468 research outputs found
Coulomb fission in multiply charged molecular clusters: experiment and theory
A series of three multiply charged molecular clusters, (C6H6)nz+ (benzene), (CH3CN)nz+ (acetonitrile), and (C4H8O)nz+ (tetrahydrofuran), where the charge z is either 3 or 4, have been studied for the purpose of identifying patterns of behaviour close to the charge instability limit. Experiments show that on a time scale of ~10-4 s, ions close to the limit undergo Coulomb fission where all of the observed pathways exhibit considerable asymmetry in the sizes of the charged fragments, and are associated with kinetic (ejection) energies of between 1.4 and 2.2 eV. Accurate kinetic energies have been determined through a computer simulation of peak profiles recorded in the experiments and the results modelled using a theory formulated to describe how charged particles of dielectric materials interact with one another (Bichoutskaia et al. J. Chem. Phys. 2010, 133, 024105). The calculated electrostatic interaction energy between separating fragments gives an accurate account for the measured kinetic energies and also supports the conclusion that +4 ions fragment into +3 and +1 products as opposed to the alternative of two +2 fragments. This close match between theory and experiment supports the assumption that a significant fraction of excess charge resides on the surfaces of the fragment ions. It is proposed that the high degree of asymmetry seen in the fragmentation patterns of the multiply charged clusters is due, in part, to limits imposed by the time window during which observations are made
Recommended from our members
Electrokinetic removal of uranium from contaminated, unsaturated soils
Electrokinetic remediation of uranium-contaminated soil was studied in a series of laboratory-scale experiments in test cells with identical geometry using quartz sand at approximately 10 percent moisture content. Uranium, when present in the soil system as an anionic complex, could be migrated through unsaturated soil using electrokinetics. The distance that the uranium migrated in the test cell was dependent upon the initial molar ratio of citrate to uranium used. Over 50 percent of the uranium was recovered from the test cells using the citrate and carbonate complexing agents over of period of 15 days. Soil analyses showed that the uranium remaining in the test cells had been mobilized and ultimately would have been extracted. Uranium extraction exceeded 90 percent in an experiment that was operated for 37 days. Over 70 percent of the uranium was removed from a Hanford waste sample over a 55 day operating period. Citrate and carbonate ligand utilization ratios required for removing 50 percent of the uranium from the uranium-contaminated sand systems were approximately 230 moles ligand per mole uranium and 1320 moles ligand per mole uranium for the waste. Modifying the operating conditions to increasing the residence time of the complexants is expected to improved the utilization efficiency of the complexing agent
Model-based Probe State Estimation and Crack Inverse Methods Addressing Eddy Current Probe Variability
Recent work on model-based inverse methods with eddy current inspections of surface breaking discontinuities has shown some sizing error due to variability in probes with the same design specifications [1]. This is an important challenge for model-based inversion crack sizing techniques, to be robust to the varying characteristics of eddy current probes found in the field [1-2]. In this paper, a model-based calibration process is introduced that estimates the state of the probe. First, a carefully designed surrogate model was built using VIC-3D® simulations covering the critical range of probe rotation angles, tilt in two directions, and probe offset (liftoff) for both tangential and longitudinal flaw orientations. Some approximations and numerical compromises in the model were made to represent tilt in two directions and reduce simulation time; however, this surrogate model was found to represent the key trends in the eddy current response for each of the four probe properties in experimental verification studies well. Next, this model was incorporated into an iterative inversion scheme during the calibration process, to estimate the probe state while also addressing the gain/phase fit and centering the calibration notch indication. Results are presented showing several examples of the blind estimation of tilt and rotation angle for known experimental cases with good agreement within +/- 2.5 degrees. The RMS error was found to be significantly reduced by fitting the probe state and, in many instances, probe state estimation addresses the previously un-modelled characteristics (model error) with real probe