Graphene oxide-Au nano particle coated quartz crystal microbalance biosensor for the real time analysis of carcinoembryonic antigen

A label-free quartz crystal microbalance (QCM) biosensor was developed for the selective and real-time estimation of carcinoembryonic antigen (CEA) through the present study. Graphene oxide-Au nanoparticles (GO-AuNPs) was in situ synthesised on the surface of the QCM electrode and the antibody of CEA (monoclonal anti-CEA from mouse) was covalently immobilized on this layer as the bioreceptor for CEA. Mercaptoacetic acid–EDC–NHS reaction mechanism was used for anti-CEA immobilization. The effect of oxygen plasma treatment of the QCM electrode surface before bioreceptor preparation on the performance of the biosensor was tested and was found promising. CEA solutions with various concentrations were analysed using the bioreceptors to estimate the sensitivity and detection limit of the biosensor. The biosensors selectively recognized and captured CEA biomolecules with a detection limit of 0.06 and 0.09 ng mL−1 of CEA for oxygen plasma-treated (E2) and untreated (E1) bioreceptors, respectively. The sensitivity was estimated at 102 and 79 Hz, respectively, for E2 and E1. Clinical serum samples were analysed and the results were found in good agreement with the ELISA analysis. Long term stability was also found to be excellent. Langmuir adsorption isotherm was also conducted using the experimental results

A high performance surface acoustic wave visible light sensor using novel materials: Bi2S3 nanobelts

Low dimensional Bi2S3 materials are excellent for use in photodetectors with excellent stability and fast response time. In this work, we developed a visible light sensor with good performance based on surface acoustic wave (SAW) devices using Bi2S3 nanobelts as the sensing materials. The SAW delay-line sensor was fabricated on ST-cut quartz with a designed wavelength of 15.8 microns using conventional photolithography techniques. The measured center frequency was 200.02 MHz. The Bi2S3 nanobelts prepared by a facile hydrothermal process were deposited onto SAW sensors by spin-coating. Under irradiation of 625 nm visible light with a power intensity of 170 μW cm−2, the sensor showed a fast and large response with a frequency upshift of 7 kHz within 1 s. The upshift of the frequency of the SAW device is mainly attributed to the mass loading effect caused by the desorption of oxygen from the Bi2S3 nanobelts under visible light radiation

A high performance surface acoustic wave visible light sensor using novel materials: Bi2S3 nanobelts

Low dimensional Bi2S3 materials are excellent for use in photodetectors with excellent stability and fast response time. In this work, we developed a visible light sensor with good performance based on surface acoustic wave (SAW) devices using Bi2S3 nanobelts as the sensing materials. The SAW delay-line sensor was fabricated on ST-cut quartz with a designed wavelength of 15.8 microns using conventional photolithography techniques. The measured center frequency was 200.02 MHz. The Bi2S3 nanobelts prepared by a facile hydrothermal process were deposited onto SAW sensors by spin-coating. Under irradiation of 625 nm visible light with a power intensity of 170 μW cm−2, the sensor showed a fast and large response with a frequency upshift of 7 kHz within 1 s. The upshift of the frequency of the SAW device is mainly attributed to the mass loading effect caused by the desorption of oxygen from the Bi2S3 nanobelts under visible light radiation

Biofuel trigeneration with energy storage for heating, cooling and power on farms

The drive towards net-zero carbon emissions has prompted many industries to alter the way they operate. The agriculture industry is responsible for a large proportion of the UK’s greenhouse gas emissions. Thus, the feasibility of implementing an anaerobic digestion (AD) system supplying biogas to a trigeneration system with energy storage for the provision of heating, cooling and power has been investigated in the context of a medium-scale arable farm. Two configurations – one supplied with wheat straw only, and the other supplied with wheat straw, barley straw and manure – were identified to meet the energy demands of the farm. Technical feasibility was investigated via simulations run in ECLIPSE, with the two configurations returning overall system efficiencies of 66.8% and 67.1%, respectively. Economic analyses indicated simple payback periods of 9.4 and 11 years, which fall within the expected 20-year lifetime of the project. Furthermore, the potential reduction in CO2 emissions for each scenario was determined to be 42,764 kg and 43,956 kg per year

Expression of apolipoprotein M in human hepatocellular carcinoma tissues

The present study examined mRNA levels and protein mass of apolipoprotein M (apoM) in human hepatocellular carcinoma (HCC) tissues and in the adjacent tissues. Plasma apoM levels in these HCC patients were also determined and compared to the normal subjects. The mean level of plasma apoM in the HCC patients was 0.61 +/- 0.30 OD mm(-2), which was significantly higher than that in the normal subjects 0.37 +/- 0.07 OD mm(-2) (P < 0.01). However, both apoM mRNA levels and apoM protein mass in the HCC tissues were significantly lower than in the adjacent tissues (P < 0.05). It is concluded that human hepatocellular carcinoma tissues had a reduced capacity to produce apoM than the adjacent non-tumor tissues. However, the plasma apoM levels were higher in the HCC patients than in normal subjects, which suggested that tissues adjacent to the tumors or extra-hepatic apoM production in the HCC patients may contribute to the higher plasma apoM levels in these patients. The clinical significance of apoM in relation to HCC still needs further investigation. (C) 2009 Published by Elsevier GmbH

Nebulization using ZnO/Si surface acoustic wave devices with focused interdigitated transducers

