Study of the mechanical properties of a ceramics of orthopedic and dental use

The study of the preparation of ceramics is consisted in sintering a hardened cement, wich is composed of mixture of three calcium phosphates : tetracalcium phosphate (Ca4(PO4)2O), -tricalcium phosphate (-Ca3(PO4)2) and monocalcium phosphate (Ca(H2PO4)2.H2O).After wetting, the cement evolved towards an apatitic phase while hardening. To check the effect of certain factors on the resulting ceramics, a complete central composite design of four variables (liquid/solid ratio, stoichiometric coefficient of monocalcium phosphate, rate of increase in temperature and duration of landing of termpertaure) was set up. The equation of the model and optimal conditions were defined

A disaster-resilient multi-content optical datacenter network architecture

Cloud services based on datacenter networks are becoming very important. Optical networks are well suited to meet the demands set by the high volume of traffic between datacenters, given their high bandwidth and low-latency characteristics. In such networks, path protection against network failures is generally ensured by providing a backup path to the same destination, which is link-disjoint to the primary path. This protection fails to protect against disasters covering an area which disrupts both primary and backup resources. Also, content/service protection is a fundamental problem in datacenter networks, as the failure of a single datacenter should not cause the disappearance of a specific content/service from the network. Content placement, routing and protection of paths and content are closely related to one another, so the interaction among these should be studied together. In this work, we propose an integrated ILP formulation to design an optical datacenter network, which solves all the above-mentioned problems simultaneously. We show that our disaster protection scheme exploiting anycasting provides more protection, but uses less capacity, than dedicated single-link protection. We also show that a reasonable number of datacenters and selective content replicas with intelligent network design can provide survivability to disasters while supporting user demands

The Drought Effect on Seed Germination and Seedling Growth in Bread Wheat (Triticum Aestivum L.)

Drought is a major abiotic stress that threating the producing and survival of many crops such as cereal. Wheat is grown on arid lands and drought often causes serious problem in wheat production on these fields. In this study, it was determined that the effect of five different drought stress (0, -0.3, -0.6, -0.9, -1.2 MPa, by using PEG 6000 solution) on the germination of 4 different bread wheat cultivars (Tekin, Pehlivan, DZT13-1 and DZT13-2). The study was carried out according to completely randomized design in factorial arrangement with four replications. In the present study, important growth parameters like germination rate (%), seedling vigor (%), coleoptile length (cm), root length (cm) and shoot length (cm) were observed. Results showed when dose of PEG increased, seedling growth was significantly affected. Increasing drought stress was resulted with a decrease on germination rate, seedling vigor, coleoptile length, root length and shoot length

Sintesis Paduan Co-cr Menggunakan Metode Ultrasonik

Paduan Co-Cr merupakan material tahan suhu tinggi dan tahan korosi. Penelitian ini bertujuan mensistesis serbuk paduan Co-Cr dengan metode ultrasonik, kemudian dilanjutkan dengan proses sintering dalam kapsul kaca kuarsa. Iradiasi ultrasonik yang digunakan pada frekuensi 20 kHz dan amplitudo 40 % dengan komposisi Co : Cr sebesar 80 : 20.Waktu perlakuan sonikasi adalah selama 0 jam, 3 jam, 6 jam, 12 jam, 24 jam, dan 48 jamdalam larutan etanol. Setelah sonikasi selama 48 jam, fasa FCC dari Co mulai bertransformasi menjadi fasa HCP. Perlakuan ultrasonik terhadap campuran Co-Cr juga memberikan efek pengurangan ukuran partikel. Parameter kisi serbuk setelah ultrasonikasi 48 jam adalah: untuk HCP-Co a = b = 0,25074 nmdan c = 0,40699 nm, untuk FCC-Co a = b = c = 0,35411nm, dan untuk BCC-Cr a=b=c=0.28827 nm. Perlakuan ultrasonik selama 48 jam menhasilkan pembentukan paduan Co-Cr dengan persentasi berat sebesar 25,2124. Hasil sintering padatan Co-Cr menunjukkan parameter kisi HCP-Co memiliki nilai yaitu a = b = 0,25230 nm dan c=0,41223 nm, dan FCC-Co a = b = c = 0,35232 nm. Terbentuknya microalloying CoCr diindikasikan dari hasil EDS, teramati partikel yang mempunyai komposisi Co : Cr = 71,25 : 24,45. Paduan Co-Cr yang terbentuk setelah sintering pada 1300 oC adalah sebesar 15,33416 %berat

