Revised Coordinates and Proper Motions of the Stars in the Luyten Half-Second Catalogue

We present refined coordinates and proper motion data for the high proper motion (HPM) stars in the Luyten Half-Second (LHS) catalogue. The positional uncertainty in the original Luyten catalogue is typically >10" and is often >30". We have used the digital scans of the Palomar Observatory Sky Survey (POSS) I and POSS II plates to derive more accurate positions and proper motions of the objects. Out of the 4470 candidates in the LHS catalogue, 4323 objects were manually re-identified in the POSS I and POSS II scans. A small fraction of the stars were not found due to the lack of finder charts and digitized POSS II scans. The uncertainties in the revised positions are typically ~2", but can be as high as ~8" in a few cases; this is a large improvement over the original data. Cross-correlation with the Tycho-2 and Hipparcos catalogues yielded 819 candidates (with m_R < 12). For these brighter sources, the position and proper motion data have been replaced with the more accurate Tycho/Hipparcos data. In total, we have revised proper motion measurements and coordinates for 4040 stars and revised coordinates for 4330 stars, which are presented here.Comment: 108 pages. Accepted for Publication in ApJ Suppl. Some errors caused by the transcription errors in the original LHS catalogue have been corrected in this resubmission. The most current version of the catalogue is also available online at http://www.stsci.edu/~ksahu/lh

KIC7668647: a 14 day beaming sdB+WD binary with a pulsating subdwarf

The recently discovered subdwarf B (sdB) pulsator KIC7668647 is one of the 18 pulsating sdB stars detected in the Kepler field. It features a rich g-mode frequency spectrum, with a few low-amplitude p-modes at short periods. We use new ground-based low-resolution spectroscopy, and the near-continuous 2.88 year Kepler lightcurve, to reveal that KIC7668647 consists of a subdwarf B star with an unseen white-dwarf companion with an orbital period of 14.2d. An orbit with a radial-velocity amplitude of 39km/s is consistently determined from the spectra, from the orbital Doppler beaming seen by Kepler at 163ppm, and from measuring the orbital light-travel delay of 27 by timing of the many pulsations seen in the Kepler lightcurve. The white dwarf has a minimum mass of 0.40 M_sun. We use our high signal-to-noise average spectra to study the atmospheric parameters of the sdB star, and find that nitrogen and iron have abundances close to solar values, while helium, carbon, oxygen and silicon are underabundant relative to the solar mixture. We use the full Kepler Q06--Q17 lightcurve to extract 132 significant pulsation frequencies. Period-spacing relations and multiplet splittings allow us to identify the modal degree L for the majority of the modes. Using the g-mode multiplet splittings we constrain the internal rotation period at the base of the envelope to 46-48d as a first seismic result for this star. The few p-mode splittings may point at a slightly longer rotation period further out in the envelope of the star. From mode-visibility considerations we derive that the inclination of the rotation axis of the sdB in KIC7668647 must be around ~60 degrees. Furthermore, we find strong evidence for a few multiplets indicative of degree 3 <= L <= 8, which is another novelty in sdB-star observations made possible by Kepler.Comment: arXiv admin note: text overlap with arXiv:1206.387

Effect of Flow on Caloric Curve for Finite Nuclei

In a finite temperature Thomas-Fermi theory, we construct caloric curves for finite nuclei enclosed in a freeze-out volume few times the normal nuclear volume, with and without inclusion of flow. Without flow, the caloric curve indicates a smooth liquid-gas phase transition whereas with flow, the transition may be very sharp. We discuss these results in the context of two recent experiments, one for heavy symmetric system (Au + Au at 600A MeV) and the other for highly asymmetric system (Au + C at 1A GeV) where different behaviours in the caloric curves are seen.Comment: 11 pages revtex; 4 figs; version to appear in Phys. Rev. Let

Observation of a New Type of Low Frequency Waves at Comet 67P/Churyumov-Gerasimenko