inversion studies. Additional studies are presented comparing the size of the calibration notch and the quality of the calibration fit, where calibrating with too small or too large a notch can produce poorer inversion results. Once the probe state is estimated, the final step is to transform the base crack inversion surrogate model and apply it for crack characterization. Because of the dimensionality of this problem, simulations were made at a limited set of select flaw sizes with varying length, depth and width, and an interpolation scheme was used to address the effect of the probe state at intermediate solution points. Using this process, results are presented demonstrating improved crack inversion performance for extreme probe states
Recommended from our members
Field Demonstrations of Chemiresistor and Surface Acoustic Wave Microchemical Sensors at the Nevada Test Site
Microclimatological consequences for plant and microbial composition in Sphagnum-dominated peatlands
In three Scandinavian peatlands we studied to what extent plant and microbial community compositions are governed by local-scale microhabitat, with a special interest in the effect of aspect (i.e. exposition of slopes). Despite differences in solar irradiance between the south- and north-facing slopes, maximum temperature was elevated in the south-facing slopes at the most northern site only. Pore-water nutrient concentrations were not affected by aspect, yet dissolved organic carbon concentrations were higher in the south-facing microhabitats. This was likely caused by higher vascular plant biomass. Plant and microbial community composition clearly differed among sites. In all three sites, microhabitat (i.e. prevailing water-table depth) affected the plant and microbial community compositions. Aspect, however, did not affect community composition, even though microclimate significantly differed between the south- and the north-facing aspects at the northernmost site. Our results highlight the complex link between plant community composition, microbial community and environmental conditions, which deserves much more attention than currently in order to fully understand the effects of climate change on peatland ecosystem function.I
Cephalopod genomics: a plan of strategies and organization
The Cephalopod Sequencing Consortium (CephSeq Consortium) was established at a NESCent Catalysis Group Meeting, "Paths to Cephalopod Genomics-Strategies, Choices, Organization," held in Durham, North Carolina, USA on May 24-27, 2012. Twenty-eight participants representing nine countries (Austria, Australia, China, Denmark, France, Italy, Japan, Spain and the USA) met to address the pressing need for genome sequencing of cephalopod mollusks. This group, drawn from cephalopod biologists, neuroscientists, developmental and evolutionary biologists, materials scientists, bioinformaticians and researchers active in sequencing, assembling and annotating genomes, agreed on a set of cephalopod species of particular importance for initial sequencing and developed strategies and an organization (CephSeq Consortium) to promote this sequencing. The conclusions and recommendations of this meeting are described in this white paper
Cephalopod genomics : a plan of strategies and organization
© The Author(s), 2012. This article is distributed under the terms of the Creative Commons Attribution License. The definitive version was published in Standards in Genomic Sciences 7 (2012): 175-188, doi:10.4056/sigs.3136559.The Cephalopod Sequencing Consortium (CephSeq Consortium) was established at a NESCent Catalysis Group Meeting, “Paths to Cephalopod Genomics- Strategies, Choices, Organization,” held in Durham, North Carolina, USA on May 24-27, 2012. Twenty-eight participants representing nine countries (Austria, Australia, China, Denmark, France, Italy, Japan, Spain and the USA) met to address the pressing need for genome sequencing of cephalopod molluscs. This group, drawn from cephalopod biologists, neuroscientists, developmental and evolutionary biologists, materials scientists, bioinformaticians and researchers active in sequencing, assembling and annotating genomes, agreed on a set of cephalopod species of particular importance for initial sequencing and developed strategies and an organization (CephSeq Consortium) to promote this sequencing. The conclusions and recommendations of this meeting are described in this White Paper.The Catalysis Group Meeting was supported by the National Science Foundation through the National Evolutionary Synthesis Center (NESCent) under grant number NSF #EF-0905606
Recommended from our members
Erratum: Sequence data and association statistics from 12,940 type 2 diabetes cases and controls.
This corrects the article DOI: 10.1038/sdata.2017.179
- …