A Continuous Beam Steering Slotted Waveguide Antenna Using Rotating Dielectric Slabs

The design, simulation and measurement of a beam steerable slotted waveguide antenna operating in X band are presented. The proposed beam steerable antenna consists of a standard rectangular waveguide (RWG) section with longitudinal slots in the broad wall. The beam steering in this configuration is achieved by rotating two dielectric slabs inside the waveguide and consequently changing the phase of the slots excitations. In order to confirm the usefulness of this concept, a non-resonant 20-slot waveguide array antenna with an element spacing of d = 0.58{\lambda}0 has been designed, built and measured. A 14 deg beam scanning from near broadside ({\theta} = 4 deg) toward end-fire ({\theta} = 18 deg) direction is observed. The gain varies from 18.33 dB to 19.11 dB which corresponds to the radiation efficiencies between 95% and 79%. The side-lobe level is -14 dB at the design frequency of 9.35 GHz. The simulated co-polarized realized gain closely matches the fabricated prototype patterns

On Algorithms Based on Joint Estimation of Currents and Contrast in Microwave Tomography

This paper deals with improvements to the contrast source inversion method which is widely used in microwave tomography. First, the method is reviewed and weaknesses of both the criterion form and the optimization strategy are underlined. Then, two new algorithms are proposed. Both of them are based on the same criterion, similar but more robust than the one used in contrast source inversion. The first technique keeps the main characteristics of the contrast source inversion optimization scheme but is based on a better exploitation of the conjugate gradient algorithm. The second technique is based on a preconditioned conjugate gradient algorithm and performs simultaneous updates of sets of unknowns that are normally processed sequentially. Both techniques are shown to be more efficient than original contrast source inversion.Comment: 12 pages, 12 figures, 5 table

Experimental characterization of Spherical Bragg Resonators for electromagnetic emission engineering at microwave frequencies

ABSTRACT: This work reports experimental investigation and numerical validation of millimeter-sized Spherical Bragg Resonators (SBRs) fabricated using 3D printing technology. The frequency dependencies of the reflection and transmission coefficients were analyzed, and eigenfrequency values were calculated to examine the density of photonic states in air/PLA-polylactide SBRs, showing the appearance of an eigenmode and an increase in the local density of states in the core of a defect cavity. A decay rate enhancement of ∼10² was obtained for a dipole placed in the core of the defect SBR. The study also investigated the influence of the source position on the resonator's electromagnetic wave energy. Scattering efficiencies up to order twelve of the multipole electric and magnetic contribution in a 10-layer SBR were calculated to validate the presence of the resonant modes observed in the scattering measurements performed for parallel and perpendicular polarizations. The results demonstrate that SBRs can act as omnidirectional cavities to enhance or inhibit spontaneous emission processes by modifying the density of electromagnetic states compared to free space. This finding highlights the potential of SBRs engineering spontaneous electromagnetic emission processes in various applications, including dielectric nanoantennas, optoelectronics devices, and quantum information across the entire electromagnetic spectrum

Three-dimensional scattering from uniaxial objects with a smooth boundary using a multiple infinitesimal dipole method

The formulations for three-dimensional (3D) scattering from uniaxial objects with a smooth boundary using a multiple infinitesimal dipole method (MIDM) are introduced. The proposed technique uses two sets of infinitesimal dipole triplets (IDTs), including three co-located orthogonally polarized electric infinitesimal dipoles, distributed inside and outside of a scatterer to construct simulated fields. The dyadic Green’s functions of uniaxial materials are deployed in the MIDM so as to obtain the simulated fields. The singularity issues in using the uniaxial dyadic Green’s functions, which cannot be solved analytically so far for a general uniaxial medium, can be easily eliminated by using the proposed MIDM. In comparison to the traditional single-layered distribution scheme of IDTs, the proposed multiple-layered distribution scheme can handle the scattering from uniaxial objects accurately and efficiently. Several numerical examples are presented to study bistatic radar cross section (RCS) responses under different scenarios. Excellent agreement is achieved by comparing numerical results with those obtained from commercial software packages, while the simulation performance including CPU time and required memory is drastically improved by using the MIDM when computing a general uniaxial material or a relatively larger object. The proposed technique has its merits on simplicity, conciseness and fast computation in comparison to existing numerical methods

<p>Cognitive functioning enhancement in older adults: is there an advantage of multicomponent training over Nordic walking?</p>

International audienceIntroduction: We compared Nordic walking training (NW) to a multicomponent training (MCT) program of an equivalent intensity, in older adults. Our main hypothesis was that MCT would result in larger effects on cognitive processes than NW. Methods: Thirty-nine healthy older adults, divided into two groups (NW and MCT), took part in the study (17 males, 22 females, mean age =70.8±0.8 years). They were tested for cardiovascular fitness, motor fitness and cognitive performance during the two weeks preceding and following the 12-week training session (3 times/week), respectively. For both the NW and MCT interventions, the training sessions were supervised by a trainer. Heart rate of participants was monitored during the sessions and then used to make training loads as similar as possible between the two groups (TRaining IMPulse method). Results: Results showed that training resulted in better performance for cardiovascular and motor fitness tests. Among these tests, only two revealed a significant difference between the two groups. The NW group progressed more than the MCT group in the 30 Seconds Chair Stand test, while in the One Leg Stance test, the MCT group progressed more. For the cognitive assessment, a significant effect of training was found for executive functions, spatial memory score, and information processing speed response time, with no differences between the two groups. Conclusion: The study confirmed that physical exercise has a positive impact on cognitive processes with no advantage of MCT intervention over NW training. A possible reason is that NW intervention not only improved cardiovascular capacities, but also motor fitness, including coordination capacities

