Are Agricultural PACs Monolithic? An Empirical Investigation

This paper analyzes donation strategies of agricultural PACs by examining and testing a variety of variables theoretically related to contributions and formally testing for equivalence of donation strategies across PACs of varying levels of aggregation. Both chambers of the 108th Congress were modeled, with particular attention paid to the targeting of different power or influence sources within the legislature. Results showed significant heterogeneity across PAC subaggregates within a chamber, as well as between chambers, in terms of overall strategy and magnitude of marginal impacts. Evidence supporting the conditional party government hypothesis where PACs target top Party officials rather than influential legislative members was mixed and subindustry specific, with chairmanships apparently less important in the Senate than in the House.Monolithic Behavior, Political Action Committee, Political Donation Strategies, Tobit model, Agricultural and Food Policy,

Solar-Cell Design Based On A Distributed Diode Analysis

The front surface of a p-n junction solar cell has resistive losses associated with the diffused layer, the metal-semiconductor contact, and the grid structure. These losses are analyzed by considering the spatially distributed nature of the p-n junction and the grid conductors. This distributed diode analysis is especially useful for solar cells operated under concentrated sunlight conditions. The results show the dependence of the V-I characteristics and the maximum power output per unit cell on the ratio of the diffused layer resistance to the junction dynamic resistance. This ratio can assist the designer in establishing proper grid structure geometries and should typically be less than 0.1 if the power output per unit cell is to be within 3 percent of that for the lossless case. Experimental measurements are reported which confirm the theoretical calculations. An analysis of the grid conductor losses associated with multiple-connected unit cells shows the disastrous effect that the grid header resistance can have on the performance of a solar cell. The results indicate that the use of a tapered header conductor to decrease the metal coverage may actually worsen cell performance. Copyright © 1978 by The Institute of Electrical and Electronics Engineers, Inc

Investigation of Fundamental Mechanisms of Common-Mode Radiation from Printed Circuit Boards with Attached Cables

Fundamental mechanisms leading to common-mode radiation from printed circuit boards with attached cables have been studied. Two primary mechanisms have been identified, one associated with a differential-mode voltage that results in a common-mode current on an attached cable, and another associated with a differential-mode current that results in a common-mode current on the cable. The two mechanisms are demonstrated through numerical and experimental results

Identifying and Quantifying Printed Circuit Board Inductance

The concepts of inductance and partial inductance play a key role in printed circuit board (PCB) modeling. The inductance of the signal path is an important parameter in high-speed signal integrity calculations. Delta_I noise modeling, crosstalk calculations, and common-mode source identification all rely heavily on accurate estimations of the partial inductance associated with traces, vias, and signal return paths on printed circuit boards. The paper begins by identifying and quantifying the parameters that affect the inductance of typical PCB geometries. Closed-form equations are provided for estimating the partial inductances of simple trace, via, and ground plane configurations. Finally, the issue of current crowding around via connections in planes and its affect on the partial inductance of the plane is addressed

Coherence between subjective experience and physiology in emotion: Individual differences and implications for well-being.

Emotion theorists have characterized emotions as involving coherent responding across various emotion response systems (e.g., covariation of subjective experience and physiology). Greater response system coherence has been theorized to promote well-being, yet very little research has tested this assumption. The current study examined whether individuals with greater coherence between physiology and subjective experience of emotion report greater well-being. We also examined factors that may predict the magnitude of coherence, such as emotion intensity, cognitive reappraisal, and expressive suppression. Participants (N = 63) completed self-report measures of well-being, expressive suppression, and cognitive reappraisal. They then watched a series of emotionally evocative film clips designed to elicit positive and negative emotion. During the films, participants continuously rated their emotional experience using a rating dial, and their autonomic physiological responses were recorded. Time-lagged cross-correlations were used to calculate within-participant coherence between intensity of emotional experience (ranging from neutral to very negative or very positive) and physiology (composite of cardiac interbeat interval, skin conductance, ear pulse transit time, finger pulse transit time and amplitude, systolic and diastolic blood pressure). Results indicated that individuals with greater coherence reported greater well-being. Coherence was highest during the most emotionally intense film and among individuals who reported lower expressive suppression. However, coherence was not associated with reappraisal. These findings provide support for the idea that greater emotion coherence promotes well-being and also shed light on factors that are associated with the magnitude of coherence. (PsycInfo Database Record (c) 2020 APA, all rights reserved)

