Stock Market Interdependence and Trade Relations: A Correlation Test for the U.S. and Its Trading Partners

Based on the well-established trade relations between the U.S. and its major trading partners, this paper examines the robustness of the trade relation hypothesis which, in some recent studies, argues that difference in trade relations among countries can significantly explain difference in the stock market interdependence. The generalized VDC analysis is employed to measure the stock market interdependence, and the correlation test with bootstrap procedure is applied to test the hypothesis. The results indicate that the hypothesis is hardly as a general rule.

Preservation of Bovine Hide using Less Salt with Low Concentration of Antiseptic

Content: A Conventional technique of bovine hide preservation requires approximately 40-50% sodium chloride or table salt on raw hide weight or 95% saturated brine in case of wet salting. This salt resides in wastewater after the soaking process and generates a huge environmental pollution in the form of total dissolved solids (TDS) and chloride (Cl-) during leather processing. The current research has developed an antiseptic based hide curing formulation using 45% saturated brine solution which reduces 50% salt usage in compare to the traditional method. For hide preservation, it is essential to arrest microbial attack on hide as the main constituent of raw hide is protein which is very susceptible for bacterial degradation. The newly developed formulations have been found more effective in limiting microbial growth on cured hide than the conventional method preserving the bovine hide for more than 30 days. In-process analysis of cured hides during storage period reveals the compatibility of the alternative curing process. Post-leather analysis e.g. grain pattern, scanning electron microscopic images, mechanical properties and organoleptic evaluation reveal that the crust leather produced from alternatively cured hides are comparable to the control obtained from traditionally preserved hide. The efficacy of the alternative system is also assessed by monitoring the environmental impacts caused by the leather processing effluents on the basis of TDS and chloride content, total solids (TS), total aerobic bacterial counts in soaking liquor, Bio-Chemical oxygen demand (BOD) and Chemical oxygen demand (COD). The environmental advantages of the alternative hide curing method are determined particularly by 50% reduction of TDS and chloride content. Therefore, this new development will not only preserve hide through better protection from microorganisms but also offer improved conservation of the environment. Take-Away: Environmentally friendly technique of animal hide preservation Hide preservation through better protection from microbial degradatoin than the traditional techniqu

Scaffolding Contigs Using Multiple Reference Genomes

Scaffolding is an important step of the genome assembly and its function is to order and orient the contigs in the assembly of a draft genome into larger scaffolds. Several single reference-based scaffolders have currently been proposed. However, a single reference genome may not be sufficient alone for a scaffolder to correctly scaffold a target draft genome, especially when the target genome and the reference genome have distant evolutionary relationship or some rearrangements. This motivates researchers to develop the so-called multiple reference-based scaffolders that can utilize multiple reference genomes, which may provide different but complementary types of scaffolding information, to scaffold the target draft genome. In this chapter, we will review some of the state-of-the-art multiple reference-based scaffolders, such as Ragout, MeDuSa and Multi-CAR, and give a complete introduction to Multi-CSAR, an improved extension of Multi-CAR

Dynamic response of a polymer-stabilized blue-phase liquid crystal

Fast response time is the most attractive feature of polymer-stabilized blue phase liquid crystals (PS-BPLCs). We have investigated the dynamic response of a PS-BPLC under various electric fields and found that the response time becomes slower as the applied electric field exceeds a critical field. Further analyses of experimental data reveal that two relaxation processes are involved. Possible mechanism is proposed to explain the behavior of each process. These results provide useful guidelines for achieving fast response time without hysteresis

Comparison of navigation systems for total knee arthroplasty: A systematic review and meta-analysis

BackgroundComponent alignment is a crucial factor affecting the clinical outcome of total knee arthroplasty (TKA). Accelerometer-based navigation (ABN) systems were developed to improve the accuracy of alignment during surgery. This study aimed to compare differences in component alignment, clinical outcomes, and surgical duration when using conventional instrumentation (CONI), ABN, and computer navigation (CN) systems.MethodsA comprehensive literature search was carried out using the Web of Science, Embase, PubMed, and Cochrane databases. Articles that met the eligibility criteria were included in the study. Meta-analyses were performed using the Cochrane Collaboration Review Manager based on Cochrane Review Method. The variables used for the analyses were postoperative clinical outcome (PCO), surgical duration, and component alignment, including the hip-knee-ankle (HKA) angle, coronal femoral angle (CFA), coronal tibial angle (CTA), sagittal femoral angle (SFA), sagittal tibial angle (STA), and the outliers for the mentioned angles. The mean difference (MD) was calculated to determine the difference between the surgical techniques for continuous variables and the odds ratio (OR) was used for the dichotomous outcomes.ResultsThe meta-analysis of the CONI and ABN system included 18 studies involving 2,070 TKA procedures, while the comparison of the ABN and CN systems included 5 studies involving 478 TKA procedures. The results showed that the ABN system provided more accurate component alignment for HKA, CFA, CTA, and SFA and produced fewer outliers for HKA, CFA, CTA, and STA. However, while the ABN system also required a significantly longer surgical time than the CONI approach, there was no statistical difference in PCO for the two systems. For the ABN and CN systems, there was no statistical difference in all variables except for the ABN system having a significantly shorter surgical duration.ConclusionThere was no significant difference in the accuracy of component alignment between the ABN and CN systems, but the ABN approach had a shorter surgical duration and at lower cost. The ABN system also significantly improved the accuracy of component alignment when compared to the CONI approach, although the surgery was longer. However, there was no significant difference in PCO between the CONI, ABN, and CN systems

