1,188 research outputs found
The 1996 outburst of GRO J1655-40: disc irradiation and enhanced mass transfer
We show that the 1996 outburst of the X-ray binary transient system GRO
J1655-40 can be explained by the standard dwarf-nova type disc instability,
followed by an episode of enhanced mass transfer from the secondary if the mass
transfer rate in GRO J1655-40 is within a factor < 10 of the stability limit.
We argue that irradiation of the secondary during the onset of the outburst
driven by the thermal instability in the outer disc can increase the mass
transfer rate above the minimum value required for stable accretion. This will
then produce the period of near-constant X-ray emission seen in this system.
This scenario can also explain the observed anti-correlation between the
optical and X-ray fluxes. It is generally accepted that optical emission in
low-mass X-ray binaries is produced by irradiation of the outer disc by X-rays.
There is also strong circumstantial evidence that in order for the outer disc
to see the irradiating flux, it must be warped. Depending on the warp
propagation mechanism, either a burst of mass from the secondary or viscous
decay are likely to decrease the degree of warping, thereby causing the
decrease in the observed optical flux while the X-ray flux remains constant or
even increases, exactly as observed in GRO J1655-40. Finally, the decrease of
the disc warping and, therefore, irradiation will cause the disc to become
unstable once again, terminating the outburst.Comment: Astronomy and Astrophysics - in pres
Mass of a Black Hole Firewall
Quantum entanglement of Hawking radiation has been supposed to give rise to a
Planck density "firewall" near the event horizon of old black holes. We show
that Planck density firewalls are excluded by Einstein's equations for black
holes of mass exceeding the Planck mass. We find an upper limit of
to the surface density of a firewall in a Schwarzschild black hole of mass ,
translating for astrophysical black holes into a firewall density smaller than
Planck density by more than 30 orders of magnitude. A strict upper limit on the
firewall density is given by the Planck density times the ratio .Comment: 6 pages, version published in Phys. Rev. Let
Structural instabilities in strontium titanate from first-principles calculations
For some time now, first-principles calculation methods have proven to be an effective tool for investigating the physics of condensed matter systems. The additional use of density functional theory (DFT) and the local density approximation (LDA) has permitted even complex materials to be studied on desktop workstations with remarkable success. The incorporation of linear response theory into these methods has extended their power, allowing investigation of important dynamical properties.;Contained within the following pages are the results of a first-principles study of SrTiO3. This transition metal oxide is often grouped with ferroelectric materials, due to its similar composition and perovskite structure. Although it behaves as if it were to become ferroelectric, it fails to do so, even at the lowest temperatures.;Using the LAPW method for bulk materials, the ground-state equilibrium properties for the cubic phase were found. Additional linear response calculations produced the phonon frequencies throughout the Brillouin zone. Imaginary values for these frequencies revealed two distinct regions of reciprocal space corresponding to structural instabilities of the ferroelectric (FE) and antiferrodistortive (AFD) types. A cell-doubling AFD transition to tetragonal structure is observed experimentally, so subsequent calculations were continued in this phase. Total energy calculations were performed for both FE and AFD distortions in this new phase, and it was found that the AFD instability is enhanced with decreasing lattice parameter, while the FE instability is diminished. Furthermore, these calculations suggest that this material is marginally stable against FE distortions, even at the 105 K volume
X-ray irradiation in low mass binary systems
We calculate self-consistent models of X-ray irradiated accretion discs in
close binary systems. We show that a point X-ray source powered by accretion
and located in the disc plane cannot modify the disc structure, mainly because
of the self-screening by the disc of its outer regions. Since observations show
that the emission of the outer disc regions in low mass X-ray binaries is
dominated by the reprocessed X-ray flux, accretion discs in these systems must
be either warped or irradiated by a source above the disc plane, or both. We
analyse the thermal-viscous stability of irradiated accretion discs and derive
the stability criteria of such systems. We find that, contrary to the usual
assumptions, the critical accretion rate below which a disc is unstable is
rather uncertain since the correct formula describing irradiation is not well
known.Comment: to be published in MNRAS, uses epsfig.st
The slimming effect of advection on black-hole accretion flows
At super-Eddington rates accretion flows onto black holes have been described
as slim (aspect ratio ) or thick (H/R >1) discs, also known as
tori or (Polish) doughnuts. The relation between the two descriptions has never
been established, but it was commonly believed that at sufficiently high
accretion rates slim discs inflate, becoming thick. We wish to establish under
what conditions slim accretion flows become thick. We use analytical equations,
numerical 1+1 schemes, and numerical radiative MHD codes to describe and
compare various accretion flow models at very high accretion rates.We find that
the dominant effect of advection at high accretion rates precludes slim discs
becoming thick. At super-Eddington rates accretion flows around black holes can
always be considered slim rather than thick.Comment: 8 pages, 5 figures. Astronomy & Astrophysics, in pres
Extracting black-hole rotational energy: The generalized Penrose process
In the case involving particles the necessary and sufficient condition for
the Penrose process to extract energy from a rotating black hole is absorption
of particles with negative energies and angular momenta. No torque at the
black-hole horizon occurs. In this article we consider the case of arbitrary
fields or matter described by an unspecified, general energy-momentum tensor
and show that the necessary and sufficient condition for
extraction of a black hole's rotational energy is analogous to that in the
mechanical Penrose process: absorption of negative energy and negative angular
momentum. We also show that a necessary condition for the Penrose process to
occur is for the Noether current (the conserved energy-momentum density vector)
to be spacelike or past directed (timelike or null) on some part of the
horizon. In the particle case, our general criterion for the occurrence of a
Penrose process reproduces the standard result. In the case of relativistic
jet-producing "magnetically arrested disks" we show that the negative energy
and angular-momentum absorption condition is obeyed when the Blandford-Znajek
mechanism is at work, and hence the high energy extraction efficiency up to
found in recent numerical simulations of such accretion flows
results from tapping the black hole's rotational energy through the Penrose
process. We show how black-hole rotational energy extraction works in this case
by describing the Penrose process in terms of the Noether current.Comment: 24 pages, 14 figures, version published in Phys. Rev.
Stability of radiation-pressure dominated disks. I. The dispersion relation for a delayed heating alpha-viscosity prescription
We derive and investigate the dispersion relation for accretion disks with
retarded or advanced heating. We follow the alpha-prescription but allow for a
time offset (\tau) between heating and pressure perturbations, as well as for a
diminished response of heating to pressure variations. We study in detail
solutions of the dispersion relation for disks with radiation-pressure fraction
1 - \beta . For \tau <0 (delayed heating) the number and sign of real solutions
for the growth rate depend on the values of the time lag and the ratio of
heating response to pressure perturbations, \xi . If the delay is larger than a
critical value (e.g., if \Omega \tau <-125 for \alpha =0.1, \beta =0 and \xi
=1) two real solutions exist, which are both negative. These results imply that
retarded heating may stabilize radiation-pressure dominated accretion disks.Comment: 11 pages, 10 figures, to be submitted to A&
Advection Dominated Accretion Flows Around Kerr Black Holes
We derive all relevant equations needed for constructing a global general
relativistic model of advectively cooled, very hot, optically thin accretion
disks around black holes and present solutions which describe advection
dominated flows in the gravitational field of a Kerr black hole.Comment: ApJ submitte
- …