Evaluation of quality of drinking water from Baghdad, Iraq

This is a joint work between the Italian Red Cross and the Environmental Laboratories, Baghdad. The drinking water (DW) samples from 16 residential districts in Baghdad were chemically evaluated with reference to the raw water samples and water directly taken from the purification plants. In addition to the routinely measured parameters, 17 metals and 11 trihalomathane (THM) were measured. Generally, the samples of water analysed can be considered of good quality. The relatively high sulphate and aluminium contents results from the use of aluminium sulphate as flocculent. The ammonia and Nitrite concentrations were lower than the detectable limit, because ammonia is converted into chloramines and nitrite is converted into Nitrate during chlorination. This indicates no sewage contamination of the drinking water. The high chloride contents can be referred to the use of partially degraded hypo for the disinfection. The presence of THM's in the samples analysed is indicative of good disinfection process. The presence of these compounds is preferred better than bacterial contamination. The relatively high levels of zinc and iron have no impact on the quality of DW. Iron, however, was efficiently removed during the treatment, together with Manganese. Reference was done to the EU specification of drinking water regarding total hardness, chloride contents, sulphate, iron and THM's. As for the iron content, the original pH of the river water (7.5 and 8.0) ensures that Iron should not be present in soluble form at a detectable level. Corrosion of the pipes could be one of the reasons for the presence of iron. Key Words: Drinking water quality, heavy metals, sulphate, Aluminium, Trihalomethans, hardness

Unintentional p-type conductivity in intrinsic Ge-rich SiGe/Ge heterostructures grown on Si(001)

In this work, we investigate the effective background charge density in intrinsic Si0.06Ge0.94/Ge plastically relaxed heterostructures deposited on Si(001). Hall effect measurements and capacitance–voltage profiling reveal a p-type conductivity in the nominally intrinsic layer with a hole concentration in the mid 1015 cm−3 range at temperatures between 50 and 200 K. In view of the carrier freeze out that we observe below 50 K, we attribute the origin of these carriers to the ionization of shallow acceptor-like defect states above the valence band. In addition, one dominant hole trap located at mid-gap position is found by deep level transient spectroscopy. Carrier trapping kinetics measurements can be interpreted as due to a combination of point defects, likely trapped in the strain field of extended defects, i.e., the threading dislocation

Current leakage mechanisms related to threading dislocations in Ge-rich SiGe heterostructures grown on Si(001)

This work investigates the role of threading dislocation densities (TDD) in the low density regime on the vertical transport in Si0.06Ge0.94 heterostructures integrated on Si(001). The use of unintentionally doped Si0.06Ge0.94 layers enables the study of the impact of grown-in threading dislocations (TD) without interaction with processing-induced defects originating, e.g., from dopant implantation. The studied heterolayers, while equal in composition, the degree of strain relaxation, and the thickness feature three different values for the TDD as 3 × 106, 9 × 106, and 2 × 107 cm−2. Current–voltage measurements reveal that leakage currents do not scale linearly with TDD. The temperature dependence of the leakage currents suggests a strong contribution of field-enhanced carrier generation to the current transport with the trap-assisted tunneling via TD-induced defect states identified as the dominant transport mechanism at room temperature. At lower temperatures and at high electric fields, direct band-to-band tunneling without direct interactions with defect levels becomes the dominating type of transport. Leakage currents related to emission from mid-gap traps by the Shockley–Read–Hall (SRH) generation are observed at higher temperatures (>100 °C). Here, we see a reduced contribution coming from SRH in our material, featuring the minimal TDD (3 × 106 cm−2), which we attribute to a reduction in point defect clusters trapped in the TD strain fields

The Cholecystectomy As A Day Case (CAAD) Score: A Validated Score of Preoperative Predictors of Successful Day-Case Cholecystectomy Using the CholeS Data Set

Background Day-case surgery is associated with significant patient and cost benefits. However, only 43% of cholecystectomy patients are discharged home the same day. One hypothesis is day-case cholecystectomy rates, defined as patients discharged the same day as their operation, may be improved by better assessment of patients using standard preoperative variables. Methods Data were extracted from a prospectively collected data set of cholecystectomy patients from 166 UK and Irish hospitals (CholeS). Cholecystectomies performed as elective procedures were divided into main (75%) and validation (25%) data sets. Preoperative predictors were identified, and a risk score of failed day case was devised using multivariate logistic regression. Receiver operating curve analysis was used to validate the score in the validation data set. Results Of the 7426 elective cholecystectomies performed, 49% of these were discharged home the same day. Same-day discharge following cholecystectomy was less likely with older patients (OR 0.18, 95% CI 0.15–0.23), higher ASA scores (OR 0.19, 95% CI 0.15–0.23), complicated cholelithiasis (OR 0.38, 95% CI 0.31 to 0.48), male gender (OR 0.66, 95% CI 0.58–0.74), previous acute gallstone-related admissions (OR 0.54, 95% CI 0.48–0.60) and preoperative endoscopic intervention (OR 0.40, 95% CI 0.34–0.47). The CAAD score was developed using these variables. When applied to the validation subgroup, a CAAD score of ≤5 was associated with 80.8% successful day-case cholecystectomy compared with 19.2% associated with a CAAD score >5 (p < 0.001). Conclusions The CAAD score which utilises data readily available from clinic letters and electronic sources can predict same-day discharges following cholecystectomy

Unsteady rotational flows of an Oldroyd-B fluid due to tension on the boundary

Unsteady Taylor–Couette flows of an Oldroyd-B fluid, which fills a straight circular cylinder of radius R, are studied. Flows are generated by the oscillating azimuthal tension which is given on the cylinder surface. As a novelty, authors used in this paper the governing equation related to the tension field. The closed forms of the shear stress and velocity fields corresponding to the flow problems are obtained by means of the integral transforms method. Expressions for the azimuthal tension and fluid velocity were written as sums between the “permanent component” (the steady-state component) and the transient component. By customizing values of parameters from the mathematical model were obtained the corresponding solutions of other types of fluids, namely, Maxwell fluids. By using numerical simulations and diagrams of the azimuthal stress, the fluid behavior has been analyzed. The necessary time to achieve the “steady-state” was, also, determined

SEMEN CHARACTERISTICS OF CROSSBRED (FRIESIAN X SAHIW AL) AND SAHIWAL YOUNG BULLS MAINT AINED UNDER SUB-TROPICAL CONDITIONS OF PUNJAB

Comparative studies of semen characteristics were carried out in 50% crossbred (Friesian X Sahiwal) and purebred Sahiwal young bulls maintained under sub-tropical conditions at Research Institute of Physiology of Animal Reproduction, Bhunikey and Semen Production Unit. Qadirabad, respectively. Semen was collected on weekly intervals for a period of one year. The semen characteristics (mean+SE), i.e., volume per ejaculate (ml), mass motility (0-5 score), individual motility of spermatozoa (%), dead and abnormal spermatozoa (%) were 5.62+0.14, 1.25+0.04, 50.50+0.93, 25.78+0.91 and 27.15+0.97, respectively in crossbred bulls. The corresponding values for these semen characteristics in Sahiwal bulls were 3.64+0.09, 1.36+0.04, 60.55+ 0.33, 27.73+0.87 and 15.41+0.86, respectively. These semen parameters differed significantly (P<0.05) between crossbred and Sahiwal bulls. It may be concluded from this study that the semen characteristics in crossbred (Friesian x Sahiwal) bulls ~'ere poorer than purebred Sahiwal bulls