Arcjet component conditions through a multistart test

A low power, dc arcjet thruster was tested for starting reliability using hydrogen-nitrogen mixtures simulating the decomposition products of hydrazine. More than 300 starts were accumulated in phases with extended burn-in periods interlaced. A high degree of flow stabilization was built into the arcjet and the power supply incorporated both rapid current regulation and a high voltage, pulsed starting circuit. A nominal current level of 10 A was maintained throughout the test. Photomicrographs of the cathode tip showed a rapid recession to a steady-state operating geometry. A target of 300 starts was selected, as this represents significantly more than anticipated (150 to 240), in missions of 10 yr or less duration. Weighings showed no apparent mass loss. Some anode erosion was observed, particularly at the entrance to the constrictor. This was attributed to the brief period during startup the arc mode attachment point spends in the high pressure region upstream of the nozzle. Based on the results obtained, startup does not appear to be performance or life limiting for the number of starts typical of operational satellite applications

High-power hydrogen arcjet performance

A hydrogen arcjet was operated at power levels ranging from 5 to 30 kW with three different nozzle geometries. Test results using all three nozzle geometries are reported and include variations of specific impulse with flow rate, and thrust with power. Geometric variables investigated included constrictor diameter, length, and diverging exit angle. The nozzle with a constrictor diameter of 1.78 mm and divergence angle of 20 degrees was found to give the highest performance. A specific impulse of 1460 s was attained with this nozzle at a thrust efficiency of 29.8 percent. The best efficiency measured was 34.4 percent at a specific impulse of 1045 s. Post test examination of the cathode showed erosion after 28 hours of operation to be small, and limited to the conical tip where steady state arc attachment occurred. Each nozzle was tested to destruction

Arcjet starting reliability: A multistart test on hydrogen/nitrogen mixtures

An arcjet starting reliability test was performed to investigate one feasibility issue in the use of arcjets onboard a satellite for north-south stationkeeping. A 1 kW arcjet was run on hydrogen/nitrogen gas mixtures simulating decomposed hydrazine. A pulse width modulated power supply with an integral high voltage starting pulser was used for arc ignition and steady-state operation. The test was performed in four phases in order to determine if starting characteristics changed as a result of long term thruster operation. More than 300 successful starts were accumulated over an operating time of 18 hrs. Overall results indicate that there is a link between starting characteristics and long term thruster operation; however, the large number of starts had no effect on steady-state performance

Vehicles Recognition Using Fuzzy Descriptors of Image Segments

In this paper a vision-based vehicles recognition method is presented. Proposed method uses fuzzy description of image segments for automatic recognition of vehicles recorded in image data. The description takes into account selected geometrical properties and shape coefficients determined for segments of reference image (vehicle model). The proposed method was implemented using reasoning system with fuzzy rules. A vehicles recognition algorithm was developed based on the fuzzy rules describing shape and arrangement of the image segments that correspond to visible parts of a vehicle. An extension of the algorithm with set of fuzzy rules defined for different reference images (and various vehicle shapes) enables vehicles classification in traffic scenes. The devised method is suitable for application in video sensors for road traffic control and surveillance systems.Comment: The final publication is available at http://www.springerlink.co

Exploring the critical success factors of virtual-agile IT projects: a grounded theory study

Business dynamics and competition have necessitated IT organizations to use virtual style of working depending on the principles of agile methods. Virtual-agile IT projects are most relevant in the context of software and web development, new product development and information system projects. Organizations where fulfilling the demands of clients, face several complexities during projects; mainly obstructed by differences in location, time, culture and working dynamics etc. This paper aims to explore some useful practices undertaken in IT industry to deal with such criticalities. The research uses qualitative methods and grounded theory methodology to generate emerging themes recognized as codes or concepts; which were further transformed into categories based on their properties and dimensions. Categories or sub-categories identified were arranged using coding paradigm which helped to identify a core-category. Consequently, the relationships were refined, arranged in a unique way in selective coding phase and a storyline was generated elaborating the relationships between various categories, sub-categories and concepts. Finally, a conclusion is made and recommendations are proposed for future research

Derivation of phenomenological expressions for transition matrix elements for electron-phonon scattering

In the literature on electron-phonon scatterings very often a phenomenological expression for the transition matrix element is used which was derived in the textbooks of Ashcroft/Mermin and of Czycholl. There are various steps in the derivation of this expression. In the textbooks in part different arguments have been used in these steps, but the final result is the same. In the present paper again slightly different arguments are used which motivate the procedure in a more intuitive way. Furthermore, we generalize the phenomenological expression to describe the dependence of the matrix elements on the spin state of the initial and final electron state

BSAURUS- A Package For Inclusive B-Reconstruction in DELPHI

BSAURUS is a software package for the inclusive reconstruction of B-hadrons in Z-decay events taken by the DELPHI detector at LEP. The BSAURUS goal is to reconstruct B-decays, by making use of as many properties of b-jets as possible, with high efficiency and good purity. This is achieved by exploiting the capabilities of the DELPHI detector to their extreme, applying wherever possible physics knowledge about B production and decays and combining different information sources with modern tools- mainly artificial neural networks. This note provides a reference of how BSAURUS outputs are formed, how to access them within the DELPHI framework, and the physics performance one can expect.Comment: 52 pages, 24 figures, added author Z.

Effective Constraints for Relativistic Quantum Systems

Determining the physical Hilbert space is often considered the most difficult but crucial part of completing the quantization of a constrained system. In such a situation it can be more economical to use effective constraint methods, which are extended here to relativistic systems as they arise for instance in quantum cosmology. By side-stepping explicit constructions of states, such tools allow one to arrive much more feasibly at results for physical observables at least in semiclassical regimes. Several questions discussed recently regarding effective equations and state properties in quantum cosmology, including the spreading of states and quantum back-reaction, are addressed by the examples studied here.Comment: 27 pages, 2 figures; v2: new appendix comparing effective constraints and physical coherent states by an exampl

Balanced homodyne detectors in QFT

Within the dipole approximation we describe the interaction of a photodiode with the quantum electric field. The diode is modelled by an electron in a bound state which upon interaction, treated perturbatively in the paper, can get excited to one of the scattering states. We furthermore analyze a balanced homodyne detector (BHD) with a local oscillator (LO) consisting of two photodiodes illuminated by a monochromatic coherent state. We show, that to the leading order the BHD's output measures the expectation value of the quantum electric field, in the state without the LO, restricted to the frequency of the LO. The square of the output measures the two-point function of the quantum field. This shows that the BHDs provide tools for measurements of sub-vacuum (negative) expectation values of the squares quantum fields and thus for test of Quantum Energy Inequality - like bounds, or other QFT effects under the influence of external conditions.Comment: Revised version with minor mistakes remove

Variations in production per farm and per worker in Missouri, 1939

"In wartime, manpower is an item of scarcity and must be used as effectively as possible on farms as well as in factories and offices. Since the productivity of farm operators and workers varies widely from area to area within the United States and even within a particular state, it has become necessary to promote the shifting of workers and even farm operators from one area to another to make most efficient use of the manpower available for farm production. To assist those charged with the handling of Missouri farm labor problems in their determination of policies, information relative to differences in productivity of workers among the areas of the state is needed. Unfortunately, the latest data which may be used for these comparisons are those collected during the 1939 census. Although productivity has increased greatly since 1939, which makes the data presented appear out-of-date, it is expected that the relative position of counties and areas has not changed greatly. Thus, the material presented may be used to indicate the relative productivity of farm manpower within a county or area."--Pages 1-2