31,719 research outputs found
Mach number and flow-field calibration at the advanced design propeller location on the JetStar airplane
Advanced design propellers on a JetStar aircraft were tested at NASA Ames Research Center's Dryden Flight Research Facility. A calibration of the flow field at the test location to obtain local Mach number and flow direction was performed. A pitot-static probe and flow direction vane installation was installed and tested at Mach 0.3 to 0.8 and altitudes from 3000 m (10,000 ft) to 9100 m (30,000 ft). Local Mach number and flow direction relationships were obtained and related to their noseboom counterparts. Effects of varying angles of sideslip to + or - 3 deg. were investigated
LANDSAT 4 and 5: Emergency
The primary purpose of LANDSAT is to study Earth resources. Each satellite contains a Thematic Mapper (TM) and a Multispectral Scanner (MSS) imaging device plus mission unique hardware. The flight profile is presented, and information is presented in tabular form on the following topics: Deep Space Network support, frequency assignments, telemetry, command, and tracking support responsibility
Structural relaxation in silicate melts and non-Newtonian melt rheology in geologic processes
The timescale of structural relaxation in a silicate melt defines the transition from liquid (relaxed) to glassy (unrelaxed) behavior. Structural relaxation in silicate melts can be described by a relaxation time, , consistent with the observation that the timescales of both volume and shear relaxation are of the same order of magnitude. The onset of significantly unrelaxed behavior occurs 2 log10 units of time above . In the case of shear relaxation, the relaxation time can be quantified using the Maxwell relationship for a viscoelastic material; S = S/G (where S is the shear relaxation time, G is the shear modulus at infinite frequency and S is the zero frequency shear viscosity). The value of G known for SiO2 and several other silicate glasses. The shear modulus, G , and the bulk modulus, K , are similar in magnitude for every glass, with both moduli being relatively insensitive to changes in temperature and composition. In contrast, the shear viscosity of silicate melts ranges over at least ten orders of magnitude, with composition at fixed temperature, and with temperature at fixed composition. Therefore, relative to S, G may be considered a constant (independent of composition and temperature) and the value of S, the relaxation time, may be estimated directly for the large number of silicate melts for which the shear viscosity is known.
For silicate melts, the relaxation times calculated from the Maxwell relationship agree well with available data for the onset of the frequency-dependence (dispersion) of acoustic velocities, the onset of non-Newtonian viscosities, the scan-rate dependence of the calorimetric glass transition, with the timescale of an oxygen diffusive jump and with the Si-O bond exchange frequency obtained from 29Si NMR studies.
Using data obtained over a range of frequencies and strain-rates we illustrate the significance of relaxed versus unrelaxed behavior in laboratory experiments on silicate melts. Similarly, using strain-rate estimates for magmatic processes we evaluate the significance of the liquid-glass transition in igneous petrogenesis.
Dedicated to the memory of Chris Scarf
Non-Newtonian Rheology of Igneous Melts at High Stresses and Strain Rates: Experimental Results for Rhyolite, Andesite, Basalt, and Nephelinite
The stress-strain rate relationships of four silicate melt compositions (high-silica rhyolite, andesite, tholeiitic basalt, and nephelinite) have been studied using the fiber elongation method. Measurements were conducted in a stress range of 10–400 MPa and a strain rate range of 10−6 to 10−3 s−1. The stress-strain rate relationships for all the melts exhibit Newtonian behavior at low strain rates, but non-Newtonian (nonlinear stress-strain rate) behavior at higher strain rates, with strain rate increasing faster than the applied stress. The decrease in calculated shear viscosity with increasing strain rate precedes brittle failure of the fiber as the applied stress approaches the tensile strength of the melt. The decrease in viscosity observed at the high strain rates of the present study ranges from 0.25 to 2.54 log10 Pa s. The shear relaxation times τ of these melts have been estimated from the low strain rate, Newtonian, shear viscosity, using the Maxwell relationship τ = η s /G ∞. Non-Newtonian shear viscosity is observed at strain rates ( ɛ ˙ = time - 1 ) equivalent to time scales that lie 3 log10 units of time above the calculated relaxation time. Brittle failure of the fibers occurs 2 log10 units of time above the relaxation time. This study illustrates that the occurrence of non-Newtonian viscous flow in geological melts can be predicted to within a log10 unit of strain rate. High-silica rhyolite melts involved in ash flow eruptions are expected to undergo a non-Newtonian phase of deformation immediately prior to brittle failure
Isospectral Graph Reductions and Improved Estimates of Matrices' Spectra
Via the process of isospectral graph reduction the adjacency matrix of a
graph can be reduced to a smaller matrix while its spectrum is preserved up to
some known set. It is then possible to estimate the spectrum of the original
matrix by considering Gershgorin-type estimates associated with the reduced
matrix. The main result of this paper is that eigenvalue estimates associated
with Gershgorin, Brauer, Brualdi, and Varga improve as the matrix size is
reduced. Moreover, given that such estimates improve with each successive
reduction, it is also possible to estimate the eigenvalues of a matrix with
increasing accuracy by repeated use of this process.Comment: 32 page
- …