758 research outputs found
Non equilibrium anisotropic excitons in atomically thin ReS
We present a systematic investigation of the electronic properties of bulk
and few layer ReS van der Waals crystals using low temperature optical
spectroscopy. Weak photoluminescence emission is observed from two
non-degenerate band edge excitonic transitions separated by 20 meV. The
comparable emission intensity of both excitonic transitions is incompatible
with a fully thermalized (Boltzmann) distribution of excitons, indicating the
hot nature of the emission. While DFT calculations predict bilayer ReS to
have a direct fundamental band gap, our optical data suggests that the
fundamental gap is indirect in all cases
Effect of Coulomb impurities on the electronic structure of magic angle twisted bilayer graphene
In graphene, charged defects break the electron-hole symmetry and can even
give rise to exotic collapse states when the defect charge exceeds a critical
value which is proportional to the Fermi velocity. In this work, we investigate
the electronic properties of twisted bilayer graphene (tBLG) with charged
defects using tight-binding calculations. Like monolayer graphene, tBLG
exhibits linear bands near the Fermi level but with a dramatically reduced
Fermi velocity near the magic angle (approximately 1.1{\deg}). This suggests
that the critical value of the defect charge in magic-angle tBLG should also be
very small. We find that charged defects give rise to significant changes in
the low-energy electronic structure of tBLG. Depending on the defect position
in the moir\'e unit cell, it is possible to open a band gap or to induce an
additional flattening of the low-energy valence and conduction bands. Our
calculations suggest that the collapse states of the two monolayers hybridize
in the twisted bilayer. However, their in-plane localization remains largely
unaffected by the presence of the additional twisted layer because of the
different length scales of the moir\'e lattice and the monolayer collapse state
wavefunctions. These predictions can be tested in scanning tunnelling
spectroscopy experiments
Atmospheric concentrations of carbon dioxide and its isotopic composition in southern Poland: comparison of high-altitude mountain site and a near-by urban environment
International audienceThe results of regular observations of atmospheric CO2 mixing ratios and its carbon isotope composition (?13C, ?14C), carried out at two continental sites located in central Europe are presented and discussed. The sites (Kasprowy Wierch, 49°14' N, 19°59' E, 1989 m a.s.l.; Krakow, 50°04' N, 19°55' E, 220 m a.s.l.), are located in two contrasting environments: (i) high-altitude mountaneous area, relatively free of anthropogenic influences, and (ii) typical urban environment with numerous local sources of carbon dioxide. Despite of relative proximity of those sites (ca. 100 km), substantial differences in both the recorded CO2 levels and their isotopic composition were detected. The CO2 mixing ratios measured in the urban atmosphere revealed quasi-permanent excess concentration of this gas when compared with near-by background atmosphere. The annual mean CO2 concentration recorded in Krakow in 2004 was almost 10% higher than that recorded at high-altitude mountain site (Kasprowy Wierch). Such effect is occuring probably in all urban centers. Carbon isotopic composition of atmospheric CO2 proved to be efficient tool for identification the surface CO2 fluxes into the atmosphere related to fossil fuel burning and their influence on the recorded levels of this gas in the local atmosphere. The available records of ?14C for Krakow and Kasprowy Wierch suggest gradual reduction of 14C-free CO2 fluxes into the urban atmosphere of Krakow in the past several years
Proximity Effect in Crystalline Framework Materials: Stacking‐Induced Functionality in MOFs and COFs
Metal–organic frameworks (MOFs) and covalent organic frameworks (COFs) consist of molecular building blocks being stitched together by strong bonds. They are well known for their porosity, large surface area, and related properties. The electronic properties of most MOFs and COFs are the superposition of those of their constituting building blocks. If crystalline, however, solid‐state phenomena can be observed, such as electrical conductivity, substantial dispersion of electronic bands, broadened absorption bands, formation of excimer states, mobile charge carriers, and indirect band gaps. These effects emerge often by the proximity effect caused by van der Waals interactions between stacked aromatic building blocks. Herein, it is shown how functionality is imposed by this proximity effect, that is, by stacking aromatic molecules in such a way that extraordinary properties emerge in MOFs and COFs. After discussing the proximity effect in graphene‐related materials, its importance for layered COFs and MOFs is shown. For MOFs with well‐defined structure, the stacks of aromatic building blocks can be controlled via varying MOF topology, lattice constant, and by attaching steric control units. Finally, an overview of theoretical methods to predict and analyze these effects is given, before the layer‐by‐layer growth technique for well‐ordered surface‐mounted MOFs is summarized
