Three-nucleon mechanisms in photoreactions

The $^{12}$C$(\gamma,ppn)$ reaction has been measured for E$_{\gamma}$=150-800 MeV in the first study of this reaction in a target heavier than $^3$He. The experimental data are compared to a microscopic many body calculation. The model, which predicts that the largest contribution to the reaction arises from final state interactions following an initial pion production process, overestimates the measured cross sections and there are strong indications that the overestimate arises in this two-step process. The selection of suitable kinematic conditions strongly suppresses this two-step contribution leaving cross sections in which up to half the yield is predicted to arise from the absorption of the photon on three interacting nucleons and which agree with the model. The results indicate $(\gamma,3N)$ measurements on nuclei may be a valuable tool for obtaining information on the nuclear three-body interaction.Comment: 5 pages, 3 figure

Mode identification in rapidly rotating stars

Context: Recent calculations of pulsation modes in rapidly rotating polytropic models and models based on the Self-Consistent Field method have shown that the frequency spectrum of low degree pulsation modes can be described by an empirical formula similar to Tassoul's asymptotic formula, provided that the underlying rotation profile is not too differential. Aims: Given the simplicity of this asymptotic formula, we investigate whether it can provide a means by which to identify pulsation modes in rapidly rotating stars. Methods: We develop a new mode identification scheme which consists in scanning a multidimensional parameter space for the formula coefficients which yield the best-fitting asymptotic spectra. This mode identification scheme is then tested on artificial spectra based on the asymptotic formula, on random frequencies and on spectra based on full numerical eigenmode calculations for which the mode identification is known beforehand. We also investigate the effects of adding random frequencies to mimic the effects of chaotic modes which are also expected to show up in such stars. Results: In the absence of chaotic modes, it is possible to accurately find a correct mode identification for most of the observed frequencies provided these frequencies are sufficiently close to their asymptotic values. The addition of random frequencies can very quickly become problematic and hinder correct mode identification. Modifying the mode identification scheme to reject the worst fitting modes can bring some improvement but the results still remain poorer than in the case without chaotic modes

The potential for dietary factors to prevent or treat osteoarthritis

Osteoarthritis (OA) is a degenerative joint disease for which there are no disease-modifying drugs. It is a leading cause of disability in the UK. Increasing age and obesity are both major risk factors for OA and the health and economic burden of this disease will increase in the future. Focusing on compounds from the habitual diet that may prevent the onset or slow the progression of OA is a strategy that has been under-investigated to date. An approach that relies on dietary modification is clearly attractive in terms of risk/benefit and more likely to be implementable at the population level. However, before undertaking a full clinical trial to examine potential efficacy, detailed molecular studies are required in order to optimise the design. This review focuses on potential dietary factors that may reduce the risk or progression of OA, including micronutrients, fatty acids, flavonoids and other phytochemicals. It therefore ignores data coming from classical inflammatory arthritides and nutraceuticals such as glucosamine and chondroitin. In conclusion, diet offers a route by which the health of the joint can be protected and OA incidence or progression decreased. In a chronic disease, with risk factors increasing in the population and with no pharmaceutical cure, an understanding of this will be crucial

Cooling or Warming the Esophagus to Reduce Esophageal Injury During Left Atrial Ablation in the Treatment of Atrial Fibrillation.

Ablation of the left atrium using either radiofrequency (RF) or cryothermal energy is an effective treatment for atrial fibrillation (AF) and is the most frequent type of cardiac ablation procedure performed. Although generally safe, collateral injury to surrounding structures, particularly the esophagus, remains a concern. Cooling or warming the esophagus to counteract the heat from RF ablation, or the cold from cryoablation, is a method that is used to reduce thermal esophageal injury, and there are increasing data to support this approach. This protocol describes the use of a commercially available esophageal temperature management device to cool or warm the esophagus to reduce esophageal injury during left atrial ablation. The temperature management device is powered by standard water-blanket heat exchangers, and is shaped like a standard orogastric tube placed for gastric suctioning and decompression. Water circulates through the device in a closed-loop circuit, transferring heat across the silicone walls of the device, through the esophageal wall. Placement of the device is analogous to the placement of a typical orogastric tube, and temperature is adjusted via the external heat-exchanger console

Excitations in the Halo Nucleus He-6 Following The Li-7(gamma,p)He-6 Reaction

A broad excited state was observed in 6-He with energy E_x = 5 +/- 1 MeV and width Gamma = 3 +/- 1 MeV, following the reaction Li-7(gamma,p)He-6. The state is consistent with a number of broad resonances predicted by recent cluster model calculations. The well-established reaction mechanism, combined with a simple and transparent analysis procedure confers considerable validity to this observation.Comment: 3 pages of LaTeX, 3 figures in PostScript, approved for publication in Phys. Rev. C, August, 200