Mutations in the PKM2 exon-10 region are associated with reduced allostery and increased nuclear translocation.

PKM2 is a key metabolic enzyme central to glucose metabolism and energy expenditure. Multiple stimuli regulate PKM2's activity through allosteric modulation and post-translational modifications. Furthermore, PKM2 can partner with KDM8, an oncogenic demethylase and enter the nucleus to serve as a HIF1α co-activator. Yet, the mechanistic basis of the exon-10 region in allosteric regulation and nuclear translocation remains unclear. Here, we determined the crystal structures and kinetic coupling constants of exon-10 tumor-related mutants (H391Y and R399E), showing altered structural plasticity and reduced allostery. Immunoprecipitation analysis revealed increased interaction with KDM8 for H391Y, R399E, and G415R. We also found a higher degree of HIF1α-mediated transactivation activity, particularly in the presence of KDM8. Furthermore, overexpression of PKM2 mutants significantly elevated cell growth and migration. Together, PKM2 exon-10 mutations lead to structure-allostery alterations and increased nuclear functions mediated by KDM8 in breast cancer cells. Targeting the PKM2-KDM8 complex may provide a potential therapeutic intervention

Light-Independent Inactivation of Dengue-2 Virus by Carboxyfullerene C3 Isomer

AbstractCarboxyfullerene (C60) is known as a photosensitizer for virus inactivation. Its regioisomer with C3 symmetry, named the C3 isomer, could also inactivate the dengue-2 virus without light when the dose of C3 isomer was increased to 40 μM, indicating the possible involvement of a light-independent mechanism. Further analysis showed that the C3 isomer blocked viral replication at the attachment and penetration stages, suggesting that a direct interaction between the C3 isomer and the virion is required for inactivation. The C3 isomer with a bipolar structure showed better lipid interaction and dengue-2 virus suppression than D3, another isomer that contains evenly distributed hydrophilic side chains. Moreover, the C3 isomer selectively inactivated enveloped viruses (viz., dengue-2 virus and Japanese encephalitis virus) instead of nonenveloped viruses (viz., enterovirus 71 and coxsackievirus B3). Collectively, these findings support the hypothesis that C3 isomer suppression of enveloped viruses is effected through its hydrophobic interaction with the viral lipid envelope. Our report, which demonstrates the light-dependent and -independent mechanisms of C60 on viral inactivation, will aid in the development of novel anti-viral agents for use against enveloped viruses

3510-V 390-m Omega . cm(2) 4H-SiC Lateral JFET on a Semi-Insulating Substrate

The performance of high-voltage 4H-SiC lateral JFETs on a semi-insulating substrate is reported in this letter. The design of the voltage-supporting layers is based on the charge compensation of p- and n-type epilayers. The best measured breakdown voltage is 3510 V, which, to the authors\u27 knowledge, is the highest value ever reported for SiC lateral switching devices. The R-on of this device is 390 m Omega . cm(2), in which 61% is due to the drift-region resistance. The BV2/R-on is 32 MW/cm(2), which is typical among other reported SiC lateral devices

A microsecond-response polymer-stabilized blue phase liquid crystal

A polymer-stabilized blue-phase liquid crystal (BPLC) with microsecond response time is demonstrated using a vertical field switching cell. The measured decay time is 39 mu s at room temperature (21 degrees C) and then decreases to 9.6 mu s at 44.3 degrees C. Such a response time is 1-2 orders of magnitude faster than that of a typical BPLC device. The responsible physical mechanisms are the collective effects of short pitch length, strong polymer network, and low viscosity through temperature effect. The on-state voltage of our BPLC device is 44.2 V, hysteresis is below 0.7%, and contrast ratio is over 1300:1