Radiation-Hardness Measurements of High OH−OH^{-} Content Quartz Fibres Irradiated with 24 GeV Protons up to 1.25 Grad

We investigated the darkening of two high OH- content quartz fibres irradiated with 24 GeV protons at the Cern PS facility IRRAD. The two tested fibres have a 0.6 mm quartz core diameter, one with hard plastic cladding (qp) and the other with quartz cladding (qq). These fibres were exposed at about 1.25 Gigarad in 3 weeks. The fibres became opaque below 380nm, and in the range 580-650 nm. The darkening under irradiation and damage recovery after irradiation as a function of dose and time are similar to what we observed with electrons. The typical attenuation at 455 nm are 1.44 + - 0.22 and 2.20 + - 0.15 dB/m at 100 Mrad for qp and qq fibres, respectively. The maximum damage recovery is also observed near this wavelength

Multiband tight-binding theory of disordered ABC semiconductor quantum dots: Application to the optical properties of alloyed CdZnSe nanocrystals

Zero-dimensional nanocrystals, as obtained by chemical synthesis, offer a broad range of applications, as their spectrum and thus their excitation gap can be tailored by variation of their size. Additionally, nanocrystals of the type ABC can be realized by alloying of two pure compound semiconductor materials AC and BC, which allows for a continuous tuning of their absorption and emission spectrum with the concentration x. We use the single-particle energies and wave functions calculated from a multiband sp^3 empirical tight-binding model in combination with the configuration interaction scheme to calculate the optical properties of CdZnSe nanocrystals with a spherical shape. In contrast to common mean-field approaches like the virtual crystal approximation (VCA), we treat the disorder on a microscopic level by taking into account a finite number of realizations for each size and concentration. We then compare the results for the optical properties with recent experimental data and calculate the optical bowing coefficient for further sizes

Natural coagulates for wastewater treatment; a review for application and mechanism

The increase of water demand and wastewater generation is among the global concerns in the world. The less effective management of water sources leads to serious consequences, the direct disposal of untreated wastewater is associated with the environmental pollution, elimination of aquatic life and the spread of deadly epidemics. The flocculation process is one of the most important stages in water and wastewater treatment plants, wherein this phase the plankton, colloidal particles, and pollutants are precipitated and removed. Two major types of coagulants are used in the flocculation process included the chemical and natural coagulants. Many studies have been performed to optimize the flocculation process while most of these studies have confirmed the hazardous effects of chemical coagulants utilization on the ecosystem. This chapter reviews a summary of the coagulation/flocculation processes using natural coagulants as well as reviews one of the most effective natural methods of water and wastewater treatment

Symmetry and topology in antiferromagnetic spintronics

Antiferromagnetic spintronics focuses on investigating and using antiferromagnets as active elements in spintronics structures. Last decade advances in relativistic spintronics led to the discovery of the staggered, current-induced field in antiferromagnets. The corresponding N\'{e}el spin-orbit torque allowed for efficient electrical switching of antiferromagnetic moments and, in combination with electrical readout, for the demonstration of experimental antiferromagnetic memory devices. In parallel, the anomalous Hall effect was predicted and subsequently observed in antiferromagnets. A new field of spintronics based on antiferromagnets has emerged. We will focus here on the introduction into the most significant discoveries which shaped the field together with a more recent spin-off focusing on combining antiferromagnetic spintronics with topological effects, such as antiferromagnetic topological semimetals and insulators, and the interplay of antiferromagnetism, topology, and superconductivity in heterostructures.Comment: Book chapte