Anti-series varactor network with improved linearity performances in the presence of inductive and capacitive parasitics

ABSTRACT: This paper proposes a varactor-based circuit technique intended for amplitude and phase control, with improved linearity in the presence of parasitic capacitances and parasitic inductances. The mechanism causing linearity degradation in an anti-series varactor network that includes significant parasitic elements - a key aspect that, to our knowledge, has never been reported - is first studied using an analytical approach based on multi-tone excitation. It is demonstrated that simply optimizing the ratio of diode sizes is insufficient to circumvent this linearity degradation. The underlying linearity degradation concept serves as the basis for the introduction of a modified anti-series controllable capacitance, followed by a design and practical implementation. Experimental validations with multi-tone and modulated signals demonstrate improved linearity performances with respect to the state-of-the-art when parasitic capacitances and inductances are significant. Moreover, it is shown that the complete varactor-based circuit topology proposed here, which uses the proposed modified anti-series controllable capacitance in conjunction with a second-harmonic trap filter, constitutes a very attractive alternative to the state-of-the-art anti-series/anti-parallel topology, since it reduces the required number of diodes by a factor of 2. Measurements on discrete-component designs operating at 3.6GHz, hence with significant parasitic effects, demonstrate that the proposed circuit topology improves the 3 rd order intermodulation distortion levels by 10.6dB and 6.6dB at output powers of 10dBm and 18dBm respectively, in comparison with the state-of-the-art topology. Measurements with a 16QAM modulated signal also show 3.9dB improvement in ACPR at 18dBm. These performances constitute improved state-of-the-art results in anti-series hyper-abrupt varactor-based electronic control

Study of microwave tomography measurement setup configurations for breast cancer detection based on breast compression

Microwave tomography (MT) measurement setups for different configurations based on breast compression are compared to classical circular measurement setups. Configurations based on compression allow measuring the evanescent component of the scattered field and lead to a compact measurement setup that allows direct image comparison with a standard mammography system. The different configurations are compared based on the singular value decomposition (SVD) of the radiation operator for a 2D TM case. This analysis allows determining under which conditions the image quality obtained from the reconstructions can be enhanced. These findings are confirmed by a series of reconstructions of breast phantoms based on synthetic data obtained at a single frequency of operation

Reconfigurable Filter Design

This chapter discusses recent development of reconfigurable filters. The technical terminology reconfigurable means that a circuit is designed in a way to have various electrical characteristics comparing with one which has a static feature. For the filter design, the various electrical characteristics can be considered as the filter can tune its operating frequency, bandwidth, and/or have multiple operational modes, that is, bandstop or bandpass modes. Also, recently, the filters that can exhibit an improved impedance matching performance over its stopband have been reported. It provides more options for the filter designers to realize the reconfigurable filters having reflective and/or absorptive frequency response types to satisfy a prior given requirement. In this chapter, recently devised filter designs will be covered and essential frequency tuning elements to realize the reconfigurable characteristic will be introduced as well

Genetic association study of UCMA/GRP and OPTN genes (PDB6 locus) with Paget's disease of bone

We performed a genetic association study of rare variants and single nucleotide polymorphisms (SNPs) of UCMA/GRP and OPTN genes, in French-Canadian patients with Paget's disease of bone (PDB) and in healthy controls from the same population. We reproduced the variant found in the UCMA/GRP basal promoter and tested its functionality using in vitro transient transfection assays. Interestingly, this SNP rs17152980 appears to affect the transcription level of UCMA/GRP. In addition, we have identified five rare genetic variants in UCMA/GRP gene, four of them being population-specific, although none were found to be associated with PDB. Six Tag SNPs of UCMA/GRP gene were associated with PDB, particularly the SNP rs17152980 (uncorrected P = 3.8 x 10(-3)), although not significant after Bonferroni's correction. More importantly, we replicated the strong and statistically significant genetic association of two SNPs of the OPTN gene, the rs1561570 (uncorrected P = 5.7 x 10(-7)) and the rs2095388 (uncorrected P = 4.9 x 10(-3)), With PDB. In addition, we identified a very rare variant found to be located close to the basal promoter of the OPTN gene, at -232 bp from its distal transcription start site. Furthermore, depending on the type of allele present (G or A), the binding of several important nuclear factors such as the vitamin D or the retinoic acid receptors is predicted to be altered at this position, suggesting a significant effect in the regulation of transcription of the OPTN gene. In conclusion, we identified a functional SNP located in the basal promoter of the UCMA/GRP gene which provided a weak genetic association with PDB. In addition, we replicated the strong genetic association of two already known SNPs of the OPTN gene, with PDB in a founder effect population. We also identified a very rare variant in the promoter of OPTN, and through bioinformatic analysis, identified putative transcription factor binding sites likely to affect OPTN gene transcription. (C) 2012 Elsevier Inc. All rights reserved.Fonds de la Recherche du Quebec - Sante (FRQS), Canada; Portuguese Science and Technology Foundation, Portugal [SFRH/BPD/48206/2008]; Catalyst Grant (Bone Health) from the Canadian Institutes of Health Research (Canada); CHUQ Foundation (Canada); Groupe de Recherche en Maladies Osseuses (Canada); Canadian Foundation for Innovation (Canada); FRSQ (Canada); Laval University (Canada); CHUQ (CHUL) Research Centre (Canada); Centre of Marine Sciences (CCMAR) (Portugal)info:eu-repo/semantics/publishedVersio