529 research outputs found
Recommended from our members
Where do electronic markets come from? Regulation and the transformation of financial exchanges
The practices of high-frequency trading (HFT) are dependent on automated financial markets, especially those produced by securities exchanges electronically interconnected with competing exchanges. How did this infrastructural and organizational state of affairs come to be? Employing the conceptual distinction between fixed-role and switch-role markets, we analyse the discourse surrounding the design and eventual approval of the Securities and Exchange Commission’s Regulation of Exchanges and Alternative Trading Systems (Reg ATS). We find that the disruption of the exchange industry at the hands of automated markets was produced through an interweaving of both technological and political change. This processual redefinition of the ‘exchange’, in addition, may provide a suggestive precedent for understanding contemporary regulatory crises generated by other digital marketplace platforms
Combined electrochemistry and Raman spectroscopy of heme proteins
Gooijer, C. [Promotor]Zwan, G. van der [Copromotor
An Ultra-Stable Referenced Interrogation System in the Deep Ultraviolet for a Mercury Optical Lattice Clock
We have developed an ultra-stable source in the deep ultraviolet, suitable to
fulfill the interrogation requirements of a future fully-operational lattice
clock based on neutral mercury. At the core of the system is a Fabry-P\'erot
cavity which is highly impervious to temperature and vibrational perturbations.
The mirror substrate is made of fused silica in order to exploit the
comparatively low thermal noise limits associated with this material. By
stabilizing the frequency of a 1062.6 nm Yb-doped fiber laser to the cavity,
and including an additional link to LNE-SYRTE's fountain primary frequency
standards via an optical frequency comb, we produce a signal which is both
stable at the 1E-15 level in fractional terms and referenced to primary
frequency standards. The signal is subsequently amplified and frequency-doubled
twice to produce several milliwatts of interrogation signal at 265.6 nm in the
deep ultraviolet.Comment: 7 pages, 6 figure
Ultralow phase noise microwave generation with an Er:fiber-based optical frequency divider
We present an optical frequency divider based on a 200 MHz repetition rate
Er:fiber mode-locked laser that, when locked to a stable optical frequency
reference, generates microwave signals with absolute phase noise that is equal
to or better than cryogenic microwave oscillators. At 1 Hz offset from a 10 GHz
carrier, the phase noise is below -100 dBc/Hz, limited by the optical
reference. For offset frequencies > 10 kHz, the phase noise is shot noise
limited at -145 dBc/Hz. An analysis of the contribution of the residual noise
from the Er:fiber optical frequency divider is also presented.Comment: 4 pages, 3 figure
Ultrastable lasers based on vibration insensitive cavities
We present two ultra-stable lasers based on two vibration insensitive cavity
designs, one with vertical optical axis geometry, the other horizontal.
Ultra-stable cavities are constructed with fused silica mirror substrates,
shown to decrease the thermal noise limit, in order to improve the frequency
stability over previous designs. Vibration sensitivity components measured are
equal to or better than 1.5e-11 per m.s^-2 for each spatial direction, which
shows significant improvement over previous studies. We have tested the very
low dependence on the position of the cavity support points, in order to
establish that our designs eliminate the need for fine tuning to achieve
extremely low vibration sensitivity. Relative frequency measurements show that
at least one of the stabilized lasers has a stability better than 5.6e-16 at 1
second, which is the best result obtained for this length of cavity.Comment: 8 pages 12 figure
Amplitude to phase conversion of InGaAs pin photo-diodes for femtosecond lasers microwave signal generation
When a photo-diode is illuminated by a pulse train from a femtosecond laser,
it generates microwaves components at the harmonics of the repetition rate
within its bandwidth. The phase of these components (relative to the optical
pulse train) is known to be dependent on the optical energy per pulse. We
present an experimental study of this dependence in InGaAs pin photo-diodes
illuminated with ultra-short pulses generated by an Erbium-doped fiber based
femtosecond laser. The energy to phase dependence is measured over a large
range of impinging pulse energies near and above saturation for two typical
detectors, commonly used in optical frequency metrology with femtosecond laser
based optical frequency combs. When scanning the optical pulse energy, the
coefficient which relates phase variations to energy variations is found to
alternate between positive and negative values, with many (for high harmonics
of the repetition rate) vanishing points. By operating the system near one of
these vanishing points, the typical amplitude noise level of commercial-core
fiber-based femtosecond lasers is sufficiently low to generate state-of-the-art
ultra-low phase noise microwave signals, virtually immune to amplitude to phase
conversion related noise.Comment: 7 pages, 6 figures, submitted to Applied Physics
Ultra-low noise microwave generation with fiber-based optical frequency comb and application to atomic fountain clock
We demonstrate the use of a fiber-based femtosecond laser locked onto an
ultra-stable optical cavity to generate a low-noise microwave reference signal.
Comparison with both a liquid Helium cryogenic sapphire oscillator (CSO) and a
Ti:Sapphire-based optical frequency comb system exhibit a stability about
between 1 s and 10 s. The microwave signal from the fiber
system is used to perform Ramsey spectroscopy in a state-of-the-art Cesium
fountain clock. The resulting clock system is compared to the CSO and exhibits
a stability of . Our continuously operated
fiber-based system therefore demonstrates its potential to replace the CSO for
atomic clocks with high stability in both the optical and microwave domain,
most particularly for operational primary frequency standards.Comment: 3 pages, 3 figure
Ethylene Forming Activity from ACC in Citrus Leaf Discs: Influence of Light and Darkness
The influence of light and darkness incubation on ethylene forming activity from 1-aminocyclopropane-1-carboxylic acid (ACC) in citrus (Citrus sinensis L. Osbeck cv. 'Salustiana) mature leaf discs was studied. Leaf discs incubated 48 hours inlight produced 20 times greater ethylene than in darkness. Twenty-four hours light and darkness alternative incubations were carried out. In any case, transference of discs from the light to the dark resulted in inhibition of ethylene forming activity. Effects of DCMU (3-(3,4-
dichlorophenyl)-1,1-dimethylurea, inhibitor of photosynthetic electron flow) and KCN (inhibitor of cytochrome oxidase) were studied,, DCMU at 0.1 mM concentration inhibited ethylene forming activity after 48 h incubation in light at 95%.However, ethylene forming activity was not affected by DCMU in the dark. On the other hand, 1mMKCN stimulated considerably ethylene forming activity both in the light and dark. Incubation in a CO, enriched atmosphere did not affect ethylene forming activity in light. Therefore, respiratory CO, release could not be the responsible of ethylene forming activity inhibition in the dark. Increase on ethylene production in light from ACC in mature leaf discs is related with the ethylene forming enzyme (EFE) because of CO, + ion
(inhibitor of EFE activity) reduced highly ethylene production from ACC both in the light and dark. Likewise mannitol (stimulator of EFE activity and ACC synthesis) enhanced ethylene production from ACC both in the light and in the dark. Cycloheximide (inhibitor of protein synthesis) also inhibited ethylene production from ACC. Therefore, enzyme synthesis could be required for the ethylene forming activity from ACC
- …