Electrodepósito de níquel negro sobre aletas de cobre para aplicaciones en colectores solares planos

CIES2020 - XVII Congresso Ibérico e XIII Congresso Ibero-americano de Energia SolarRESUMEN: En este trabajo se reporta el desempeño de colectores solares construidos con aletas de cobre recubiertas con níquel/níquel negro con y sin SiO2. Los recubrimientos de níquel y níquel negro fueron obtenidos mediante electrodepósito y la capa de SiO2 por sol-gel y roció pirolítico, los resultados se comparan con un colector construido con un recubrimiento selectivo comercial TiNOX. Los resultados muestran que el níquel negro con SiO2 tiene una curva de desempeño cercana al colector construidos con el recubrimiento comercial. El recubrimiento de níquel negro con SiO2 fue obtenido por técnicas de bajo costo lo cual pudiera ser atractivo para las empresas dedicadas a la construcción de colectores solares.ABSTRACT: This work reports the performance of solar collectors built with nickel / black nickel coated copper fins with and without SiO2. The nickel and black nickel coatings were obtained by electrodeposition, the SiO2 layer by sol-gel and spray pyrolysis methods, the results are compared with a collector built with a commercial selective coating TiNOX. The results show that black nickel with SiO2 have a near performance curve than the collector built with the commercial coating. The black nickel coating with SiO2 was obtained by low cost techniques which could be attractive for companies dedicated to the construction of solar collectors.info:eu-repo/semantics/publishedVersio

Performance and operational effectiveness of evacuated flat plate solar collectors compared with conventional thermal, PVT and PV panels

The concept of an evacuated flat plate (EFP) collector was proposed over 40 years ago but, despite its professed advantages, very few manufacturers have developed commercial versions. This situation suggests both technical difficulties in manufacturing a competitively-priced sealed for life panel and a lack of awareness of the bene fits of such panels. This paper demonstrates an evacuated flat plate simulation that closely models experimental efficiency measurements. Having established the validity of the model, it compares published data for a commercial EFP collector with predictions for an optimal design to investigate whether any further efficiency improvement might be possible. The optimised design is then evaluated against alternative solar energy devices by modelling a number of possible applications. These comparisons should inform choices about solar options for delivering heat: EFP collectors are well-suited to some of these applications. Evacuated flat plate collectors are a possible alternative to concentrating collectors for Organic Rankine Cycle power generation. The annual output for all the modelled collectors was found to be a quadratic function of delivery temperature: this enabled a novel optimisation of ORC source temperature. Predictions for concentrating and non-concentrating ORC plant are compared with a PV/thermal alternative. The ORC output is significantly less than a PV panel would achieve; applications needing both heat and power are better served by PVT panels. This is an original and novel result

Photothermal Determination of Infrared Emissivity of Selective Solar Absorbing Coatings

International audienceThe infrared emissivity of glassy carbon, stainless steel, and stainless steel with a selective coating of NiNiO has been determined using a thermal-wave resonant cavity heated with a modulated laser beam. This is achieved performing a length scan of the cavity at a fixed frequency of 5 Hz. It is observed experimentally that (1) the mechanisms of heat conduction and radiation co-exist inside the cavity, through the coupling of the dc and ac components of the temperature, and (2) the radiation effect shows up in both the amplitude and phase signals for cavity thicknesses greater than the diffusion length of the intra-cavity air. Using a suitable theoretical model, the experimental data for the amplitude and phase have allowed the determination of the infrared emissivity of the studied materials