426 research outputs found
Probing thermalization and dynamics of high-energy quasiparticles in a superconducting nanowire by scanning critical current microscopy
Besides its fundamental interest, understanding the dynamics of pair breaking
in superconducting nanostructures is a central issue to optimize the
performances of superconducting devices such as qubits or photon detectors.
However, despite substantial research efforts, these dynamics are still not
well understood as this requires experiments in which quasiparticles are
injected in a controlled fashion. Until now, such experiments have employed
solid-state tunnel junctions with a fixed tunnel barrier. Here we use instead a
cryogenic scanning tunnelling microscope to tune independently the energy and
the rate of quasiparticle injection through, respectively, the bias voltage and
the tunnelling current. For high energy quasiparticles, we observe the
reduction of the critical current of a nanowire and show it is mainly
controlled by the injected power and, marginally, by the injection rate. Our
results prove a thermal mechanism for the reduction of the critical current and
unveil the rapid dynamics of the generated hot spot.Comment: 25 pages, 14 figure
Phonons in the multiferroic langasite BaNbFeSiO : evidences for symmetry breaking
The chiral langasite BaNbFeSiO is a multiferroic
compound. While its magnetic order below T=27 K is now well characterised,
its polar order is still controversial. We thus looked at the phonon spectrum
and its temperature dependence to unravel possible crystal symmetry breaking.
We combined optical measurements (both infrared and Raman spectroscopy) with ab
initio calculations and show that signatures of a polar state are clearly
present in the phonon spectrum even at room temperature. An additional symmetry
lowering occurs below 120~K as seen from emergence of softer phonon modes in
the THz range. These results confirm the multiferroic nature of this langasite
and open new routes to understand the origin of the polar state
Bi-layer Kinetic Inductance Detectors for space observations between 80-120 GHz
We have developed Lumped Element Kinetic Inductance Detectors (LEKID)
sensitive in the frequency band from 80 to 120~GHz. In this work, we take
advantage of the so-called proximity effect to reduce the superconducting gap
of Aluminium, otherwise strongly suppressing the LEKID response for frequencies
smaller than 100~GHz. We have designed, produced and optically tested various
fully multiplexed arrays based on multi-layers combinations of Aluminium (Al)
and Titanium (Ti). Their sensitivities have been measured using a dedicated
closed-circle 100 mK dilution cryostat and a sky simulator allowing to
reproduce realistic observation conditions. The spectral response has been
characterised with a Martin-Puplett interferometer up to THz frequencies, and
with a resolution of 3~GHz. We demonstrate that Ti-Al LEKID can reach an
optical sensitivity of about ~ (best pixel), or
~ when averaged over the whole array. The optical
background was set to roughly 0.4~pW per pixel, typical for future space
observatories in this particular band. The performance is close to a
sensitivity of twice the CMB photon noise limit at 100~GHz which drove the
design of the Planck HFI instrument. This figure remains the baseline for the
next generation of millimetre-wave space satellites.Comment: 7 pages, 9 figures, submitted to A&
Subgap Kinetic Inductance Detector Sensitive to 85-GHz Radiation
We have fabricated an array of subgap kinetic inductance detectors (SKIDs) made of granular aluminum (T∼2 K) sensitive in the 80–90 GHz frequency band and operating at 300 mK. We measure a noise equivalent power of 1.3×10-16W/Hz0.5 on average and 2.6×10W/Hz at best, for an illuminating power of 50 fW per pixel. Even though the circuit design of SKIDs is identical to that of the kinetic inductance detectors, the SKIDs operating principle is based on their sensitivity to subgap excitations. This detection scheme is advantageous because it avoids having to lower the operating temperature proportionally to the lowest detectable frequency. The SKIDs presented here are intrinsically selecting the 80–90 GHz frequency band, well below the superconducting spectral gap of the film, at approximately 180 GHz
LEKID sensitivity for space applications between 80 and 600 GHz
We report the design, fabrication and testing of Lumped Element Kinetic
Inductance Detectors (LEKID) showing performance in line with the requirements
of the next generation space telescopes operating in the spectral range from 80
to 600 GHz. This range is of particular interest for Cosmic Microwave
Background (CMB) studies. For this purpose we have designed and fabricated
100-pixel arrays covering five distinct bands. These wafers have been measured
via multiplexing, where a full array is read out using a single pair of lines.
We adopted a custom cold black-body installed in front of the detectors and
regulated at temperatures between 1 K and 20 K. We will describe in the present
paper the main design considerations, the fabrication processes, the testing
and the data analysis
Anisotropy of the Sommerfeld Coefficient in Magnesium Diboride Single Crystals
International audienceThe anisotropic field dependence of the Sommerfeld coefficient has been measured down to B ! 0 by combining specific heat and Hall probe magnetization measurements in MgB2 single crystals. We find that B; is the sum of two contributions arising from the and band, respectively. We show that B; B=Bc2 where Bc2 Bab c2= si n 2 2cos2 p with 5:4 ( being the angle between the applied field and the c axis) and B; B B=B B . The ''critical field'' of the band B is fully isotropic but field dependent increasing from 0:25 T for B 0:1 T up to 3 T Bcc 2 for B ! 3 T. Because of the coupling of the two bands, superconductivity survives in the band up to 3 T but is totally destroyed above for any orientation of the field
Circuit Quantum Electrodynamics of Granular Aluminum Resonators
The introduction of crystalline defects or dopants can give rise to so-called
"dirty superconductors", characterized by reduced coherence length and
quasiparticle mean free path. In particular, granular superconductors such as
Granular Aluminum (GrAl), consisting of remarkably uniform grains connected by
Josephson contacts have attracted interest since the sixties thanks to their
rich phase diagram and practical advantages, like increased critical
temperature, critical field, and kinetic inductance. Here we report the
measurement and modeling of circuit quantum electrodynamics properties of GrAl
microwave resonators in a wide frequency range, up to the spectral
superconducting gap. Interestingly, we observe self-Kerr coefficients ranging
from Hz to Hz, within an order of magnitude from analytic
calculations based on GrAl microstructure. This amenable nonlinearity, combined
with the relatively high quality factors in the range, open new avenues
for applications in quantum information processing and kinetic inductance
detectors.Comment: 7 pages, 4 figures, supplementary informatio
Superconductor-ferromagnet hybrids for non-reciprocal electronics and detectors
We review the use of hybrid thin films of superconductors and ferromagnets
for creating non-reciprocal electronic components and self-biased detectors of
electromagnetic radiation. We start by introducing the theory behind these
effects, as well as different possible materials that can be used in the
fabrication of these components. We proceed by discussing in detail the
fabrication and characterization of Al/EuS/Cu and EuS/Al/Co based detectors,
along with their noise analysis. We also indicate some routes for multiplexing
such self-biased detectors.Comment: 28 pages, 21 figure
- …