6,331 research outputs found
Radial Trends in IMF-Sensitive Absorption Features in Two Early-Type Galaxies: Evidence for Abundance-Driven Gradients
Samples of early-type galaxies show a correlation between stellar velocity
dispersion and the stellar initial mass function (IMF) as inferred from
gravity-sensitive absorption lines in the galaxies' central regions. To search
for spatial variations in the IMF, we have observed two early-type galaxies
with Keck/LRIS and measured radial gradients in the strengths of absorption
features from 4000-5500 \AA and 8000-10,000 \AA. We present spatially
resolved measurements of the dwarf-sensitive spectral indices NaI (8190 \AA)
and Wing-Ford FeH (9915 \AA), as well as indices for species of H, C, CN,
Mg, Ca, TiO, and Fe. Our measurements show a metallicity gradient in both
objects, and Mg/Fe consistent with a shallow gradient in \alpha-enhancement,
matching widely observed trends for massive early-type galaxies. The NaI index
and the CN index at 4160 \AA exhibit significantly steeper gradients,
with a break at ( pc). Inside this radius
NaI strength increases sharply toward the galaxy center, consistent with a
rapid central rise in [Na/Fe]. In contrast, the ratio of FeH to Fe index
strength decreases toward the galaxy center. This behavior cannot be reproduced
by a steepening IMF inside if the IMF is a single power law.
While gradients in the mass function above may occur,
exceptional care is required to disentangle these IMF variations from the
extreme variations in individual element abundances near the galaxies' centers.Comment: Accepted for publication in ApJ. Updates from v1 include an expanded
comparison of measured index strengths to SPS models. 20 page body + 7 page
appendix + references. Includes 25 figure
Determination of failure limits for sterilizable solid rocket motor
A structural evaluation to establish probable failure limits and a series of environmental tests involving temperature cycling, sustained acceleration, and vibration were conducted on an 18-inch diameter solid rocket motor. Despite the fact that thermal, acceleration and vibration loads representing a severe overtest of conventional environmental requirements were imposed on the sterilizable motor, no structural failure of the grain or flexible support system was detected. The following significant conclusions are considered justified. It is concluded that: (1) the flexible grain retention system, which permitted heat sterilization at 275 F on the test motor, can readily be adopted to meet the environmental requirements of an operational motor design, and (2) if further substantiation of structural integrity is desired, the motor used is considered acceptable for static firing
Development of the NASA VALT digital navigation system
The research to develop and fabricate a terminal area navigation system for use in the NASA VTOL Approach and Landing Technology (VALT) program. The results of that effort are reported. The navigation system developed and fabricated was based on a general purpose airborne digital computer. A set of flight hardware units was fabricated to create the necessary analog, digital and human interface with the computer. A comprehensive package of software was created to implement the control and guidance laws required for automatic and flight director approaches that are curved in two planes. A technique was developed that enables the generation of randomly shaped lateral paths from simple input data. The lateral path concept combines straight line and elliptical-curved segments to fit a continuous curved path to the data points. A simple, fixed base simulation was put together to assist in developing and evaluating the system. The simulation was used to obtain system performance data during simulated curved-path approaches
Hard X‐ray polarimetry of solar flares with BATSE
We describe a technique for measuring the polarization of hard X‐rays from solar flares based on the angular distribution of that portion of the flux which is scattered off the top of the Earth’s atmosphere. The scattering cross section depends not only on the scatter angle itself, but on the orientation of the scatter angle with respect to the incident polarization vector. Consequently, the distribution of the observed albedo flux will depend on the direction and the polarization properties (i.e., the level of polarization and polarization angle) of the source. Since the albedo component can represent a relatively large fraction (up to 40%) of the direct source flux, there will generally be sufficient signal for making such a measurement. The sensitivity of this approach is therefore dictated by the effective area and the ability of a detector system to ‘image’ the albedo flux. The 4π coverage of the BATSE detectors on the Compton Gamma‐RayObservatory provides an opportunity to measure both the direct and the albedo flux from a given solar flare event. Although the BATSE design (with its large field‐of‐view for each detector) is not optimized for albedo polarimetry, we have nonetheless investigated the feasibility of this technique using BATSE data
The design of a gamma‐ray burst polarimeter
The study of the polarization properties of the gamma‐ray bursts is the one remaining unexplored avenue of research which may help to answer some of the fundamental problems regarding the nature of these mysterious objects. We have designed an instrument to measure linear polarization in cosmic gamma‐ray bursts at energies ≳50 keV. Here we describe the design of this instrument, which we call the Gamma‐ray Burst Polarimeter Experiment (GRAPE)
Using BATSE to measure gamma-ray burst polarization
We describe a technique for measuring the polarization of hard x-rays from γ-ray bursts based on the angular distribution of that portion of the flux which is scattered off the top of the Earth’s atmosphere. The scattering cross section depends not only on the scatter angle itself, but on the orientation of the scatter angle with respect to the incident polarization vector. Consequently, the distribution of the observed albedo flux will depend on the direction and the polarization properties (i.e., the level of polarization and polarization angle) of the source. Although the BATSE design (with its large field-of-view for each detector) is not optimized for albedo polarimetry, we have nonetheless investigated the feasibility of this technique using BATSE data
A technique for generating arbitrarily shaped curved approach paths
A technique for creating and using arbitrarily curved flight paths is described, in conjunction with either automatic or manual guidance. Operating techniques for VTOL aircraft in the terminal area environment are investigated. Straight lines and elliptical segments to connect a series of data points into a continous approach path were developed. Software was created to allow the generation of arbitrarily shaped altitude and speed profiles in conjunction with the lateral curved paths
Study for incorporating time-synchronized approach control into the CH-47/VALT digital navigation system
Techniques for obtaining time synchronized (4D) approach control in the VALT research helicopter is described. Various 4D concepts and their compatibility with the existing VALT digital computer navigation and guidance system hardware and software are examined. Modifications to various techniques were investigated in order to take advantage of the unique operating characteristics of the helicopter in the terminal area. A 4D system is proposed, combining the direct to maneuver with the existing VALT curved path generation capability
Molecular ferroelectric contributions to anomalous hysteresis in hybrid perovskite solar cells
We report a model describing the molecular orientation disorder in
CH3NH3PbI3, solving a classical Hamiltonian parametrised with electronic
structure calculations, with the nature of the motions informed by ab-initio
molecular dynamics. We investigate the temperature and static electric field
dependence of the equilibrium ferroelectric (molecular) domain structure and
resulting polarisability. A rich domain structure of twinned molecular dipoles
is observed, strongly varying as a function of temperature and applied electric
field. We propose that the internal electrical fields associated with
microscopic polarisation domains contribute to hysteretic anomalies in the
current--voltage response of hybrid organic-inorganic perovskite solar cells
due to variations in electron-hole recombination in the bulk.Comment: 10 pages; 4 figures, 2 SI figure
- …