Propagation of surface acoustic waves (SAWs) on bulk piezoelectric substrates such as LiNbO3 and quartz, exhibits an in-plane anisotropic effect due to their crystal cut orientations. Thin film SAW devices, such as those based on ZnO or AlN, offer potential advantages, including isotropic wave velocities in all in-plane directions, higher power handling capability, and potentially lower failure rates. This paper reports experimental and simulation results of nebulization behaviour for water droplets using ZnO/Si surface acoustic wave devices with focused interdigital transducers (IDTs). Post-deposition annealing of the films at various temperatures was applied to improve the quality of the sputtering-deposited ZnO films, and 500 °C was found to be the optimal annealing temperature. Thin film ZnO/Si focused SAW devices were fabricated using the IDT designs with arc angles ranging from 30° to 90°. Nebulization was significantly enhanced with increasing the arc angles of the IDTs, e.g., increased nebulization rate, reduced critical powers required to initialise nebulization, and concentration of the nebulised plume into a narrower size of spray. Effects of applied RF power and droplet size have been systematically studied, and increased RF power and reduced droplet size significantly enhanced the nebulization phenomena

A novel quartz-crystal microbalance humidity sensor based on solution-processible indium oxide quantum dots

Large surface area, like quantum confinement effect also caused by particular nano level size of quantum dots (QDs), brings fantastic possibility for humidity sensing. High concentration of surface adsorption site initiate response increasing. Porosity between QDs stacking up fast water vapor penetration and flowing away. Here, a quartz-crystal microbalance (QCM) humidity sensor was prepared using the indium oxide (In2O3) QDs, synthesized via solvothermal method. After In2O3 QDs directly spin-coating onto the QCM, an annealing process taken place to remove organic long chains and expose more moisture adsorption sites on the surface of the QDs. The annealed QCM humidity sensor exhibited high sensitivity (56.3 Hz/%RH at 86.3% RH), with a fast response/recovery time (14 s/16 s). Long carbon chains break down and hydrogen-bonded hydroxyl groups chemisorpted to the QDs. Chemical reaction was reduced by these chemisorpted hydrogen-bonded hydroxyl groups. Mass changing was mostly caused by fast multilayer physiorption. So the transducer can effectively and precisely monitor the moisture of person’s breathing. In2O3 QDs modified QCM sensors demonstrating its promising humidity sensing applications in daily life

Highly stable, love-mode surface acoustic wave biosensor using Au nanoparticle-MoS2-rGO nano-cluster doped polyimide nanocomposite for the selective detection of carcinoembryonic antigen

Herein, presents a novel method for the preparation of a Love mode SAW biosensor for the selective detection of carcinoembryonic antigen (CEA) using a transuding polymer nanocomposite thin film based bioreceptor. Graphene oxide (GO) was synthesized using modified Hummers' method and flower-like MoS2 nanoparticles were allowed to grow on the 2D layers GO. The rGO-MoS2 was further used as a host for the synthesis of Au nanoparticles (AuNP) and the final three-component nano-cluster was introduced to the previously synthesized polyamic acid diethyl ethanolamine salt precursor. The uniform mixture was coated on the delay line area of SAW device and conducted thermal imidization process to obtain polyimide nanocomposite. The thickness of the thin film was optimized based on the insertion loss and centre frequency response of the SAW device. Further, anti-CEA self-assembled monolayer (SAM) based bioreceptor was prepared on the polyimide nanocomposite thin film through thioglycolic acid – EDC/NHS immobilization mechanism. The bioreceptor was tested for immunoassay analysis with CEA solution with varying concentrations. The LOD of the biosensor was estimated at 0.084 ng/ml. The real-time applicability of the biosensor was validated using clinical serum sample analysis and the selectivity was evaluated through the affinity test towards other common tumour marking proteins. The biosensor also showed excellent stability, only 10% reduction activity was observed till 80th day of storage. The antigen-antibody adsorption parameters were also evaluated through Langmuir and Freundlich adsorption isotherms

Evaluation of anti-fatigue property of Porphyridium cruentum in mice

Purpose: To evaluate the potential effects of Porphyridium cruentum (PC) on fatigue induced by forced swimming test in mice. Methods: Mice were randomly divided into normal control group (NC, i.e., untreated non-swimming); model control group (MC, untreated swimming); Spirulina treated group (SP, 800 mg/kg); PC-treated groups (50, 100, and 200 mg/kg), respectively. After intragastric administration for 14 consecutive days, a weight-bearing swimming experiment was conducted for the mice, and the biochemical indicators related to fatigue were examined, including exhaustive swimming time, glucose levels (Glu), hepatic glycogen contents (HG), muscle glycogen contents (MG), glutathione peroxidase activities (GSH-Px), creatine kinase (CK), malondialdehyde (MDA), urea nitrogen levels (SUN), lactate dehydrogenase activities (LDH), lactic acid (LA) as well as superoxide dismutase (SOD). Results: PC significantly prolonged the swimming endurance time compared to MC. After PC treatment, Glu, HG and MG were effectively increased dose-dependently, SUN, LA, LDH and CK levels in serum were significantly reduced. Moreover, PC treatment elevated the bioactivities of two antioxidant enzymes, namely, GSH-Px and SOD, while MDA content decreased when compared to MC group. Conclusion: These results indicate that PC exhibits strong anti-fatigue effect. Thus, PC may be suitable for incorporation in functional food to counter fatigue