10,533 research outputs found
Deep into the structure of the first galaxies: SERRA views
We study the formation and evolution of a sample of Lyman Break Galaxies in
the Epoch of Reionization by using high-resolution (),
cosmological zoom-in simulations part of the SERRA suite. In SERRA, we follow
the interstellar medium (ISM) thermo-chemical non-equilibrium evolution, and
perform on-the-fly radiative transfer of the interstellar radiation field
(ISRF). The simulation outputs are post-processed to compute the emission of
far infrared lines ([CII], [NII], and [OIII]). At , the most massive
galaxy, `Freesia', has an age , stellar mass
, and a star formation rate
, due to a recent burst.
Freesia has two stellar components (A and B) separated by ; other 11 galaxies are found within . The
mean ISRF in the Habing band is and is spatially uniform; in
contrast, the ionisation parameter is , and
has a patchy distribution peaked at the location of star-forming sites. The
resulting ionising escape fraction from Freesia is .
While [CII] emission is extended (radius 1.54 kpc), [OIII] is concentrated in
Freesia-A (0.85 kpc), where the ratio . As many high- galaxies, Freesia lies below the local [CII]-SFR
relation. We show that this is the general consequence of a starburst phase
(pushing the galaxy above the Kennicutt-Schmidt relation) which
disrupts/photodissociates the emitting molecular clouds around star-forming
sites. Metallicity has a sub-dominant impact on the amplitude of [CII]-SFR
deviations.Comment: 22 pages, 14 figures, accepted by MNRA
Orbital electron capture by the nucleus
The theory of nuclear electron capture is reviewed in the light of current understanding of weak interactions. Experimental methods and results regarding capture probabilities, capture ratios, and EC/Beta(+) ratios are summarized. Radiative electron capture is discussed, including both theory and experiment. Atomic wave function overlap and electron exchange effects are covered, as are atomic transitions that accompany nuclear electron capture. Tables are provided to assist the reader in determining quantities of interest for specific cases
Predicting Broiler Breeder's Behavior Using Electronic Identification
Rosana G. Moreira, Editor-in-Chief; Texas A&M UniversityThis is a Technical Paper from International Commission of Agricultural Engineering (CIGR, Commission Internationale du Genie Rural) E-Journal Volume 4 (2002): F. Curto, I. Naas, D. Pereira, D. Salagado, M. Murayama and F. Behrens. Predicting Broiler Breeder's Behavior Using Electronic Identification. Vol. IV. December 2002
Numerical and experimental investigations on an extrusion process for a newly developed ultra-high-carbon lightweight steel for the automotive industry
In this study the material flow of a newly developed ultra-high-carbon lightweight steel (uhc-steel) with a high amount of aluminum was investigated in an extrusion process. Cylinder compression tests were performed for material characterization and frictional behaviour was determined by using ring compression tests. Numerical simulations were carried to determine the optimal die geometry as well as to calculate the process loads and dominated stresses in the die occurring during the process. Based on the numerical results, an extrusion process was designed and implemented. Experiments showed that the uhc-steel can be formed by extrusion however it is associated with a high wear rate.BMB
A pulsed, mono-energetic and angular-selective UV photo-electron source for the commissioning of the KATRIN experiment
The KATRIN experiment aims to determine the neutrino mass scale with a
sensitivity of 200 meV/c^2 (90% C.L.) by a precision measurement of the shape
of the tritium -spectrum in the endpoint region. The energy analysis of
the decay electrons is achieved by a MAC-E filter spectrometer. To determine
the transmission properties of the KATRIN main spectrometer, a mono-energetic
and angular-selective electron source has been developed. In preparation for
the second commissioning phase of the main spectrometer, a measurement phase
was carried out at the KATRIN monitor spectrometer where the device was
operated in a MAC-E filter setup for testing. The results of these measurements
are compared with simulations using the particle-tracking software
"Kassiopeia", which was developed in the KATRIN collaboration over recent
years.Comment: 19 pages, 16 figures, submitted to European Physical Journal
Five new species of aeolid nudibranchs (Mollusca, Opisthobranchia) from the tropical eastern Pacific
The ZEUS Forward Plug Calorimeter with Lead-Scintillator Plates and WLS Fiber Readout
A Forward Plug Calorimeter (FPC) for the ZEUS detector at HERA has been built
as a shashlik lead-scintillator calorimeter with wave length shifter fiber
readout. Before installation it was tested and calibrated using the X5 test
beam facility of the SPS accelerator at CERN. Electron, muon and pion beams in
the momentum range of 10 to 100 GeV/c were used. Results of these measurements
are presented as well as a calibration monitoring system based on a Co
source.Comment: 38 pages (Latex); 26 figures (ps
1/m_Q Corrections to the Heavy-to-Light-Vector Transitions in the HQET
Within the HQET, the heavy to light vector meson transitions are
systematically analyzed to the order of 1/m_Q. Besides the four universal
functions at the leading order, there are twenty-two independent universal form
factors at the order of 1/m_Q. Both the semileptonic decay B->\rho which is
relevant to the |V_{ub}| extraction, and the penguin induced decay B -> K^*
which is important to new physics discovering, depend on these form factors.
Phenomenological implications are discussed.Comment: RevTeX, 9 pages, no figure
B-> K photon photon via intermediate eta'
We examine our previous conjecture that the eta' intermediate resonance has
the dominant role in the long distance contributions to B decay into two
photons and a strange final state hadron. We calculate the branching ratio of
the exclusive B-> K eta'-> K photon photon decay using the nonspectator
mechanism for eta' production in charmless hadronic B decays. It is shown that
the obtained branching ratio B^eta'(B-> K\gamma\gamma)~ 8.7 X 10^{-7} is more
than twice as large as the eta_c contribution to this decay mode.Comment: 6 pages, latex, no figure
Catalytic co oxidation and HO direct synthesis over pd and pt-impregnated titania nanotubes
Titania nanotubes (TNTs) impregnated with Pd and Pt nanoparticles are evaluated as heterogeneous catalysts in different conditions in two reactions: catalytic CO oxidation (gas phase, up to 500 °C) and HO direct synthesis (liquid phase, 30 °C). The TNTs are obtained via oxidation of titanium metal and the intermediate layer-type sodium titanate NaTiO. Thereafter, the titanate layers are exfoliated and show self-rolling to TNTs, which, finally, are impregnated with Pd or Pt nanoparticles at room temperature by using Pd(ac) and Pt(ac). The resulting crystalline Pd/TNTs and Pt/TNTs are realized with different lengths (long TNTs: 2.0–2.5 µm, short TNTs: 0.23–0.27 µm) and a specific surface area up to 390 m/g. The deposited Pd and Pt particles are 2–5 nm in diameter. The TNT-derived catalysts show good thermal (up to 500 °C) and chemical stability (in liquid-phase and gas-phase reactions). The catalytic evaluation results in a low CO oxidation light-out temperature of 150 °C for Pt/TNTs (1 wt-%) and promising HO generation with a productivity of 3240 mol kgh (Pd/TNTs, 5 wt-%, 30 °C). Despite their smaller surface area, long TNTs outperform short TNTs with regard to both CO oxidation and HO formation
- …