4,355 research outputs found
Unpacking Brazil’s leadership in the global biofuels arena: Brazilian ethanol diplomacy in Africa
Biofuels represent an opportunity for Brazil to exert global leadership by substantially scaling up the production, consumption, and international trade of bioethanol. Africa represents an ideal venue in which to do this, given its suitable agro-climatic conditions and extensive land area. Brazil has consequently sought to establish bilateral partnerships with African countries, as well as North-South-South trilateral partnerships involving the EU and US. However, empirically grounded assessments of how Brazil’s leadership aspirations have unfolded in practice through these partnerships are limited. In this article, we examine Brazil’s potential to exert global political leadership, by analyzing its policy-based, structural, and instrumental qualities in making bilateral and trilateral inroads regarding bioethanol production in Africa. Interviews in Brazil, Africa, and Europe suggest that both the bilateral and trilateral avenues have produced meager results. Lack of domestic strategy and vision, economic recession, and a fragmented alliance network have reduced Brazil’s capacity to achieve its ethanol diplomacy objectives
Measurements and optimization of the light yield of a TeO crystal
Bolometers have proven to be good instruments to search for rare processes
because of their excellent energy resolution and their extremely low intrinsic
background. In this kind of detectors, the capability of discriminating alpha
particles from electrons represents an important aspect for the background
reduction. One possibility for obtaining such a discrimination is provided by
the detection of the Cherenkov light which, at the low energies of the natural
radioactivity, is only emitted by electrons. This paper describes the method
developed to evaluate the amount of light produced by a crystal of TeO when
hit by a 511 keV photon. The experimental measurements and the results of a
detailed simulation of the crystal and the readout system are shown and
compared. A light yield of about 52 Cherenkov photons per deposited MeV was
measured. The effect of wrapping the crystal with a PTFE layer, with the aim of
maximizing the light collection, is also presented
New application of superconductors: high sensitivity cryogenic light detectors
In this paper we describe the current status of the CALDER project, which is
developing ultra-sensitive light detectors based on superconductors for
cryogenic applications. When we apply an AC current to a superconductor, the
Cooper pairs oscillate and acquire kinetic inductance, that can be measured by
inserting the superconductor in a LC circuit with high merit factor.
Interactions in the superconductor can break the Cooper pairs, causing sizable
variations in the kinetic inductance and, thus, in the response of the LC
circuit. The continuous monitoring of the amplitude and frequency modulation
allows to reconstruct the incident energy with excellent sensitivity. This
concept is at the basis of Kinetic Inductance Detectors (KIDs), that are
characterized by natural aptitude to multiplexed read-out (several sensors can
be tuned to different resonant frequencies and coupled to the same line),
resolution of few eV, stable behavior over a wide temperature range, and ease
in fabrication. We present the results obtained by the CALDER collaboration
with 2x2 cm2 substrates sampled by 1 or 4 Aluminum KIDs. We show that the
performances of the first prototypes are already competitive with those of
other commonly used light detectors, and we discuss the strategies for a
further improvement
Characterization of the KID-Based Light Detectors of CALDER
The aim of the Cryogenic wide-Area Light Detectors with Excellent Resolution
(CALDER) project is the development of light detectors with active area of
cm and noise energy resolution smaller than 20 eV RMS,
implementing phonon-mediated kinetic inductance detectors. The detectors are
developed to improve the background suppression in large-mass bolometric
experiments such as CUORE, via the double read-out of the light and the heat
released by particles interacting in the bolometers. In this work, we present
the characterization of the first light detectors developed by CALDER. We
describe the analysis tools to evaluate the resonator parameters (resonant
frequency and quality factors) taking into account simultaneously all the
resonance distortions introduced by the read-out chain (as the feed-line
impedance and its mismatch) and by the power stored in the resonator itself. We
detail the method for the selection of the optimal point for the detector
operation (maximizing the signal-to-noise ratio). Finally, we present the
response of the detector to optical pulses in the energy range of 0-30 keV
Energy resolution and efficiency of phonon-mediated Kinetic Inductance Detectors for light detection
The development of sensitive cryogenic light detectors is of primary interest
for bolometric experiments searching for rare events like dark matter
interactions or neutrino-less double beta decay. Thanks to their good energy
resolution and the natural multiplexed read-out, Kinetic Inductance Detectors
(KIDs) are particularly suitable for this purpose. To efficiently couple
KIDs-based light detectors to the large crystals used by the most advanced
bolometric detectors, active surfaces of several cm are needed. For this
reason, we are developing phonon-mediated detectors. In this paper we present
the results obtained with a prototype consisting of four 40 nm thick aluminum
resonators patterned on a 22 cm silicon chip, and calibrated with
optical pulses and X-rays. The detector features a noise resolution
eV and an (182) efficiency.Comment: 5 pages, 5 figure
High sensitivity phonon-mediated kinetic inductance detector with combined amplitude and phase read-out
The development of wide-area cryogenic light detectors with good energy
resolution is one of the priorities of next generation bolometric experiments
searching for rare interactions, as the simultaneous read-out of the light and
heat signals enables background suppression through particle identification.
