3,154 research outputs found
Characterisation of Medipix3 Silicon Detectors in a Charged-Particle Beam
While designed primarily for X-ray imaging applications, the Medipix3 ASIC
can also be used for charged-particle tracking. In this work, results from a
beam test at the CERN SPS with irradiated and non-irradiated sensors are
presented and shown to be in agreement with simulation, demonstrating the
suitability of the Medipix3 ASIC as a tool for characterising pixel sensors.Comment: 16 pages, 13 figure
Radiation damage in the LHCb vertex locator
The LHCb Vertex Locator (VELO) is a silicon strip detector designed to reconstruct charged particle trajectories and vertices produced at the LHCb interaction region. During the first two years of data collection, the 84 VELO sensors have been exposed to a range of fluences up to a maximum value of approximately 45 × 1012 1 MeV neutron equivalent (1 MeV neq). At the operational sensor temperature of approximately −7 °C, the average rate of sensor current increase is 18 μA per fb−1, in excellent agreement with predictions. The silicon effective bandgap has been determined using current versus temperature scan data after irradiation, with an average value of Eg = 1.16±0.03±0.04 eV obtained. The first observation of n+-on-n sensor type inversion at the LHC has been made, occurring at a fluence of around 15 × 1012 of 1 MeV neq. The only n+-on-p sensors in use at the LHC have also been studied. With an initial fluence of approximately 3 × 1012 1 MeV neq, a decrease in the Effective Depletion Voltage (EDV) of around 25 V is observed. Following this initial decrease, the EDV increases at a comparable rate to the type inverted n+-on-n type sensors, with rates of (1.43±0.16) × 10−12 V/ 1 MeV neq and (1.35±0.25) × 10−12 V/ 1 MeV neq measured for n+-on-p and n+-on-n type sensors, respectively. A reduction in the charge collection efficiency due to an unexpected effect involving the second metal layer readout lines is observed
Observation of narrow baryon resonance decaying into in pA-interactions at with SVD-2 setup
SVD-2 experiment data have been analyzed to search for an exotic baryon
state, the -baryon, in a decay mode at on IHEP
accelerator. The reaction with a limited multiplicity was
used in the analysis. The invariant mass spectrum shows a resonant
structure with and . The statistical significance of this peak was estimated to be of . The mass and width of the resonance is compatible with the recently
reported - baryon with positive strangeness which was predicted as an
exotic pentaquark () baryon state. The total cross section for
production in pN-interactions for was estimated to be
and no essential deviation from A-dependence for inelastic
events was found.Comment: 8 pages, 7 figures, To be submitted to Yadernaya Fizika. v3-v5 - Some
references added, minor typos correcte
Properties of Neutral Charmed Mesons in Proton--Nucleus Interactions at 70 GeV
The results of treatment of data obtained in the SERP-E-184experiment
"Investigation of mechanisms of the production of charmed particles in
proton-nucleus interactions at 70 GeV and their decays" by irradiating the
active target of the SVD-2 facility consisting of carbon, silicon, and lead
plates, are presented. After separating a signal from the two-particle decay of
neutral charmed mesons and estimating the cross section for charm production at
a threshold energy {\sigma}(c\v{c})=7.1 \pm 2.4(stat.) \pm 1.4(syst.)
