The measurement of very low conductivity and dielectric loss in XLPE cables: A possible method to detect degradation due to thermal aging

The dielectric response of crosslinked polyethylene (XLPE) insulated, miniature power cables, extruded with inner and outer semicons, was measured over the frequency range 10-4 to 104 Hz at temperatures from 20 to 100 °C. A dielectric spectrometer was used for the frequency range 10-4 to 10-2 Hz. A bespoke noise-free power supply was constructed and used to measure the dc conductivity and, using a Fourier transform technique, it was also used to measure the very low dielectric tanδ losses encountered at frequencies of 1 to 100 Hz. Tanδ measurements of <;10-5 were found in this frequency range and attributed to a β-mode dielectric relaxation lying above 100 Hz due to motion of chain segments in the amorphous region and an β-mode relaxation lying below 1 Hz window due to twists of chains in the crystal lamellae. The dc conductivity measurements were consistent with those of the dielectric spectrometer and indicate lower dc conductivities in vacuum degassed cables than have been previously reported for XLPE (less than 10-17 S.m-1). The conduction process is thermally activated with an activation energy of approximately 1.1 eV. Higher conductivities were found for non-degassed cables. A transformer ratio bridge was used for measurements in the range 1 to 10 kHz; loss in this region was shown to be due to the series resistance of the semicon layers. Thermal ageing of the cables at 135 °C for 60 days caused significant increases in the conductivity and tanδ and it is considered that such measurements may be a sensitive way of measuring electrical degradation due to thermal aging

Dielectric spectroscopy study of thermally-aged extruded model power cables

“Model” extruded power cables, having a much reduced geometry but using the same extrusion techniques and materials as full-sized cables, have been examined using dielectric spectroscopy techniques to study their thermal ageing effects. Cables insulated with homo-polymer XLPE and co-polymer of XLPE with micron-sized ethylene-butyl-acrylate (EBA) islands were studied by both frequency-domain and time-domain dielectric spectroscopy techniques after accelerated thermal ageing under 135°C for 60 days. In the frequency domain, a frequency response analyzer (FRA) was used to measure the frequency range from 10-4Hz to 1Hz at temperatures from 20°C to 80°C. In the time domain, a special charging/discharging current measurement system was developed to measure the frequencies from 10-1Hz to 102Hz. These techniques were chosen to cope with the extremely low dielectric losses of the model cables. The results are compared with those from new model power cables that were degassed at 80°C for 5 days. Thermal ageing was found to increase the low-frequency conductivity, permittivity and the discharging current. Both homo- and co-polymer cables have substantial increase of dielectric loss after ageing

Characterizing HV XLPE cables by electrical, chemical and microstructural measurements on cable peeling: Effects of surface roughness, thermal treatment and peeling location

Characterization of the electrical, chemical, and microstructural properties of high voltage cables was the first step of the European project “ARTEMIS”, which has the aim of investigating degradation processes and constructing aging models for the diagnosis of cross-linked polyethylene (XLPE) cables. Cables produced by two different manufacturers were subjected to a large number of electrical, microstructural, and chemical characterizations, using cable peelings, instead of lengths of whole cables, as specimens for the measurements. Here the effect of surface deformation and roughness due to peeling and the relevance and significance of thermal pre-treatment prior to electrical and other measurements is discussed. Special emphasis is put on space charge, conduction current and luminescence measurements. We also consider the dependence of these properties on the spatial position of the specimen within the cable. It is shown that even though the two faces of the cable peel specimens have different roughness, the low-field electrical properties seem quite insensitive to surface roughness, while significant differences are detectable at high fields. Thermal pre-treatment is required to stabilize the insulating material to enable us to obtain reproducible results and reliable inter-comparisons throughout the whole project. The spatial position of the specimens along the cable radius can also have a non-negligible influence on the measured properties, due to differential microstructure and chemical composition

Experimental f-value and isotopic structure for the Ni I line blended with [OI] at 6300A

We have measured the oscillator strength of the Ni I line at 6300.34 \AA, which is known to be blended with the forbidden [O I] $\lambda$6300 line, used for determination of the oxygen abundance in cool stars. We give also wavelengths of the two isotopic line components of $^{58}$Ni and $^{60}$Ni derived from the asymmetric laboratory line profile. These two line components of Ni I have to be considered when calculating a line profile of the 6300 \AA\ feature observed in stellar and solar spectra. We also discuss the labelling of the energy levels involved in the Ni I line, as level mixing makes the theoretical predictions uncertain.Comment: Accepted for publication in ApJLetter

The state space and physical interpretation of self-similar spherically symmetric perfect-fluid models

The purpose of this paper is to further investigate the solution space of self-similar spherically symmetric perfect-fluid models and gain deeper understanding of the physical aspects of these solutions. We achieve this by combining the state space description of the homothetic approach with the use of the physically interesting quantities arising in the comoving approach. We focus on three types of models. First, we consider models that are natural inhomogeneous generalizations of the Friedmann Universe; such models are asymptotically Friedmann in their past and evolve fluctuations in the energy density at later times. Second, we consider so-called quasi-static models. This class includes models that undergo self-similar gravitational collapse and is important for studying the formation of naked singularities. If naked singularities do form, they have profound implications for the predictability of general relativity as a theory. Third, we consider a new class of asymptotically Minkowski self-similar spacetimes, emphasizing that some of them are associated with the self-similar solutions associated with the critical behaviour observed in recent gravitational collapse calculations.Comment: 24 pages, 12 figure