Multivariate statistical process control based on principal component analysis: implementation of framework in R

The interest in multivariate statistical process control (MSPC) has increased as the industrial processes have become more complex. This paper presents an industrial process involving a plastic part in which, due to the number of correlated variables, the inversion of the covariance matrix becomes impossible, and the classical MSPC cannot be used to identify physical aspects that explain the causes of variation or to increase the knowledge about the process behaviour. In order to solve this problem, a Multivariate Statistical Process Control based on Principal Component Analysis (MSPC-PCA) approach was used and an R code was developed to implement it according some commercial software used for this purpose, namely the ProMV (c) 2016 from ProSensus, Inc. (www.prosensus.ca). Based on used dataset, it was possible to illustrate the principles of MSPC-PCA. This work intends to illustrate the implementation of MSPC-PCA in R step by step, to help the user community of R to be able to perform it.FCT - Fundação para a Ciência e a Tecnologia(UID/CEC/00319/2013

Characterisation and statistical analysis of breakdown data for a corona-stabilised switch in environmentally-friendly gas mixtures

Characterisation of a corona-stabilised switch in the single-shot regime, including triggering range, delay times and jitter is reported, over the pressure range 0-3 bar gauge, as a continuation of work from similar characterisation with this switch filled with SF6 with different gap spacings. When filled with mixtures of HFO-1234ze and N2, the breakdown voltage can be increased by up to ~306% and ~191% under negative and positive polarity, respectively, of that using 100% N2. These results were achieved with gas mixtures consisting of 80% N2 and 20% HFO-1234ze, by pressure. The maximum negative polarity triggering range was 13.6 kV, comparable to that achieved previously using SF6. The measured delay time and calculated jitter was generally found to increase with increasing pressure, and with increasing percentage (from 5% to 20%) of HFO-1234ze in the gas mixtures. Von Laue statistical analysis of time-to-breakdown data showed that both the formative time and statistical time increased with increasing pressure, and with increasing percentage of HFO-1234ze in the gas mixtures. The formative time under negative polarity was significantly longer than that for positive polarity. The results indicate that HFO-1234ze may be considered as a suitable candidate to replace SF6 for switching applications, although there are some operational observations that require further investigation

Icosahedral metallacarborane/carborane species derived from 1,1′-bis(o-carborane)

We thank ORSAS (GS) and the EPSRC (DE and DMcK supported by project EP/E02971X/1, WYM supported by project EP/I031545/1) for funding.Examples of singly-metallated derivatives of 1,1[prime or minute]-bis(o-carborane) have been prepared and spectroscopically and structurally characterised. Metallation of [7-(1[prime or minute]-1[prime or minute],2[prime or minute]-closo-C2B10H11)-7,8-nido-C2B9H10]2- with a {Ru(p-cymene)}2+ fragment affords both the unisomerised species [1-(1[prime or minute]-1[prime or minute],2[prime or minute]-closo-C2B10H11)-3-(p-cymene)-3,1,2-closo-RuC2B9H10] (2) and the isomerised [8-(1[prime or minute]-1[prime or minute],2[prime or minute]-closo-C2B10H11)-2-(p-cymene)-2,1,8-closo-RuC2B9H10] (3), and 2 is easily transformed into 3 with mild heating. Metallation with a preformed {CoCp}2+ fragment also affords a 3,1,2-MC2B9-1[prime or minute],2[prime or minute]-C2B10 product [1-(1[prime or minute]-1[prime or minute],2[prime or minute]-closo-C2B10H11)-3-Cp-3,1,2-closo-CoC2B9H10] (4), but if CoCl2/NaCp is used followed by oxidation the result is the 2,1,8-CoC2B9-1[prime or minute],2[prime or minute]-C2B10 species [8-(1[prime or minute]-1[prime or minute],2[prime or minute]-closo-C2B10H11)-2-Cp-2,1,8-closo-CoC2B9H10] (5). Compound 4 does not convert into 5 in refluxing toluene, but does do so if it is reduced and then reoxidised, perhaps highlighting the importance of the basicity of the metal fragment in the isomerisation of metallacarboranes. A computational study of 1,1[prime or minute]-bis(o-carborane) is in excellent agreement with a recently-determined precise crystallographic study and establishes that the {1[prime or minute],2[prime or minute]-closo-C2B10H11} fragment is electron-withdrawing compared to H.Publisher PDFPeer reviewe