersion of CNTs in metallic matrices. Although high energy ball milling (HEBM) has been reported as an effective method of dispersing CNTs into metal matrices, a careful selection of the milling parameters is important not to compromise the structural integrity of CNTs which may cause interfacial reactions with the matrix. In this study, multi-walled carbon nanotubes (MWCNTs) were purified by annealing in argon and vacuum atmospheres at 1000 and 1800 °C, respectively, for 5 h to remove possible metallic catalyst impurities. Subsequently, 1, 2 and 3 wt.% MWCNTs were dispersed by adapted HEBM into Ti6Al4V alloy metal matrix. Raman spectroscopy (RS), x-ray diffraction, scanning electron microscopy, energy-dispersive x-ray spectrometry and transmission electron microscopy techniques were used to characterize the as-received and annealed MWCNTs, as well as the admixed MWCNT/Ti6Al4V nanocomposite powders. The experimental results showed that vacuum annealing successfully eliminated retained nickel (Ni) catalysts from MWCNTs, while the adapted HEBM method achieved a relative homogeneous dispersion of MWCNTs into the Ti6Al4V matrix and helped to control interfacial reactions between defective MWCNTs and the metal matrix
- …