210 research outputs found
Recommended from our members
Integrated filtering-antenna with controllable frequency bandwidth
An integrated design of a band-pass filter and a patch antenna is proposed in this paper by using an aperture coupled structure. Traditionally, the microwave filter and antenna are designed separately using 50 Ohm interface and then connected by transmission lines, which lead to a large size and more loss. Here, the antenna and microwave filter are directly integrated without a 50 Ohm interface between them. Compared with the traditional cascade designing, the co-design of filter and antenna has a more compact size, simpler configuration, improved frequency selectivity and higher system efficiency. The frequency bandwidth also can be controlled by adjusting the dimension of the coupling aperture in the ground. The measured results agree very well with the simulations, showing the filtering-antenna has good performance in impedance matching, radiation pattern and antenna gain
Circular polarised antenna fabricated with low-cost 3D and inkjet printing equipment
The fabrication of a patch antenna using low-cost 3D printing equipment is presented. A circular polarised (CP) patch antenna is manufactured by combining inkjet printing and stereolithography (SLA) technology. The substrate has been fabricated by curing photosensitive resin while the patch element of the antenna has been inkjet printed using silver ink. The printed antenna satisfies the required reflection coefficient, axial ratio and radiation pattern at 1575 MHz. The aim is to demonstrate an inexpensive technology that could be used for the fabrication of antennas on customised 3D printed substrates. The performance of the antenna is summarised through simulations and experimental results
Partial wave analysis of J/\psi \to \gamma \phi \phi
Using events collected in the BESII detector, the
radiative decay is
studied. The invariant mass distribution exhibits a near-threshold
enhancement that peaks around 2.24 GeV/.
A partial wave analysis shows that the structure is dominated by a
state () with a mass of
GeV/ and a width of GeV/. The
product branching fraction is: .Comment: 11 pages, 4 figures. corrected proof for journa
Measurements of the observed cross sections for exclusive light hadrons containing at , 3.650 and 3.6648 GeV
By analyzing the data sets of 17.3, 6.5 and 1.0 pb taken,
respectively, at , 3.650 and 3.6648 GeV with the BES-II
detector at the BEPC collider, we measure the observed cross sections for
, , ,
and at the three energy
points. Based on these cross sections we set the upper limits on the observed
cross sections and the branching fractions for decay into these
final states at 90% C.L..Comment: 7 pages, 2 figure
Direct Measurements of Absolute Branching Fractions for D0 and D+ Inclusive Semimuonic Decays
By analyzing about 33 data sample collected at and around 3.773
GeV with the BES-II detector at the BEPC collider, we directly measure the
branching fractions for the neutral and charged inclusive semimuonic decays
to be and , and determine the ratio of the two branching
fractions to be
A study of charged kappa in
Based on events collected by BESII, the decay
is studied. In the invariant mass
spectrum recoiling against the charged , the charged
particle is found as a low mass enhancement. If a Breit-Wigner function of
constant width is used to parameterize the kappa, its pole locates at MeV/. Also in this channel,
the decay is observed for the first time.
Its branching ratio is .Comment: 14 pages, 4 figure
Partial Wave Analysis of
BES data on are presented. The
contribution peaks strongly near threshold. It is fitted with a
broad resonance with mass MeV, width MeV. A broad resonance peaking at 2020 MeV is also required
with width MeV. There is further evidence for a component
peaking at 2.55 GeV. The non- contribution is close to phase
space; it peaks at 2.6 GeV and is very different from .Comment: 15 pages, 6 figures, 1 table, Submitted to PL
Measurements of the observed cross sections for exclusive light hadron production in e^+e^- annihilation at \sqrt{s}= 3.773 and 3.650 GeV
By analyzing the data sets of 17.3 pb taken at GeV
and 6.5 pb taken at GeV with the BESII detector at the
BEPC collider, we have measured the observed cross sections for 12 exclusive
light hadron final states produced in annihilation at the two energy
points. We have also set the upper limits on the observed cross sections and
the branching fractions for decay to these final states at 90%
C.L.Comment: 8 pages, 5 figur
Search for the Rare Decays J/Psi --> Ds- e+ nu_e, J/Psi --> D- e+ nu_e, and J/Psi --> D0bar e+ e-
We report on a search for the decays J/Psi --> Ds- e+ nu_e + c.c., J/Psi -->
D- e+ nu_e + c.c., and J/Psi --> D0bar e+ e- + c.c. in a sample of 5.8 * 10^7
J/Psi events collected with the BESII detector at the BEPC. No excess of signal
above background is observed, and 90% confidence level upper limits on the
branching fractions are set: B(J/Psi --> Ds- e+ nu_e + c.c.)<4.8*10^-5, B(J/Psi
--> D- e+ nu_e + c.c.) D0bar e+ e- + c.c.)<1.1*10^-5Comment: 10 pages, 4 figure
Measurements of psi(2S) decays to octet baryon-antibaryon pairs
With a sample of 14 million psi(2S) events collected by the BESII detector at
the Beijing Electron Positron Collider (BEPC), the decay channels psi(2S)->p
p-bar, Lambda Lambda-bar, Sigma0 Sigma0-bar, Xi Xi-bar are measured, and their
branching ratios are determined to be (3.36+-0.09+-0.24)*10E-4,
(3.39+-0.20+-0.32)*10E-4, (2.35+-0.36+-0.32)*10E-4, (3.03+-0.40+-0.32)*10E-4,
respectively. In the decay psi(2S)->p p-bar, the angular distribution parameter
alpha is determined to be 0.82+-0.17+-0.04.Comment: 8 pages, 8 figure
- …