757 research outputs found
Fogging technique used to coat magnesium with plastic
Cleaning process and a fogging technique facilitate the application of a plastic coating to magnesium plates. The cleaning process removes general organic and inorganic surface impurities, oils and greases, and oxides and carbonates from the magnesium surfaces. The fogging technique produces a thin-filmlike coating in a clean room atmosphere
X-ray observations of the hot phase in Sgr~A*
We analyze 134 ks Chandra ACIS-I observations of the Galactic Centre (GC)
performed in July 2011. The X-ray image with the field of view
contains the hot plasma surrounding the Sgr~A*. The obtained surface brightness
map allow us to fit Bondi hot accretion flow to the innermost hot plasma around
the GC. We have fitted spectra from region up to from Sgr~A* using a
thermal bremsstrahlung model and four Gaussian profiles responsible for
K emission lines of Fe, S, Ar, and Ca. The X-ray surface brightness
profile up to from Sgr~A* found in our data image, was successfully fitted
with the dynamical model of Bondi spherical accretion. By modelling the surface
brightness profile, we derived the temperature and number density profiles in
the vicinity of the black hole. The best fitted model of spherical Bondi
accretion shows that this type of flow works only up to and implies outer
plasma density and temperature to be:
cm and keV respectively. We show
that the Bondi flow can reproduce observed surface brightness profile up to
from Sgr~A* in the Galactic Center. This result strongly suggests the
position of stagnation radius in the complicated dynamics around GC. The
Faraday rotation computed from our model towards the pulsar PSR J1745-2900 near
the GC agrees with the observed one, recently reported.Comment: 10 pages, 7 figures, accepted for publication in A&
Catalytic combustion for the automotive gas turbine engine
Fuel injectors to provide a premixed prevaporized fuel-air mixture are studied. An evaluation of commercial catalysts was performed as part of a program leading to the demonstration of a low emissions combustor for an automotive gas turbine engine. At an inlet temperature of 800 K, a pressure of 500,000 Pa and a velocity of 20 m/s a multiple-jet injector produced less than + or - 10 percent variation in Jet-A fuel-air ratio and 100 percent varporization with less than 0.5 percent pressure drop. Fifteen catalytic reactors were tested with propane fuel at an inlet temperature of 800 K, a pressure of 300,000 Pa and inlet velocities of 10 to 25 m/s. Seven of the reactors had less than 2 percent pressure drop while meeting emissions goals of 13.6 gCO/kg fuel and 1.64 gHC/kg fuel at the velocities and exit temperatures required for operation in an automotive gas turbine engine. NO sub x emissions at all conditions were less than 0.5 ppm. All tests were performed with steady state conditions
Performance of a catalytic reactor at simulated gas turbine combustor operating conditions
The performance of a catalytic reactor 12 cm in diameter and 17 cm long was evaluated at simulated gas turbine combustor operating conditions using premixed propane and air. Inlet temperatures of 600 and 800 K, pressures of 3 and 6 atm, and reference velocities of 9 to 30 m/s were tested. Data were taken for equivalence ratios as high as 0.43. The operating range was limited on the low-temperature side by very poor efficiency; the minimum exit temperature for good performance ranged from 1400 to 1600 K depending on inlet conditions. As exit temperatures were raised above this minimum, emissions of unburned hydrocarbons decreased, carbon monoxide emissions became generally less than 1 g CO/kg fuel, and nitrogen oxides were less than about 0.1 g NO2/kg fuel
Design and fabrication of a low-specific-weight parabolic dish solar concentrator
A segmented design and fabrication and assembly techniques were developed for a 1.8 m (6 ft) diameter parabolic concentrator for space application. This design and these techniques were adaptable to a low cost, mass-produced concentrator. Minimal machining was required. Concentrator segments of formed magnesium were used. The concentrator weighed only 1.6 kg sq m (0.32 lbm/sq ft)
Emissions control for ground power gas turbines
The similarities and differences of emissions reduction technology for aircraft and ground power gas turbines is described. The capability of this technology to reduce ground power emissions to meet existing and proposed emissions standards is presented and discussed. Those areas where the developing aircraft gas turbine technology may have direct application to ground power and those areas where the needed technology may be unique to the ground power mission are pointed out. Emissions reduction technology varying from simple combustor modifications to the use of advanced combustor concepts, such as catalysis, is described and discussed
Experimental and Theoretical Investigation of Overall Energy Deposition in Surface-Induced Unfolding of Protein Ions
Recent advances in native mass spectrometry have enabled its use to probe the structure of and interactions within biomolecular complexes. Surface-induced dissociation, in which inter- and intramolecular interactions are disrupted following an energetic ion-surface collision, is a method that can directly interrogate the topology of protein complexes. However, a quantitative relationship between the ion kinetic energy at the moment of surface collision and the internal energy deposited into the ion has not yet been established for proteins. The factors affecting energy deposition in surface-induced unfolding (SIU) of protein monomers were investigated and a calibration relating laboratory-frame kinetic energy to internal energy developed. Protein monomers were unfolded by SIU and by collision-induced unfolding (CIU). CIU and SIU cause proteins to undergo the same unfolding transitions at different values of laboratory-frame kinetic energy. There is a strong correlation between the SIU and CIU energies, demonstrating that SIU, like CIU, can largely be understood as a thermal process. The change in internal energy in CIU was modeled using a Monte Carlo approach and theory. Computed values of the overall efficiency were found to be approximately 25% and used to rescale the CIU energy axis and relate nominal SIU energies to internal energy. The energy deposition efficiency in SIU increases with mass and kinetic energy from a low of -20% to a high of -68%, indicating that the effective mass of the surface increases along with the mass of the ion. The effect of ion structure on energy deposition was probed using multiple stages of ion activation. Energy deposition in SIU strongly depends on structure, decreasing as the protein is elongated, due to decreased effective protein-surface collisional cross section and increased transfer to rotational modes
Magnetohydrodynamics (MHD) Engineering Test Facility (ETF) 200 MWe power plant. Design Requirements Document (DRD)
A description and the design requirements for the 200 MWe (nominal) net output MHD Engineering Test Facility (ETF) Conceptual Design, are presented. Performance requirements for the plant are identified and process conditions are indicated at interface stations between the major systems comprising the plant. Also included are the description, functions, interfaces and requirements for each of these major systems. The lastest information (1980-1981) from the MHD technology program are integrated with elements of a conventional steam electric power generating plant
Caregiving and elderly health in Mexico
Using the National Mexican Health and Aging Study panel dataset, the authors estimate the effect of having informal care on the probability of dying and on the change in elderly health over a two-year period. Three measures of functional health were used: self-reported health, activities of daily living, and instrumental activities of daily living. We develop an empirical strategy that relies on the panel structure of the dataset to sort out the possible correlation between unobservable characteristics that affect both elderly health and an individual’s decision to provide informal care. Our findings suggest that informal care provided by daughters reduces the probability of dying. In addition, informal care provided by daughters reduces the probability of having a decline in activities of daily living and instrumental activities of daily living, while it has no effect on the observed changes in self-reported health status. The protective effect of informal care provided by sons is not statistically significant for any health outcomes. A discussion of the policy options to increase elderly health and to improve the role of caregivers is included
Cross Sections, Recoil Ranges, and Angular Distributions of Nuclei Produced in 20-200 MeV Alpha Bombardment of 59-Co
This work was supported by the National Science Foundation Grant NSF PHY 81-14339 and by Indiana Universit
- …