We report on magnetic field measurements made in the innermost coma of 67P/Churyumov-Gerasimenko in its low activity state. Quasi-coherent, large-amplitude ($\delta B/B \sim 1$), compressional magnetic field oscillations at $\sim$ 40 mHz dominate the immediate plasma environment of the nucleus. This differs from previously studied comet-interaction regions where waves at the cometary ion gyro-frequencies are the main feature. Thus classical pick-up ion driven instabilities are unable to explain the observations. We propose a cross-field current instability associated with newborn cometary ion currents as a possible source mechanism.Comment: 6 pages, 3 Figure

Comparative study of the (0001) and (0001) surfaces of ZnO

The authors compare the surface and optical properties of the Zn-polar (0001) and O-polar (0001¯)surfaces of bulk ZnO samples. For optical characterization, steady-state photoluminescence using a He–Cd laser was measured at 15 and 300K. At room temperature, the (0001¯)surface demonstrates nearly double the near-band-edge emission intensity seen for the (0001) surface. Using scanning Kelvin probe microscopy, the authors have measured surface contact potentials of 0.39±0.05 and 0.50±0.05V for the (0001) and (0001¯)surfaces, respectively. The resulting small difference in band bending for these two surfaces indicates that charge transfer between the surfaces is not a dominant stabilizing mechanism. Conductive atomic force microscopy studies show enhanced reverse-bias conduction in localized regions on the (0001¯) vs (0001) surface. The differences in surface conduction and band bending between the two polar surfaces can be attributed to their chemical interactions with hydrogen and water in the ambient

Does the process map influence the outcome of quality improvement work? A comparison of a sequential flow diagram and a hierarchical task analysis diagram

Background: Many quality and safety improvement methods in healthcare rely on a complete and accurate map of the process. Process mapping in healthcare is often achieved using a sequential flow diagram, but there is little guidance available in the literature about the most effective type of process map to use. Moreover there is evidence that the organisation of information in an external representation affects reasoning and decision making. This exploratory study examined whether the type of process map - sequential or hierarchical - affects healthcare practitioners' judgments.Methods: A sequential and a hierarchical process map of a community-based anti coagulation clinic were produced based on data obtained from interviews, talk-throughs, attendance at a training session and examination of protocols and policies. Clinic practitioners were asked to specify the parts of the process that they judged to contain quality and safety concerns. The process maps were then shown to them in counter-balanced order and they were asked to circle on the diagrams the parts of the process where they had the greatest quality and safety concerns. A structured interview was then conducted, in which they were asked about various aspects of the diagrams.Results: Quality and safety concerns cited by practitioners differed depending on whether they were or were not looking at a process map, and whether they were looking at a sequential diagram or a hierarchical diagram. More concerns were identified using the hierarchical diagram compared with the sequential diagram and more concerns were identified in relation to clinical work than administrative work. Participants' preference for the sequential or hierarchical diagram depended on the context in which they would be using it. The difficulties of determining the boundaries for the analysis and the granularity required were highlighted.Conclusions: The results indicated that the layout of a process map does influence perceptions of quality and safety problems in a process. In quality improvement work it is important to carefully consider the type of process map to be used and to consider using more than one map to ensure that different aspects of the process are captured

Iron Status and Analysis of Efficacy and Safety of Ferric Carboxymaltose Treatment in Patients with Inflammatory Bowel Disease

Background and Aims:We analyzed iron deficiency and the therapeutic response following intravenous ferric carboxymaltose in a large single-center inflammatory bowel disease (IBD) cohort. Methods: 250 IBD patients were retrospectively analyzed for iron deficiency and iron deficiency anemia. A subgroup was analyzed regarding efficacy and side effects of iron supplementation with ferric carboxymaltose. Results: In the cohort (n = 250), 54.4% of the patients had serum iron levels 60 mu g/dl, 61.6% had ferritin >100 ng/ml, and 90.7% reached Hb >12/13 g/dl at follow-up (p < 0.0001 for all parameters vs. pretreatment values). The most frequent adverse event was a transient increase of liver enzymes with male gender as risk factor (p = 0.008, OR 8.62, 95% CI 1.74-41.66). Conclusions: Iron deficiency and anemia are frequent in IBD patients. Treatment with ferric carboxymaltose is efficious, safe and well tolerated in iron-deficient IBD patients. Copyright (C) 2011 S. Karger AG, Base