\mub/nucleon, some properties of D mesons are investigated. These include the
dependence of the cross section on the target mass number (its A dependence);
the behavior of the differential cross sections d{\sigma}/dpt2 and
d{\sigma}/dxF; and the dependence of the parameter {\alpha} on the kinematical
variables xF, pt2, and plab. The experimental results in question are compared
with predictions obtained on the basis of the FRITIOF7.02 code.Comment: 9 pages, 9 figures,3 table
Performance of the LHCb vertex locator
The Vertex Locator (VELO) is a silicon microstrip detector that surrounds the proton-proton interaction region in the LHCb experiment. The performance of the detector during the first years of its physics operation is reviewed. The system is operated in vacuum, uses a bi-phase CO2 cooling system, and the sensors are moved to 7 mm from the LHC beam for physics data taking. The performance and stability of these characteristic features of the detector are described, and details of the material budget are given. The calibration of the timing and the data processing algorithms that are implemented in FPGAs are described. The system performance is fully characterised. The sensors have a signal to noise ratio of approximately 20 and a best hit resolution of 4 μm is achieved at the optimal track angle. The typical detector occupancy for minimum bias events in standard operating conditions in 2011 is around 0.5%, and the detector has less than 1% of faulty strips. The proximity of the detector to the beam means that the inner regions of the n+-on-n sensors have undergone space-charge sign inversion due to radiation damage. The VELO performance parameters that drive the experiment's physics sensitivity are also given. The track finding efficiency of the VELO is typically above 98% and the modules have been aligned to a precision of 1 μm for translations in the plane transverse to the beam. A primary vertex resolution of 13 μm in the transverse plane and 71 μm along the beam axis is achieved for vertices with 25 tracks. An impact parameter resolution of less than 35 μm is achieved for particles with transverse momentum greater than 1 GeV/c
Precision luminosity measurements at LHCb
Measuring cross-sections at the LHC requires the luminosity to be determined accurately at each centre-of-mass energy √s. In this paper results are reported from the luminosity calibrations carried out at the LHC interaction point 8 with the LHCb detector for √s = 2.76, 7 and 8 TeV (proton-proton collisions) and for √sNN = 5 TeV (proton-lead collisions). Both the "van der Meer scan" and "beam-gas imaging" luminosity calibration methods were employed. It is observed that the beam density profile cannot always be described by a function that is factorizable in the two transverse coordinates. The introduction of a two-dimensional description of the beams improves significantly the consistency of the results. For proton-proton interactions at √s = 8 TeV a relative precision of the luminosity calibration of 1.47% is obtained using van der Meer scans and 1.43% using beam-gas imaging, resulting in a combined precision of 1.12%. Applying the calibration to the full data set determines the luminosity with a precision of 1.16%. This represents the most precise luminosity measurement achieved so far at a bunched-beam hadron collider
Search for R-parity Violating Supersymmetry in Dimuon and Four-Jets Channel
We present results of a search for R-parity-violating decay of the neutralino
chi_1^0, taken to be the Lightest Supersymmetric Particle. It is assumed that
this decay proceeds through one of the lepton-number violating couplings
lambda-prime_2jk (j=1,2; k=1,2,3). This search is based on 77.5 pb-1 of data,
collected by the D0 experiment at the Fermilab Tevatron in ppbar collisions at
a center of mass energy of 1.8 TeV in 1992-1995.Comment: 10 pages, 3 figure
Search for right-handed W bosons in top quark decay
We present a measurement of the fraction f+ of right-handed W bosons produced
in top quark decays, based on a candidate sample of events in the
lepton+jets decay mode. These data correspond to an integrated luminosity of
230pb^-1, collected by the DO detector at the Fermilab Tevatron
Collider at sqrt(s)=1.96 TeV. We use a constrained fit to reconstruct the
kinematics of the and decay products, which allows for the
measurement of the leptonic decay angle for each event. By comparing
the distribution from the data with those for the expected
background and signal for various values of f+, we find
f+=0.00+-0.13(stat)+-0.07(syst). This measurement is consistent with the
standard model prediction of f+=3.6x10^-4.Comment: Submitted to Physical Review D Rapid Communications 7 pages, 3
figure
Measurement of Semileptonic Branching Fractions of B Mesons to Narrow D** States
Using the data accumulated in 2002-2004 with the DO detector in
proton-antiproton collisions at the Fermilab Tevatron collider with
centre-of-mass energy 1.96 TeV, the branching fractions of the decays B ->
\bar{D}_1^0(2420) \mu^+ \nu_\mu X and B -> \bar{D}_2^{*0}(2460) \mu^+ \nu_\mu X
and their ratio have been measured: BR(\bar{b}->B) \cdot BR(B-> \bar{D}_1^0
\mu^+ \nu_\mu X) \cdot BR(\bar{D}_1^0 -> D*- pi+) =
(0.087+-0.007(stat)+-0.014(syst))%; BR(\bar{b}->B)\cdot BR(B->D_2^{*0} \mu^+
\nu_\mu X) \cdot BR(\bar{D}_2^{*0} -> D*- \pi^+) =
(0.035+-0.007(stat)+-0.008(syst))%; and (BR(B -> \bar{D}_2^{*0} \mu^+ \nu_\mu
X)BR(D2*0->D*- pi+)) / (BR(B -> \bar{D}_1^{0} \mu^+ \nu_\mu X)\cdot
BR(\bar{D}_1^{0}->D*- \pi^+)) = 0.39+-0.09(stat)+-0.12(syst), where the charge
conjugated states are always implied.Comment: submitted to Phys. Rev. Let
- …