Estimating DC Power Bus Noise

Simultaneous switching noise (SSN) resulting from IC devices can result in significant power bus noise, as well as radiation problems. An approach for estimating the power bus noise spectrum is presented in this paper. The power bus noise caused by digital circuits injecting high-frequency noise onto the DC buses feeding digital devices is calculated. The transient current drawn by an IC device is modeled using the load current and the shoot-through current through the power dissipation capacitance. Modeling and experimental results for several digital chips are shown. The modeling agrees well with the experimental results

Deposition of CdTe by spray pyrolysis

We report the spray pyrolysis of thin films of CdTe which show promise as a base material for solar cell applications. The films predominately show a zinc blende structure and appear to be intrinsic. Microprobe analysis indicates an excess of cadmium but this is not detectable by X-ray diffraction or from electrical conduction measurements. Measurements indicate a nominal direct bandgap of 1.47 eV and an absorption coefficient of the order of 104 cm−1. The room temperature electrical resistivity is of the order of 107 Ω cm

A Solar-Hydrogen Energy Conversion Scheme for Agricultural Use

A solar energy activated system is presented which can produce hydrogen and hydrogen-derived fuels (methanol) for use on farms. The device, named solar-kine , also can produce fertilizer (anhydrous ammonia) as a byproduct of the hydrogen. A cost analysis shows that solar-kine may be mass-producible and sold to farmers for between $7,200 and$14,700. This is equivalent to giving the fanner energy at a price of $1.79 to$3.66 per million BTU\u27s (in 1974 dollars). Presently (Spring, 1974) regular gasoline used in tractors at 43¢ per gallon, represents a cost to the farmer of $3.77 per million BTU\u27s. As oil-based fuels increase in price in the next few years, solar-kine may represent a reasonable alternative to keep food prices down. The solar-kine system uses concentrated solar energy which can be converted into a high-density electric current by means of a thermionic heat engine. The rejected heat and electric current from the thermionic converter is supplied to an electrolysis cell which, in turn, produces hydrogen and oxygen gas. Chemical process equipment will use the hydrogen and oxygen to produce a methanol (CH3OH) fuel supply for internal combustion engines used on farm machines. The hydrogen can also be used to manufacture ammonia, ammonium nitrate (NH4NO3), and ammonium sulfate [(NH4)2SO4)] fertilizers. The following materials can be produced which are useful to the farmer: a) hydrogen gas, b) oxygen gas, c) liquid tractor fuel, d) fertilizer, e) ammonia, f) electricity, and e) heat energy We feel that any unconventional energy system, such as solar-kine, must interface and serve the conventional use of fuel energy if it is to have lasting merits. This is why we feel that it is desirable to have the complete conversion of solar energy into a liquid fuel that is safe to handle and store, and which also can be used in any conventional fossil-fuel burning system with minimum modifications. Solar energy is compatible with our environment; it is free, and its supply cannot be exhausted. It is also available at any geographic location without requiring transportation to the user\u27s site (See Fig. 2). Its major advantage over fossil fuel comes from the fact that it does not add any net heat content to the earth [5,6]. A small on-site energy system is best for the farmer because, a) It can be mass produced at 106 or more, units per year,b) Power levels needed by farms are low, 100-500 KW, c)Farm energy is used over a large geographical area, d)The main source of energy (the sun) is everywhere available,e) Heat rejected from the heat engine (thermionic) is used in other portions of the system to increase overall efficiency, and may be used in part to heat buildings,f) The farmer would be energy-independent from the price and supply undulations of the industrial complex,g) Legal considerations which regulate the large energy distribution systems would not apply, or affect, the proposed system as used by the farmer,h) Last, and possibly most important, the farmer would have a dependable fuel supply at the lowest possible cost. In the future, the proposed system will supply energy at a cost much lower than petroleum-derived energy

External Parasitic Inductance in Microstrip and Stripline Geometries of Finite Size

An external parasitic ground (return) plane inductance, or a mutual inductance associated with fringing magnetic fields in planar transmission line structures, is the culprit of common-mode voltage (ground plane noise) that leads to parasitic radiation of the corresponding unintentional antennas in high-speed electronic equipment. Mutual inductance of this sort in microstrip and stripline structures is studied here using an analytical quasi- magnetostatic approach and FDTD modeling. Closed-form expressions for mutual inductance in symmetrical and asymmetrical microstrip and stripline structures are presented