Electrical control of orbital and vibrational interlayer coupling in bi- and trilayer 2H−MoS2
Non equilibrium anisotropic excitons in atomically thin ReS2
We present a systematic investigation of the electronic properties of bulk and few layer ReS2 van der Waals crystals using low temperature optical spectroscopy. Weak photoluminescence emission is observed from two non-degenerate band edge excitonic transitions separated by similar to 20 meV. The comparable emission intensity of both excitonic transitions is incompatible with a fully thermalized (Boltzmann) distribution of excitons, indicating the hot nature of the emission. While DFT calculations predict bilayer ReS2 to have a direct fundamental band gap, our optical data suggests that the fundamental gap is indirect in all cases
Effects of Alcohol and Saccharin Deprivations on Concurrent Ethanol and Saccharin Operant Self-Administration by Alcohol-Preferring (P) Rats
Consumption of sweet solutions has been associated with a reduction in withdrawal symptoms and
alcohol craving in humans. The objective of the present study was to determine the effects of
EtOH and saccharin (SACC) deprivations on operant oral self-administration. P rats were allowed
to lever press concurrently self-administer EtOH (15% v/v) and SACC (0.0125% g/v) for 8 weeks.
Rats were then maintained on daily operant access (non-deprived), deprived of both fluids (2
weeks), deprived of SACC and given 2 ml of EtOH daily, or deprived of EtOH and given 2 ml of
SACC daily. All groups were then given two weeks of daily operant access to EtOH and SACC,
followed by an identical second deprivation period. P rats responded more for EtOH than SACC.
All deprived groups increased responding on the EtOH lever, but not on the SACC lever. Daily
consumption of 2 ml EtOH decreased the duration of the ADE. Home cage access to 2 ml SACC
also decreased the ADE but to a lesser extent than access to EtOH. A second deprivation period
further increased and prolonged the expression of an ADE. These results show EtOH is a more
salient reinforcer than SACC. With concurrent access to EtOH and SACC, P rats do not display a
saccharin deprivation effect. Depriving P rats of both EtOH and SACC had the most pronounced
effect on the magnitude and duration of the ADE, suggesting that there may be some interactions
between EtOH and SACC in their CNS reinforcing effects
The operational window of carbon nanotube electrical wires treated with strong acids and oxidants
Conventional metal wires suffer from a significant degradation or complete failure in their electrical performance, when subjected to harsh oxidizing environments, however wires constructed from Carbon Nanotubes (CNTs) have been found to actually improve in their electrical performance when subjected to these environments. These opposing reactions may provide new and interesting applications for CNT wires. Yet, before attempting to move to any real-world harsh environment applications, for the CNT wires, it is essential that this area of their operation be thoroughly examined. To investigate this, CNT wires were treated with multiple combinations of the strongest acids and halogens. The wires were then subjected to conductivity measurements, current carrying capacity tests, as well as Raman, microscopy and thermogravimetric analysis to enable the identification of both the limits of oxidative conductivity boosting and the onset of physical damage to the wires. These experiments have led to two main conclusions. Firstly, that CNT wires may operate effectively in harsh oxidizing environments where metal wires would easily fail and secondly, that the highest conductivity increase of the CNT wires can be achieved through a process of annealing, acetone and HCl purification followed by either H2O2 and HClO4 or Br2 treatment
Intelligent Web Facility To Enhance Yield,Resilience And Sustainability Ukrainian And USA Farms
This paper proposes to implement a computational model and intelligent software for farms, that give the farmer a set of robust and viable options for crop, soil, and water management, enhance crop resiliency to climate change, the effects of pests, plant diseases and other environmental factors. Model and intelligent software for farms includes the following tasks: search, analysis and storage in a dedicated base of relevant data gleaned from the Internet, the interaction with the farmer through a dedicated interface, the development of the farmer’s solution by database and integrated knowledge base for plant protection
- …