64,222 research outputs found
Methodology for the systems engineering process. Volume 2: Technical parameters
A scheme based on starting the logic networks from the development and mission factors that are of primary concern in an aerospace system is described. This approach required identifying the primary states (design, design verification, premission, mission, postmission), identifying the attributes within each state (performance capability, survival, evaluation, operation, etc), and then developing the generic relationships of variables for each branch. To illustrate this concept, a system was used that involved a launch vehicle and payload for an earth orbit mission. Examination showed that this example was sufficient to illustrate the concept. A more complicated mission would follow the same basic approach, but would have more extensive sets of generic trees and more correlation points between branches. It has been shown that in each system state (production, test, and use), a logic could be developed to order and classify the parameters involved in the translation from general requirements to specific requirements for system elements
Determining the effectiveness of the Clean Air Act and Amendments on the recovery of surface waters in the northeastern US, 2010
How effective is harassment on infalling late-type dwarfs?
A new harassment model is presented that models the complex, and dynamical
tidal field of a Virgo like galaxy cluster. The model is applied to small,
late-type dwarf disc galaxies (of substantially lower mass than in previous
harassment simulations) as they infall into the cluster from the outskirts.
These dwarf galaxies are only mildly affected by high speed tidal encounters
with little or no observable consequences; typical stellar losses are ,
producing very low surface brightness streams ( mag arcsec),
and a factor of two drop in dynamical mass-to-light ratio. Final stellar discs
remain disc-like, and dominated by rotation although often with tidally induced
spiral structure. By means of Monte-Carlo simulations, the statistically likely
influences of harassment on infalling dwarf galaxies are determined. The
effects of harassment are found to be highly dependent on the orbit of the
galaxy within the cluster, such that newly accreted dwarf galaxies typically
suffer only mild harassment. Strong tidal encounters, that can morphologically
transform discs into spheroidals, are rare occurring in of dwarf
galaxy infalls for typical orbits of sub-structure within CDM cluster
mass halos. For orbits with small apocentric distances (250 kpc), harassment
is significantly stronger resulting in complete disruption or heavy mass loss
( dark matter and stellar), however, such orbits are expected
to be highly improbable for newly infalling galaxies due to the deep potential
well of the cluster.Comment: 15 pages, 11 figures, 4 table
Determining the Effectiveness of the Clean Air Act and Amendments for the Recovery of Surface Waters in the Northeastern U.S.
Analytical technique characterizes all trace contaminants in water
Properly programmed combination of advanced chemical and physical analytical techniques characterize critically all trace contaminants in both the potable and waste water from the Apollo Command Module. This methodology can also be applied to the investigation of the source of water pollution
Structure and dynamics of topological defects in a glassy liquid on a negatively curved manifold
We study the low-temperature regime of an atomic liquid on the hyperbolic
plane by means of molecular dynamics simulation and we compare the results to a
continuum theory of defects in a negatively curved hexagonal background. In
agreement with the theory and previous results on positively curved (spherical)
surfaces, we find that the atomic configurations consist of isolated defect
structures, dubbed "grain boundary scars", that form around an irreducible
density of curvature-induced disclinations in an otherwise hexagonal
background. We investigate the structure and the dynamics of these grain
boundary scars
Development of Heterogeneous Photosensitized Transition Metal Oxide Water-Splitting Catalysts on Silica Support
The research presented in this manuscript describes the development of photosensitized inexpensive catalysts based on readily available materials. The investigation covers synthesis and characterization of photosensitizers based on porphyrins, mechanical and thermal coating of solid support with semiconducting transition metal oxides, photosensitization of the semiconducting layer, and characterization of the photoelectrochemical properties displayed by the new materials. The process of water oxidation is of primary interest here, with little emphasis put on reduction of protons to gaseous hydrogen. Photoelectrochemically produced protons serve as a probe of effectiveness of the catalysts. Several systems are described, and two catalysts are identified as the most efficient
Flow properties of a series of experimental thermoplastic polymides
The softening temperature to degradation temperature range of the polymers was about 440 to 650 K. All of the polymers retained small amounts of solvent as indicated by an increase in T(sub g) as the polymers were dried. The flow properties showed that all three polymers had very high apparent viscosities and would require high pressures and/or high temperatures and/or long times to obtain adequate flow in prepregging and molding. Although none was intended for such application, two of the polymers were combined with carbon fibers by solution prepregging. The prepregs were molded into laminates at temperatures and times, the selection of which was guided by the results from the flow measurements. These laminates had room temperature short beam shear strength similar to that of carbon fiber laminates with a thermosetting polyimide matrix. However, the strength had considerable scatter, and given the difficult processing, these polymides probably would not be suitable for continuous fiber composites
A generalized theory of semiflexible polymers
DNA bending on length scales shorter than a persistence length plays an
integral role in the translation of genetic information from DNA to cellular
function. Quantitative experimental studies of these biological systems have
led to a renewed interest in the polymer mechanics relevant for describing the
conformational free energy of DNA bending induced by protein-DNA complexes.
Recent experimental results from DNA cyclization studies have cast doubt on the
applicability of the canonical semiflexible polymer theory, the wormlike chain
(WLC) model, to DNA bending on biological length scales. This paper develops a
theory of the chain statistics of a class of generalized semiflexible polymer
models. Our focus is on the theoretical development of these models and the
calculation of experimental observables. To illustrate our methods, we focus on
a specific toy model of DNA bending. We show that the WLC model generically
describes the long-length-scale chain statistics of semiflexible polymers, as
predicted by the Renormalization Group. In particular, we show that either the
WLC or our new model adequate describes force-extension, solution scattering,
and long-contour-length cyclization experiments, regardless of the details of
DNA bend elasticity. In contrast, experiments sensitive to short-length-scale
chain behavior can in principle reveal dramatic departures from the linear
elastic behavior assumed in the WLC model. We demonstrate this explicitly by
showing that our toy model can reproduce the anomalously large
short-contour-length cyclization J factors observed by Cloutier and Widom.
Finally, we discuss the applicability of these models to DNA chain statistics
in the context of future experiments
- …