Among the proposed technological approaches for the phonon sensor, the
naturally-multiplexed Kinetic Inductance Detectors (KIDs) stand out for their
excellent intrinsic energy resolution and reproducibility. To satisfy the large
surface requirement (several cm) KIDs are deposited on an insulating
substrate that converts the impinging photons into phonons. A fraction of
phonons is absorbed by the KID, producing a signal proportional to the energy
of the original photons. The potential of this technique was proved by the
CALDER project, that reached a baseline resolution of 1547 eV RMS by
sampling a 22 cm Silicon substrate with 4 Aluminum KIDs. In this
paper we present a prototype of Aluminum KID with improved geometry and quality
factor. The design improvement, as well as the combined analysis of amplitude
and phase signals, allowed to reach a baseline resolution of 824 eV by
sampling the same substrate with a single Aluminum KID
The 2018 report of the Lancet Countdown on health and climate change: shaping the health of nations for centuries to come
The Lancet Countdown: tracking progress on health and climate change was established to provide an independent, global monitoring system dedicated to tracking the health dimensions of the impacts of, and the response to, climate change. The Lancet Countdown tracks 41 indicators across five domains: climate change impacts, exposures, and vulnerability; adaptation, planning, and resilience for health; mitigation actions and health co-benefits; finance and economics; and public and political engagement.
This report is the product of a collaboration of 27 leading academic institutions, the UN, and intergovernmental agencies from every continent. The report draws on world-class expertise from climate scientists, ecologists, mathematicians, geographers, engineers, energy, food, livestock, and transport experts, economists, social and political scientists, public health professionals, and doctors.
The Lancet Countdown's work builds on decades of research in this field, and was first proposed in the 2015 Lancet Commission on health and climate change,1 which documented the human impacts of climate change and provided ten global recommendations to respond to this public health emergency and secure the public health benefits available (panel 1)
First bolometric measurement of the two neutrino double beta decay of Mo with a ZnMoO crystals array
The large statistics collected during the operation of a ZnMoO array, for
a total exposure of 1.3 kg day of Mo, allowed the first
bolometric observation of the two neutrino double beta decay of Mo. The
observed spectrum of each crystal was reconstructed taking into account the
different background contributions due to environmental radioactivity and
internal contamination. The analysis of coincidences between the crystals
allowed the assignment of constraints to the intensity of the different
background sources, resulting in a reconstruction of the measured spectrum down
to an energy of 300 keV. The half-life extracted from the data is
T= [7.15 0.37 (stat) 0.66 (syst)] 10
y.Comment: 6 pages, 2 figure, Accepted for publication in Journal of Physics G:
Nuclear and Particle Physic
TeO bolometers with Cherenkov signal tagging: towards next-generation neutrinoless double beta decay experiments
CUORE, an array of 988 TeO bolometers, is about to be one of the most
sensitive experiments searching for neutrinoless double-beta decay. Its
sensitivity could be further improved by removing the background from
radioactivity. A few years ago it has been pointed out that the signal from
s can be tagged by detecting the emitted Cherenkov light, which is not
produced by s. In this paper we confirm this possibility. For the first
time we measured the Cherenkov light emitted by a CUORE crystal, and found it
to be 100 eV at the -value of the decay. To completely reject the
background, we compute that one needs light detectors with baseline noise below
20 eV RMS, a value which is 3-4 times smaller than the average noise of the
bolometric light detectors we are using. We point out that an improved light
detector technology must be developed to obtain TeO bolometric experiments
able to probe the inverted hierarchy of neutrino masses.Comment: 5 pages, 4 figures. Added referee correction
- …